Genie WIPX8VDVAF5 Manual de usuario

Quick Start Guide

Please read these instructions carefully before operating the unit

and keep for further reference.

8MP H.265 IP IR Vandal Dome

with 3.3-12mm Auto Focus

Lens and Facial Recognition

WIPX8VDVAF5

Intro Section

Please read this instruction carefully before operating the product and keep it for further

reference. All examples and pictures used here are for reference only.

The contents of this manual are subject to change without notice.

CAUTION:

• If the product does not work properly, please contact your dealer or the nearest service

centre. Never attempt to disassemble the camera yourself. We shall not be responsible

for any problems caused by unauthorised repair or maintenance.

• Do not allow water or liquid into the camera while in use.

• When using the product, you must be in strict compliance with the electrical safety

regulations of the nation and region.

• When the product is mounted on wall or ceiling, the device needs to be ﬁrmly ﬁxed.

• Make sure the power supply voltage is correct before using the camera.

• Do not drop the camera or subject it to any physical shock.

• If cleaning, please use a clean soft cloth with a little neutral detergent to wipe it gently.

• Do not aim the camera at the sun or in any area where there is bright lighting.

• The device may be burned out by a laser beam, so when any laser equipment is in use,

make sure that the surface of the device will not be exposed to the laser beam.

• Do not place the camera in extremely hot, cold , dusty or damp locations, and do not

expose it to high electromagnetic radiation.

• To avoid heat accumulation, good ventilation is required for operating environment.

Contents

iii

1.0 Introduction..........................................................................................................4

1.1 Product Features...........................................................................................4

1.2 Product Dimensions.....................................................................................4

1.3 Contents ......................................................................................................4

1.4 Speciﬁcation ................................................................................................5

2.0 Overview..............................................................................................................7

3.0 Installation............................................................................................................9

3.1 Installing the Camera ...................................................................................9

3.2 Installing the Camera with a Junction Box..................................................10

4.0 Network Connection ...........................................................................................11

5.0 Camera Maintenance...........................................................................................12

The Genie WIPX8VDVAF5 is an 8MP IP IR vandal dome camera with a 3.3–12mm auto focus

lens. The camera features facial recognition when paired with any Genie AI NVR.

1.1 Product Features

• 8MP (3840 × 2160) H.265 full real time coding

• Maximum resolution: 3840 × 2160, ICR auto switch, true day / night

• 20 ~ 30m IR night view distance

• Motorised zoom lens

• Micro SD card slot, up to 128GB

• 3D DNR, true WDR, HLC, BLC, Smart IR and ROI coding

• 1CH CVBS output, 1CH audio input, 1CH audio output

• RS485, Hardware reset, 1CH alarm input, 1CH alarm output

• DC12V/PoE power supply

• Supports smart phone, iPad, remote monitoring

• IP66 & IK10 ingress protection

• Supports three streams

• Supports face detection

1.2 Product Dimensions

1.3 Contents

1.0 Introduction

Camera Quick Start Guide 4 Tapping Screws PA 4×25

CD Drill Template Plastic Plug x4

Rubber Plug L-Wrench CVBS & DC In Cables

150.4mm

114.2mm

Quick Start Guide 8MP H.265 IP IR Vandal Dome with 3.3-12mm Auto Focus Lens and Facial Recognition

1.4 Speciﬁcation

Camera

Image Sensor 1 / 2.5” CMOS

Image Size 3840 × 2160

Electronic Shutter 1 / 25 s ~ 1 / 100000 s

Iris Type Fixed Iris

Minimum Illumination 0.024 Lux @ F1.2, AGC ON, 0 Lux with IR

0.068 Lux @ F2.0, AGC ON, 0 Lux with IR

Lens 3.3~12mm @ F1.4

Lens Mount Φ14

Field of View Horizontal ﬁeld of view : 97.5° ~ 38.5°

Day & Night ICR

Wide Dynamic Range 120dB

BLC Yes

HLC Yes

Defog Yes

Digital NR 3D DNR

Angle Adjustment Pan: 0°~360°, Tilt: 0°~77°, Rotation: 0°~360°

Image

Video Compression H.265+ / H.265 / H.264+ / H.264 / MJPEG

H.264 Compression

Standard Baseline Proﬁle / Main Proﬁle / High Proﬁle

Resolution 8MP (3840 × 2160), 2K (2560 × 1440), 3MP (2304 × 1296),

1080p (1920 × 1080), 720p (1280 × 720), D1, CIF, 480 × 240

Main Stream 60Hz : 8MP 2K/3MP/ 1080p / 720p (1~30fps)

50Hz : 8MP/ 2K/3MP/ 1080p/ 720p (1~25fps)

Sub Stream 60Hz : 1080p (1~5fps) / 720P (1~10fps) / D1 (1~30fps)

50Hz: 1080p (1~25fps) / 720P (1~25fps) /D1 (1~25fps)

Third Stream 60Hz : 720p / D1/ CIF / 480 × 240 (1~30fps)

50Hz: 720p / D1 / CIF / 480 × 240 (1~25fps)

Bit Rate 128 Kbps ~ 12 Mbps

Bit Rate Type VBR / CBR

Audio Compression G711A / U

Image Settings

ROI, Saturation, Brightness, Chroma, Contrast, Wide Dynamic,

Sharpen, NR,etc. Adjustable through client software or web

browser

ROI Each ROI to be conﬁgured separately

Interface

Network RJ45

Video Output CVBS Output (BNC x 1), Built-in CVBS output x 1

Audio Audio input x 1, audio output x 1

Alarm Alarm input x 1, alarm output x 1

Storage Built-in micro SD card slot, up to 128GB

Hardware Reset Yes

Quick Start Guide 8MP H.265 IP IR Vandal Dome with 3.3-12mm Auto Focus Lens and Facial Recognition

Functions

Remote Monitoring Web browsing, CMS remote control

Online Connection Supports simultaneous monitoring for up to 10 users. Supports

multi-stream real time transmission

Network Protocol UDP, IPv4, IPv6, DHCP, NTP, RTSP, PPPoE, DDNS, SMTP, FTP,

SNMP, HTTP, 802.1x, UPnP, HTTPs, QoS

Interface Protocol Onvif compatible

Face recognition and face capture

Storage Network remote storage, Micro SD card storage

Smart Alarm Motion detection, Sensor detection, SD card error, SD card

full, IP conﬂict, cable disconnection

General Function Watermark, IP address ﬁltering, video mask, heartbeat,

password protection, image distortion correction, etc.

PoE Yes

IR Distance 20~30m

Others

Ingress Protection IP67 & IK10

Power Supply DC12V / PoE

Power Consumption < 7W

Operating Environment - 30 °C ~ 60 °C (-22 °F~140°F)

Humidity: Less than 95 % (Non-Condensing)

Dimensions 150.4 × 114.2 mm

Weight Approx. 1.03 Kg

1. Ethernet Connector

2. Audio Input (MIC)

3. Audio Output (HP)

4. CVBS Video Output

5. Alarm Input/Output

6. DC12V Power Connector

7. A: Zoom- (only available for type A),

B: Focus

8. A : Zoom+ (only available for type A),

B: Zoom

9. Micro SD Card Slot

10. Reset

11. DC in & CVBS Interface

2.0 Overview

Security Cap

Type A : Motorised Zoom Camera

Type B : Manual Zoom Camera

DC12V

Alarm Input: Join the grounding ends of the sensor and the camera and then connect

the signal cable of the sensor to the alarm input port of the camera.

Alarm Output: Loosen the screws in the alarm output port. Then insert the signal wires

of the alarm output devices into the port of COM and OPEN separately. Finally tighten

the screws. Some of the external alarm output devices need the power supply.

• If the PoE switch is used to power the camera, DC12V power supply is not required.

• It is recommended to install the security cap for outdoor installation.

Quick Start Guide 8MP H.265 IP IR Vandal Dome with 3.3-12mm Auto Focus Lens and Facial Recognition

1. Loosen the nut from the main element.

2. Run the network cable (without RJ 45 connector) through both elements. Then crimp

the cable with RJ 45 connector.

3. Connect the cable to the hermetic connector. Then tighten the nut and the main

cover.

Connecting Network Cable

3.1 Installing the Camera

Please make sure that the wall or ceiling is strong enough to withstand 3 times the weight

of the camera. Please install the camera in and under a dry environment and place the

cover of the camera within 4 hours of removing it. Do not remove the protection ﬁlm until

ﬁnishing the installation.

1. Rotate the trim ring anti-clockwise to remove it from the camera.

2. Attach the drill template to the place where you want to ﬁx the camera and then drill

4 screw holes and 1 cable hole (if you want to route the cables through the ceiling)

according to the drill template.

3. Loosen the screws to open the lower dome.

4. Route and connect these cables. Then secure the camera to the ceiling or wall with the

screws provided.

5. Three-axis adjustment. Before adjustment, preview the image of the camera on a

monitor and then adjust the camera according to the ﬁgure below to get an optimum

angle.

3.0 Installation

Trim Ring

Lower Dome

Rubber Plug

Install it when routing the

cables through the ceiling.

Pan 0–345°

Tilt 0–77°

Rotation 0–345°

Hold it and rotate

Quick Start Guide 8MP H.265 IP IR Vandal Dome with 3.3-12mm Auto Focus Lens and Facial Recognition

6. Insert a micro SD card. After that, adjust Zoom or Focus to obtain an optimum image.

Before adjustment, view the image of the camera on a monitor. For Type A, press the T

or W button. For Type B, (a) push the IR light hood to the position, (b) remove the lens

cover, (c) adjust the Zoom and Focus, (d) install back the lens cover and move the IR

light hood back.

7. Install the lower dome back to the camera and ﬁx it with screws. Then put the trim ring

onto the lower dome and then rotate it clockwise until it is locked. Finally, remove the

protection ﬁlm softly.

3.2 Installing the Camera with a Junction Box

1. Fix the junction box to the wall with screws.

2. Rotate the trim ring anticlockwise to remove it from the camera and then loosen the

screws to open the lower dome.

3. Route and connect these cables (take side conduit cabling for example). Then fasten

the camera to the junction box with screws.

4. Insert a micro SD card. Then

adjust the view of angle and the

image.

5. Install the lower dome back to the camera and ﬁx it with screws. Then put the trim ring

onto the lower dome and then rotate it clockwise until it is locked. Finally, remove the

protection ﬁlm softly.

Lens Cover

Focus

Monitor

Zoom

Zoom-

Zoom+ IR Light Hood

Insert a Micro

SD card

Type A : Motorised Zoom Camera Type B : Manual Zoom Camera

Tabla de contenidos

Otros manuales de Cámara de seguridad de Genie

Genie

Genie WIPX4FD Manual de usuario

Genie

Genie WAHD2LBV Manual de usuario

Genie

Genie PWIP4BVAF Manual de usuario

Genie

Genie TPH-4000P Manual de usuario

Genie

Genie WIP1VD Manual de usuario

Genie

Genie DSF120PX Manual de usuario

Genie

Genie SSAHD2BVAF Manual de usuario

Genie

Genie PWIPN2EB Manual de usuario

Genie

Genie ZD2812IR Manual de usuario

Genie

Genie WIP2PTZ25P Manual de usuario

Genie

Genie GB83TSPXIR Manual

Genie

Genie HDI221 Manual de usuario

Genie

Genie GSDNR-6358 Manual

Genie

Genie WIP2BVLG Manual de usuario

Genie

Genie ZD2812IR Manual de usuario

Genie

Genie PWIP4EBVAF Manual de usuario

Genie

Genie SSAHD2VDAF Manual de usuario

Genie

Genie ZD49IR Manual de usuario

Genie

Genie SSAHD2B Manual de usuario

Genie

Genie WIPX4BVAF Manual de usuario

Genie

Genie DN83SPX/12 Manual

Genie

Genie SSIP2B Manual de usuario

Genie

Genie WIPX4BVAF722 Manual de usuario

Genie

Genie WIPX2LBVLPR Manual de usuario

Manuales populares de Cámara de seguridad de otras marcas

Okina USA

Okina USA SIR36-870VF650LP Manual de usuario

Divio

Divio NDR155PA Manual de usuario

Canon

Canon VB-C500D Manual de usuario

Easy Access

Easy Access EasyGuard Manual de usuario

Vivotek

Vivotek FD9389-EHV-v2 Manual de usuario

TUYA

TUYA COSMO W2 Manual de usuario

Eusso

Eusso UNC7500-IR Guía de configuración

urmet domus

urmet domus 1096/204 Manual de usuario

VC VC20 series Manual de usuario

Axis

Axis Q1614 Manual de usuario

ieGeek

ieGeek DD201 Manual de usuario

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manual de usuario

Vicon

Vicon V662-D-1 Instrucciones de funcionamiento

Grundig

Grundig GCH-K0274P Manual de usuario

Lorex

Lorex VANTAGE LBC7032 Manual de usuario

4xem

4xem WPT Manual de usuario

Samsung

Samsung SCV-3082 Manual de usuario

Vitek

Vitek VTC-C544 Manual de usuario