Billion BiPAC 7404VGOX Manual de usuario

BiPAC 7404V(G)OX

BiPAC 7404V(G)PX

3G/ VoIP/ (802.11g) ADSL2+

(VPN) Firewall Router

Quick Start Guide

Billion BiPAC 7404V(G)OX/7404V(G)PX 3G/VoIP/(802.11g)ADSL2+ (VPN) Firewall Router

Package Contents

BiPAC 7404V(G)OX/7404V(G)PX ADSL2+ Router

CD containing the on-line manual

RJ-11 ADSL/telephone cable

Ethernet (RJ-45) cable

One 2dBi detachable antenna (Wireless Router only)

Power adapter

RJ-45 to RS-232 Console Kit

This Quick Start Guide

Splitter/ Micro-filter (Option)

Warning

PLEASE READ THE QUICK START GUIDE AND FOLLOW THE

STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU

INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE.

IF YOU NEED MORE INFORMATION ON THIS SOFTWARE

CONFIGURATION, PLEASE REFER TO THE USER’S MANUAL ON

CD-ROM.



Do not use the

router

in high humidity or high temperatures.

Do not use the same power source for the router as other

equipment.

Do not open or repair the case yourself. If the router is too hot,

turn off the power immediately and have it repaired at a qualified

service center.



Avoid using this

product

and all

accessorie

outdoors.



Place the router on a stable surface.

Only use the power adapter that comes with the package. Using a

different voltage rating power adaptor may damage the router.

Attention

Quick Start Guide

Hardware Overview

The Front LEDs

The Rear Ports

Connect the

supplied power

adapter to this jack

Connect the supplied

RJ-11 cable to this port

when connecting to the

ADSL/telephone

network

Press it to reset

the device or

restore to factory

default settings

Connect your

computer to a

LAN port, using

the included

Ethernet cable

Connect the

detachable antenna

Lit when power is ON

Connect RJ

11 cable

to this port when

connecting to the

telephone wall jack

Connect RJ

11 cable

to this port when

connecting to an

analog phone set

Lit when connected to an

Ethernet device.

Green for 100Mbps;

Orange for 10Mbps.

Blinking when data is

Transmitted / Received

Lit green

when the

phone is

off-hook

Lit Green when

successfully

connected to an

ADSL DSLAM,

(“line sync”).

Lit green w

hen the

wireless connection is

established.

Flashes when sending /

receiving data

Lit

green when the

USB device is ready.

Flashes when

sending/ receiving

data.

Power

ON/OFF

switch

Lit green when IP connected

Flashes green when IP

connected and IP traffic is

passing thru the device.

Lit red when device attempted

to become IP connected and

failed

Lit

when successfully

connected to PSTN.

Lit when the SIP

Registration is OK.

Green for Phone 1;

Orange for Phone 2

Push WPS button to

trigger Wi-Fi Protected

Setup

3G/ HSDPA USB

modem backup for

Internet access

Billion BiPAC 7404V(G)OX/7404V(G)PX 3G/VoIP/(802.11g)ADSL2+ (VPN) Firewall Router

Hardware Connection

Hardware Installation

1. Power Connection

Plug the supplied power adapter to the wall jack and the other side to the router.

Please note that the plug type may differ according to different countries.

2. LAN Connection

Connect the supplied RJ-45 Ethernet cable to one of the Ethernet ports, and the

other side to the PC’s Ethernet interface.

Quick Start Guide

3. USB Connection

The USB 2.0 port supports 3G/HSDPA modem connectivity: users can

conveniently access Internet via 3G, eliminating the limitations of the wired

network. This solution also employs an auto fail-over feature to ensure always-on

connectivity for SOHO users.

4. Phone Connection

Connect RJ-11 cable to the router’s “phone 1” or “phone 2” when connecting to an

analog phone set. Both ports (“Phone 1” and “Phone 2”) can make VoIP calls

simultaneously. But only one phone is allowed to make PSTN call at the same

time

5. Line Connection

a) Connect RJ-11 cable to the router’s DSL port when connecting to the splitter’s

ADSL port.

b) Connect RJ-11 cable to the router’s Line port when connecting to the splitter’s

Phone port.

c) Connect RJ-11 cable to the splitter’s Line port when connecting to the

telephone wall jack.

Billion BiPAC 7404V(G)OX/7404V(G)PX 3G/VoIP/(802.11g)ADSL2+ (VPN) Firewall Router

6. Splitter/ Micro-filter Connection

The Splitter / Micro-filter are important for ADSL installation, they help direct

high-frequency signals to the ADSL modem & low frequency signals to the

telephone or other analogue device to prevent inter-modulation distortion & get

good speed/stable ADSL sync rate.

a) Splitter connection

If the installation has only a single telephone and a single ADSL modem, then a

splitter can be employed.

b) Micro-filter connection

If the installation has several telephones or other analog devices, then an internal

micro-filter can be employed at each analog device.

Quick Start Guide

Setup Utility

After you complete the hardware installation insert CD into the CD Drive to run the setup utility.

The setup utility will auto-run. Follow the step-by-step configuration wizard & it will guide you to

setting up the basic network configuration.

Troubleshooting

1. None of the LEDs are on when you turn on the router.

Check the connection between the adapter and the router. If the error persists, you may have

a hardware problem. In this case you should contact technical support.

2. You have forgotten your router login and/or password.

Try the default login and password, please refer to Chapter 3. If this fails, you can restore

your router to its factory settings by holding the Reset button on the back of your router for 6

seconds or more.

3. Can’t ping any PCs on the LAN.

Check the Ethernet LEDs on the front panel. The LED should be on for a port that has a PC

connected. If it is off, check the cables between your router and the PC. Make sure you have

uninstalled any software firewall for troubleshooting. Verify that the IP address and the subnet

mask are consistent between the router and the workstations.

4. Frequent loss of ADSL linesync (disconnections).

Ensure that all other devices connected to the same telephone line as your router (e.g.

telephones, fax machines, analogue modems) have a line filter connected between them and

the wall socket (unless you are using a Central Splitter or Central Filter installed by a qualified

and licensed electrician), and ensure that all line filters are correctly installed and the right

way around. Missing line filters or line filters installed the wrong way around can cause

problems with your ADSL connection, including causing frequent disconnections. If you have

a back-to-base alarm system you should contact your security provider for a technician to

make any necessary changes.

Product Support and Contact Information

Most problems can be solved by referring to the Troubleshooting section in the User’s Manual.

If you cannot resolve the problem with the Troubleshooting chapter, please contact the dealer

where you purchased this product.

Contact Billion

WORLDWIDE

http://www.billion.com

Billion Product Registration

Billion is committed to before and after sales customer services. You will get the most out of your Billion's products

after registration. Please register online at www.billion.com/register to receive valuable services and support from

us.

7404V(G)OX/V(G)PX

:V1.00EN

Otros manuales para BiPAC 7404VGOX

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Enrutador de red de Billion

Billion

Billion BiPAC 7404V(G)OX/V(G)PX Manual de usuario

Billion

Billion BiPAC 7402GL R4 Manual de usuario

Billion

Billion BiPAC 6200WZL R2 Manual de usuario

Billion

Billion BiPAC 7402G Manual de usuario

Billion

Billion BiPAC 5100 Manual de usuario

Billion

Billion BIPAC-74x GE Series Manual de usuario

Billion

Billion BiPAC 2072 Manual de usuario

Billion

Billion BiPAC 5400SW Manual de instalación y operación

Billion

Billion BILLION BIPAC-7500GL Manual de usuario

Billion

Billion BiPAC 5200S Series Manual de usuario

Billion

Billion BiPAC 7300 Manual de usuario

Billion

Billion BiPAC 710C2 Manual de usuario

Billion

Billion BiPAC 5100S Manual de usuario

Billion

Billion BiPAC 8800NL R2 Guía de configuración

Billion

Billion BiPAC 7402VGO Manual de usuario

Billion

Billion BiPAC 7202 Manual de usuario

Billion

Billion BiPAC 7300G Manual de usuario

Billion

Billion BiPAC 2070 Manual de usuario

Billion

Billion BiPAC 7402X Series Manual de usuario

Billion

Billion BiPAC 7402(G)X(L) Series Manual de usuario

Billion

Billion BiPAC 5200S RC Series Manual de usuario

Billion

Billion BiPAC 7402 Manual de usuario

Billion

Billion BiPAC 7800VDPX Manual de usuario

Billion

Billion BiPAC 7800 Manual de usuario

Manuales populares de Enrutador de red de otras marcas

Allnet

Allnet ALL0333AU Manual de usuario

HomeSeer

HomeSeer HT-SEL Manual de usuario

Sercomm

Sercomm Genesis OC3505D Manual de usuario

TP-Link

TP-Link TD-8817 Manual de usuario

Motorola

Motorola MR1900 Manual de usuario

Digi

Digi IX14 Manual de usuario

Cisco

Cisco NCS 540 Manual

XAVi

XAVi X8821e Manual de usuario

BEC

BEC 6200WZL Manual de usuario

MikroTik

MikroTik hAP ac3 Series Manual de usuario

Korenix

Korenix JetNet 5428G Series Manual de usuario

NETGEAR

NETGEAR FS526T - Switch Manual de usuario

Korenix

Korenix JetNet 5710G Series Manual de usuario

Automated Logic

Automated Logic ZN551 Manual del propietario

Cisco

Cisco ASR 1000 Series Manual del operador

EnGenius

EnGenius ESR-9710 Manual de usuario

Cisco

Cisco 805 Series Instrucciones de funcionamiento y seguridad

LevelOne

LevelOne FBR-1416 Manual de usuario