Dormakaba STV 1 Series Manual de usuario

WN 059507 45532 – 2019-03

STV1xx

Mounting instructions

1 About this manual

1.1 Target group

The door lock STV 1xx must only be mounted by

trained electricians with specific knowledge of

electromechanical locks, fire safety codes and

regulations.

1.2 Intended use

The STV1xx serves to keep doors securely closed, and

to open it without jamming and without delay in case

of emergency. The STV1xx is used in the SafeRoute®

system.

1.3 Other applicable documents:

• System instructions for the used SafeRoute® license

• Operating instructions for the SafeRoute® system

• Inspection logbook

1.4 Symbols used

ATTENTION

This signal word indicates a situation of

potential risk, which could lead to damage

to property or the environment if not

averted.

TIPS AND RECOMMENDATIONS

This signal word indicates useful information

for efficient and trouble-free operation.

1.5 Further labeling

1. 2. Sequence of action steps

6Reference to a chapter

Reference to another document

Door opening direction DIN left =

opening outwards to the right

Door opening direction DIN right =

opening outwards to the left

Components may be damaged by

electrostatic discharges

2 Safety

ATTENTION

Property damage by electrostatic discharge.

The control board may be damaged by an

electrostatic discharge!

• The user must ground his/her own body

before touching a component!

Contents

1 About this manual 1

2 Safety 1

3 Product description 2

4 Mounting 2

5 Assignment of terminals and switches 5

6 Dismantling and disposal 5

3 Product description

The STV 1xx is an electromagnetic lock for swing

doors on escape routes and is mounted on the door

frame. Together with a SafeRoute® Control Unit

(SCU), the door lock forms an escape route security

system. The STV 1xx opens without jamming and

without delay. The maximum locking force complies

with Directive for Electrical Locking Systems on

Escape Route Doors (EltVTR).

They may only be mounted on fire and smoke

protection doors, if the usability certificates for these

doors provide for the mounting, and if the related

requirements are followed. Additional notes can also

be found in the notification “Permitted changes and

supplements to fire protection closures” of the

Deutsches Institut für Bautechnik (DIBt), Berlin.

3.1 Variants

The XX markings are color variants. The instructions

are valid for the STV 101 (silver) and STV 111 (white).

3.2 LED displays

LED on LED off LED flashes

DCW®LED (red)

Bus connection OK

Bus connection interrupted

DCW® error (see SafeRoute®

system instructions)

Config LED (yellow)

Configuration successful

Device not configured

Both LEDs

Configuration mode active

3.3 Technical data

Supply voltage: 24VDC +/-15%

Retention force 2000 N bei Unenn +/- 10 %

Power consumption: locked: 280mA

unlocked: 20mA

Temperature range: -10°Cto+55°C

Rel. Humidity: up to 93%

(non condensing)

Degree of protection: IP 30

4 Mounting

TIPS AND RECOMMENDATIONS

The mounting is only shown on a door which

opens outwards to the left (DIN right).

• Proceed in mirror-inverted order when

mounting a DIN left door.

2STV1xx 2019-03

WN 059507 45532

dormakaba Mounting instructions Product description

DIN left =

opening

outwards

to the right

DIN right =

opening

outwards

to the left

3STV1xx 2019-03WN 059507 45532

dormakaba Mounting instructions Product description

Drilling template

2. 3.

4STV1xx 2019-03

WN 059507 45532

dormakaba Mounting instructions Product description

2,9x25

d=2,2 mm

mm 1 x 3 mm / 2 x 1 mm

44 1 x 1 mm

45 2 x 1 mm

46 1 x 3 mm

47 1 x 1 mm / 1 x 3 mm

48 2 x 1 mm / 1 x 3 mm 2 x

5STV1xx 2019-03WN 059507 45532

dormakaba Mounting instructions Assignment of terminals and switches

5 Assignment of

terminals and

switches

Config LED

(yellow)

DCW®-LED

(red)

24VDC

GND

DCW®-Bus SCU-xx

X2 internal holder contact

X3 internal function

X4 internal door contact

S1 Housing tampering contact

S2 DIP switch for setting the component

addresses (see SafeRoute® system

instructions)

DCW®

address

Switch S2

S3 Service switch for suppression of

tampering alarm

B = Operation (housing tampering

contact activated)

S = service (Housing tampering contact

shut off)

S4 Service button

Press service button for 8 seconds =

original settings

6 Dismantling and

disposal

Dismantling is carried out in reverse order of the

mounting instructions.

The product must not be disposed of in

domestic waste.

The product must be disposed of in an

environmentally friendly manner at the

arranged take-back and collection points.

Refer to the statutory regulations for your country.

Electrostatically

sensitive

components

6STV1xx 2019-03

WN 059507 45532

dormakaba Mounting instructions Assignment of terminals and switches

7STV1xx 2019-03WN 059507 45532

dormakaba Mounting instructions Assignment of terminals and switches

dormakaba Deutschland GmbH

DORMA Platz 1 58256 Ennepetal Germany T: +49 2333 793-0 F: +49 2333 793-4950 www.dormakaba.com

Translation of the original manual, subject to change without notice

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cerrar de Dormakaba

Dormakaba

Dormakaba RCI 3513-DM Manual de usuario

Dormakaba

Dormakaba BEST Wi-Q 45HQ Manual de usuario

Dormakaba

Dormakaba SVI Series Manual de usuario

Dormakaba

Dormakaba SVA 6000 Manual de capacitación

Dormakaba

Dormakaba LA GARD 700 Series Manual de usuario

Dormakaba

Dormakaba STV 2 Series Manual de usuario

Dormakaba

Dormakaba GL10 Manual de usuario

Dormakaba

Dormakaba ORACODE 480 Series Manual de usuario

Dormakaba

Dormakaba M Series Manual de usuario

Dormakaba

Dormakaba SVI 5000 Manual de capacitación

Dormakaba

Dormakaba LA GARD ComboGard Pro 39E Manual

Dormakaba

Dormakaba YD30S Manual

Dormakaba

Dormakaba Confidant RFID Kit 2 Manual de usuario

Dormakaba

Dormakaba GL220 Manual de usuario

Dormakaba

Dormakaba ORACODE 660i Manual de usuario

Dormakaba

Dormakaba digital cylinder Manual de usuario

Dormakaba

Dormakaba 5715 Instrucciones de funcionamiento y mantenimiento

Dormakaba

Dormakaba YD30D Manual

Dormakaba

Dormakaba LA GARD 700 Series Manual de usuario

Dormakaba

Dormakaba RCI DE8310 Manual de usuario

Dormakaba

Dormakaba Cobalt Single Manual de usuario

Dormakaba

Dormakaba 2725-K6 Manual de usuario

Dormakaba

Dormakaba Axessor Series Manual de usuario

Dormakaba

Dormakaba T900 Manual de usuario

Manuales populares de Cerrar de otras marcas

Magic

Magic 105 Manual de usuario

Gantner

Gantner GAT NET.Lock 7020 System Guía rápida

Wittkopp

Wittkopp Insys 7202 Manual de usuario

Dorma

Dorma Studio Classic Manual de usuario

Securam

Securam ECSL-601 Manual de usuario

Sudhaus

Sudhaus 3003 Manual de usuario

Safety 1st

Safety 1st 48517 Manual de usuario

Pado

Pado FDS-10 Manual de usuario

Esco

Esco systeQ Series Manual de usuario

COMPX

COMPX National D8951 Manual de usuario

secureo

secureo Key Box Manual de usuario

Stock Loks

Stock Loks C8713 Manual de usuario

COMPX

COMPX 1T-058 Manual del propietario

Auslock

Auslock T11 Manual de usuario

ELCOM

ELCOM 7205 Manual de usuario

Stealth SAFES

Stealth SAFES ShadowVault Manual de usuario

Knox

Knox KeySecure 5 Manual de usuario

Kwikset

Kwikset 48334/01 Manual de usuario