GABOR MD-BSL15W Manual de usuario

MD-BSL15W /SPRING-LOADED

TWIN-ARM

MONITOR MOuNT

For 15″–27″(38.1–68.6 cm) LCD desktop computer

User Manual

2 Welcome

The Gabor MD-BSL15W mounts two 15″–27″ (38.1–68.6 cm) LCD computer monitors side

by side. It attaches to the edge of your desk via a built-in clamp, freeing up valuable desk

space and enabling personalized monitor placement for improved safety and comfort over

conventional monitor stands. The MD-BSL15W’s arms incorporate an internal mechanical

spring system, which is safer than the gas springs found in similar products. These spring-

loaded arms function as a counterbalance to support your monitors in any position. Multiple

points of articulation provide a full range of motion, making it easy to adjust your monitors’

height, tilt, swivel, and roll.

Thank you for

choosing Gabor.

3Welcome

4 Overview

Overview Mounting Arm (x2)

M4x12 (x8) M4x30 (x8)

M6x25 (x2)

13X5.5X16.5 (x8)

(x1)

S=3mm (x1)

S=5mm

(x2)

(x1)

M4x12 (x8) M4x30 (x8)

M6x25 (x2)

13X5.5X16.5 (x8)

(x1)

S=3mm (x1)

S=5mm

(x2)

(x1)

Tools Required For

Installation

• Phillips screwdriver

VESA mount

Locking

collar

Support bracket

Set screw

Shaft

Mounting

socket

Cable guides

Clamp

Clamp screws

Clamp locking

knob

Mounting

pegs

Shaft cap

5Overview

M4 M6 Hex Keys Spacers/

Cable clip Protective Caps

Ax8 Cx2

Bx8

Dx1

Ex1

Gx1

Hx2

Ix1

Fx8

M4x12 (x8) M4x30 (x8)

M6x25 (x2)

13X5.5X16.5 (x8)

(x1)

S=3mm (x1)

S=5mm

(x2)

(x1)

M4x12 (x8) M4x30 (x8)

M6x25 (x2)

13X5.5X16.5 (x8)

(x1)

S=3mm (x1)

S=5mm

(x2)

(x1)

M4x12 (x8) M4x30 (x8)

M6x25 (x2)

13X5.5X16.5 (x8)

(x1)

S=3mm (x1)

S=5mm

(x2)

(x1)

M4x12 (x8) M4x30 (x8)

M6x25 (x2)

13X5.5X16.5 (x8)

(x1)

S=3mm (x1)

S=5mm

(x2)

(x1)

M4x12 (x8) M4x30 (x8)

M6x25 (x2)

13X5.5X16.5 (x8)

(x1)

S=3mm (x1)

S=5mm

(x2)

(x1)

M4x12 (x8) M4x30 (x8)

M6x25 (x2)

13X5.5X16.5 (x8)

(x1)

S=3mm (x1)

S=5mm

(x2)

(x1)

A(8) M4×12 screws

B(8) M4×30 screws

C(2) M6×25 screws

D3 mm hex key

E5 mm hex key

F(8) Spacers

GCable clip

H(2) Protective caps

IShaft cap

JUser manual

Supplied Parts & Hardware

Also Included

(Installed in shaft)

Max. 28.7” (73 cm)

90°

85°

180°

360°

0-13.8” (0-35 cm)

12.2” (31c m)

90°

85°

180°

360° 180° 180°

+/-45°

M6x25

S=5mm

Product Speciﬁcations

• Monitor display size:

15″—27″(38.1–68.6 cm)

• Maximum load capacity (per arm):

17 lb. (7.8 kg)

• VESA standards: 75×75, 100 × 100

• Tilt: -90°/+85°

• Swivel: 180°

• Roll: 360°

• Installation: Clamp ﬁts desk edges up to

2.6″(6.5 cm) thick

• Arm width (extended): 28.7″(73 cm)

• Arm pivot: 180°

• Arm height adjustment

Angle: ±45°

Range: 0″–13.8″(0–35 cm)

• Shaft height: 12.2″(31 cm)

• Weight: 8.25 lb. (3.7 kg)

Speciﬁcations

Safety Warnings

Please read and follow these instructions

and keep this manual in a safe place.

Clean this product with only a soft, dry cloth.

Keep this product away from children.

Make sure everything is secure before

proceeding.

Make sure that this product is intact and

that there are no missing parts.

To avoid damage to this product, be careful

not to overtighten or improperly thread any

of the threaded ﬁttings.

Do not exceed the maximum load capacity.

Do not install this product on an unsteady

structure or one that is prone to vibration,

has a chance of being impacted, or is

susceptible to other movements. Reinforce

the structure as necessary before installing

this product.

Mounting surfaces should be sturdy and ﬂat.

Do not install this product on a weak, uneven

surface.

All photos are for illustrative purposes only.

Safety Warnings

Getting Started

Decide where you want to

place your monitors. When

using a dual-monitor setup

like this one, position your

primary monitor directly

in front of you, and your

secondary monitor to the

side. You shouldn’t need to

turn your head to look at

your primary monitor. Both

monitors should be at eye

level, approximately at an

arm’s length away. If you

have to strain to look at

either monitor, readjust

its position.

Available separately are two dedicated accessories for this

mounting system, the MWD-E8W extension arm and the

MW-C wall mount. The MWD-E8W extension arm adds 10″

(25.4 cm) of length and an additional point of articulation to

provide greater freedom for positioning your monitor. The

MW-C wall mount offers an alternative mounting option for

your MD-BSL15W dual-monitor setup.

Getting Started

MWD-E8W

MW-C

9Installation Instructions

Attaching the Shaft

• The MD-BSL15W easily

attaches to most desk

edges up to 2.6″(6.5 cm)

thick, even if your desk

is nearly ﬂush against a

wall. Before attaching

the shaft to your desk,

determine whether

you have enough room

to ﬁt the entire clamp

behind your desk. If you

have enough clearance

to attach the clamp

without removing the

bottom part of it, skip to

Clearance on this page.

• If your desk is close to

a wall or you don’t have

enough clearance to ﬁt

the entire clamp behind

your desk, you can

remove the bottom part

of the clamp. If this is

the case, skip to Limited

Clearance on page 10.

Clearance

1. Loosen the clamp locking

knob until you can ﬁt the

clamp over the edge of

your desk.

2. Fit the clamp over the

edge of your desk, and

tighten the clamp locking

knob until the shaft is

securely mounted to

your desk.

• Continue with Adjusting

the Support Bracket on

page 11.

Limited Clearance

1. Use the included 5 mm

hex key to remove the

clamp screws.

2. Fit the top part of the

clamp behind your desk.

3. Underneath your desk,

align the screw holes in

the top and bottom parts

of the clamp.

Note: It may help to unscrew

the clamp locking knob ﬁrst.

4. Reinsert the clamp

screws and use the

included 5 mm hex key

to fasten them until fully

tightened.

5. Tighten the clamp locking

knob until the shaft is

securely mounted to your

desk.

• Continue with Adjusting

the Support Bracket on

page 11 .

Installation Instructions

M4x12

Tabla de contenidos

Otros manuales de Rack y soporte de GABOR

GABOR

GABOR CP-6 Manual de usuario

GABOR

GABOR FSM-M Manual de usuario

GABOR

GABOR LTS-20 Manual de usuario

GABOR

GABOR LeviTouch DM-500 Manual de usuario

GABOR

GABOR Mainmast DMS-200 Manual de usuario

GABOR

GABOR LTS-30 Manual de usuario

GABOR

GABOR FSM-S Manual de usuario

GABOR

GABOR FM-2742 Manual de usuario

GABOR

GABOR DMS-202 Manual de usuario

GABOR

GABOR MD-ASL15W Manual de usuario

GABOR

GABOR Levitouch DM-550 Manual de usuario

GABOR

GABOR ACCUGEAR UPMP-1000 Manual de usuario

GABOR

GABOR TM-1732 Manual de usuario

GABOR

GABOR FM-4265 Manual de usuario

GABOR

GABOR FSM-L Manual de usuario

GABOR

GABOR Levitouch DM-552 Manual de usuario

GABOR

GABOR TM-SS Manual de usuario

Manuales populares de Rack y soporte de otras marcas

Salamander

Salamander Acadia AC/W/L400/WH Manual de usuario

Fohhn

Fohhn VAT-09 Guía del usuario

ricoo

ricoo FS0522 Manual de usuario

AMSOIL

AMSOIL BMK-22 Guía rápida

Kargo Master

Kargo Master 48220 Manual de usuario

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manual de usuario

ricoo

ricoo S1222 Manual de usuario

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manual de usuario

VidaBox

VidaBox VB MNT FFS2 Manual de usuario

Welch Allyn

Welch Allyn 48960 Manual de usuario

Arkon

Arkon CM035-ST-2 Manual de usuario

PROEL

PROEL PLWIN60C Manual de usuario

Agilent Technologies

Agilent Technologies E2609B Manual de usuario

Mustang

Mustang MV-ARM4 Manual de usuario

Mounting Solutions

Mounting Solutions WRM-320 Manual de usuario

Pyle

Pyle PMKSPAD1 Manual de usuario

ShelterIt

ShelterIt 21208 Manual de usuario

SPL

SPL RackPack?4 1040 Manual de usuario