Emerson Rosemount 5400 Series Manual de usuario

Quick Start Guide

00825-0600-4026, Rev AA

March 2016

Rosemount™5400 Level Transmitter

Mounting Instructions for Parabolic Antenna

March 2016

Quick Start Guide

1.0 About this guide

This Quick Start Guide provides mechanical installation instructions for the

Rosemount 5402 Level Transmitter with parabolic antenna.

For information about electrical installation and configuration, refer to the

Rosemount 5400 Series Quick Start Guide (document number

00825-0100-4026).

Failure to follow safe installation and service guidelines could result in death or serious injury.

Make sure the transmitter is installed by qualified personnel and in accordance with applicable code of

practice.

Use the equipment only as specified in this Quick Start Guide and the Reference Manual. Failure to do so

may impair the protection provided by the equipment.

Any substitution of non-authorized parts or repair, other than exchanging the complete transmitter head

or antenna assembly, may jeopardize safety and is prohibited.

Explosions could result in death or serious injury.

Verify that the operating environment of the transmitter is consistent with the appropriate hazardous

locations specifications.

To prevent ignition of flammable or combustible atmospheres, disconnect power before servicing.

Before connecting a Field Communicator in an explosive atmosphere, make sure the instruments in the

loop are installed in accordance with intrinsically safe or non-incendive field wiring practices.

To avoid process leaks, only use O-rings designed to seal with the corresponding flange adapter.

Do not remove the transmitter while in operation.

Electrical shock can result in death or serious injury.

Avoid contact with the leads and terminals. High voltage that may be present on leads can cause electrical

shock.

Make sure the main power to the Rosemount 5400 Level Transmitter is off and the lines to any other

external power source are disconnected or not powered while wiring the transmitter.

Ground device on non-metallic tanks (e.g. fiberglass tanks) to prevent electrostatic charge build-up.

Contents

Parabolic antenna overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3

Mount the flanged version . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 4

Mount the welded version . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 6

Mount the threaded version . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 13

Adjust inclination of antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 19

Quick Start Guide

March 2016

2.0 Parabolic antenna overview

Flanged version

Welded version

Threaded version

page 4-5

page 6-12

page 13-18

March 2016

Quick Start Guide

3.0 Mount the flanged version

Step 1: Mount antenna assembly on tank

Step 2: Adjust inclination of antenna

Refer to section “Adjust inclination of antenna” on page 19 for further

information.

Gasket

Quick Start Guide

March 2016

Step 3: Tighten blind plug or install air purging system

Proceed with electrical installation. For further instructions, see the Rosemount

5400 Series Quick Start Guide (document number 00825-0100-4026).

G3/8"

Air purging?No Yes

0.3-0.4 in. (8-10 mm)

(gasket excluded)

Torque 180 in-lb (20 Nm) Use thread sealant or

gasket according to

your site procedures.

March 2016

Quick Start Guide

4.0 Mount the welded version

Figure 1. Components

Weld protection plate

Weld protection bar

Flange ball

O-ring

Clamp flange

Washer

M8 screw

Antenna

Ball joint

Threaded sleeve

M20 adapter

G3/8" bonded seal

Blind plug

2x 1x 1x

1x 1x 1x

3x 3x

Quick Start Guide

March 2016

Step 1: Mount protection plates to flange/manhole cover

These plates protects the internal surfaces of the flange ball from welding sparks.

Ø 3.94 ± 0.02 in.

(Ø 100 ± 0.5 mm)

Max. 1.18 in. (30 mm)

March 2016

Quick Start Guide

Step 2: Weld flange ball

Step 3: Remove protection plates

Visually inspect the internal surfaces of the flange ball for damage and dirt.

Step 4: Mount O-ring

Quick Start Guide

March 2016

Step 5: Mount ball joint

Gradually tighten the M8 nuts.

Step 6: Remove protection cap

Visually inspect the O-rings for damage and dirt.

Torque 90 in-lb (10 Nm)

O-rings

March 2016

Quick Start Guide

Step 7: Carefully insert antenna

Step 8: Secure antenna

Torque 180 in-lb (20 Nm)

Otros manuales para Rosemount 5400 Series

Tabla de contenidos

Otros manuales de Transmisor de Emerson

Emerson

Emerson Rosemount 3100 Series Manual de usuario

Emerson

Emerson Rosemount 3051S ERS Manual de usuario

Emerson

Emerson Rosemount 1056 Manual de usuario

Emerson

Emerson Rosemount 3051S Series Guía de configuración

Emerson

Emerson Rosemount ET210 Manual de usuario

Emerson

Emerson Rosemount 2051 Wireless Series Manual de usuario

Emerson

Emerson Rosemount 3144P Manual de usuario

Emerson

Emerson Rosemount CX1100 Manual de usuario

Emerson

Emerson Rosemount 3144P Manual de usuario

Emerson

Emerson Rosemount 4088B MultiVariable Manual de usuario

Emerson

Emerson Rosemount MultiVariable 3051SMV Manual de usuario

Emerson

Emerson Rosemount 848T Manual de usuario

Emerson

Emerson Rosemount 3051 Manual de usuario

Emerson

Emerson MicroMotion FOUNDATION 5700 Manual de usuario

Emerson

Emerson Rosemount 8712EM Manual de usuario

Emerson

Emerson Rosemount 644h Manual de usuario

Emerson

Emerson Rosemount 644 HART Manual de usuario

Emerson

Emerson Micro Motion 3700 Manual de usuario

Emerson

Emerson Fisher 4200 Series Manual de usuario

Emerson

Emerson Rosemount 1208A Manual de usuario

Emerson

Emerson Rosemount 644h Manual de usuario

Emerson

Emerson Rosemount 1208C Manual de usuario

Emerson

Emerson Rosemount 848T Manual de usuario

Emerson

Emerson Rosemount 3144P Manual de usuario

Manuales populares de Transmisor de otras marcas

NIVELCO

NIVELCO EasyTREK SCA-300 Series Manual del propietario

Honeywell

Honeywell 5816WMBR Manual de usuario

Kamstrup

Kamstrup READy MTU Instrucciones de funcionamiento

Omega

Omega ZW Series Manual de usuario

ABB

ABB Field 264H Guía

Alinco

Alinco DJ-V17T Manual de usuario

Dejero

Dejero EnGo 3x Manual de usuario

Rosemount

Rosemount 4600 Manual de usuario

Speaka Professional

Speaka Professional 2342740 Manual de usuario

trubomat

trubomat GAB 1000 Manual de usuario

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Manual de usuario

Rondish

Rondish UT-11 Manual de usuario

MG 10JRE Manual de usuario

Burkert

Burkert 8177 Manual de usuario

Firetide

Firetide HotPort 3203 Manual

Tele Radio

Tele Radio T9-02 Manual de usuario

Rotronic

Rotronic HygroFlex HF3 Series Manual de usuario

Jamara

Jamara FCX6 Pro Tel Manual de usuario