Avocent SwitchView SC380 Manual de usuario

To Contact Avocent Technical Support: Visit www.avocent.com 590-1011-501E

Avocent, the Avocent logo, SwitchView and Cybex are either registered trademarks or trademarks of Avocent Corporation or its afﬁliates in the United States and/or other countries. ©2011 Avocent Corporation. 1

The following instructions will help you

install your SwitchView SC380 switch.

Should you require further assistance,

please contact Avocent Technical Support.

1Connecting local peripherals

Turn off all servers you plan to use with

your SwitchView SC380 switching

system. Plug the DVI-I monitor cable

into the appropriate CONSOLE port on

the back of the switch. Plug the USB

keyboard cable, USB mouse cable and

USB CCID [Integrated Circuit(s) Cards

Interface Devices] Smart Card reader or

CAC reader into the appropriate ports.

Plug the speaker cable and microphone

cable into the appropriate ports.

NOTE: An applicable USB CCID driver

must be installed on the target server.

NOTE: Do not insert a Smart Card/

CAC into the reader until the switch is

fully conﬁgured and turned on.

2Connecting your servers

The SwitchView SC380 switching

system has eight ports labeled A-H on

the rear of the switch. Plug the USB

cable, the two audio cables (speaker

and microphone) and the DVI-I cable

(monitor) into the corresponding ports

on the server. Plug the other ends into

one of the server port sets on the switch.

Repeat for all servers.

NOTE: Cable sets without audio cables

are available if you do not require

speaker and microphone support.

3Turning on your system

Plug one end of the included power cord

into the IEC power connector on the

switch. Plug the other end of the power

cord into an AC wall outlet. Turn on all

attached servers.

4Switching your servers

Press the corresponding front panel

button, labeled A-H, to access servers in

your SwitchView switching system.

NOTE: This switch has tamper evident

seals. Broken or removed seals will void

the warranty.

LEDs

Each target port (A-H) has two LEDs on

the front panel. The green LED will light

when the target device is supplying USB

power to the switch. The amber LED will

blink for 12 seconds until all interfaces

have connected to the selected target

device and then remain on.

Supported Hardware

The SC380 switch supports most

DVI monitors and video cards, VGA

monitors and video cards (with

adaptors), speakers, microphones,

USB keyboards, USB mice, USB CCID

Smart Card readers or CAC readers.

QUICK INSTALLATION GUIDE SwitchView™SC380 8-Port DVI-I/USB Switch with Audio

SwitchView SC380 switch shown

To Contact Avocent Technical Support: Visit www.avocent.com 590-1011-501E

Environmental

Operating Temperature:

32˚ (0˚C) to 104˚ (40˚C)

Storage Temperature:

-4˚ (-20˚C) to 122˚ (50˚C)

Operating Voltage 100-240 VAC

Power Frequency: 50/60 Hz

Typical Power Consumption:

SC380 – 10.7W (120V), 10.9W (240V)

Maximum Power Consumption:

SC380 – 25W (120V), 25W (240V)

NOTE: Power consumption ﬁgures were

determined by internal analysis. Typical

power consumption tests included a

USB keyboard, mouse and CAC reader.

Maximum power consumption tests

included a 0.5A USB load on each USB

port.

Mechanical

Approximate dimensions:

H x W x D = 1.7 in. [43.2 mm] X 17.0 in.

[431.8 mm] X 9.2 in. [233.7 mm]

Weight = 6 lbs. (2.7 kg)

Video Modes: VGA, SVGA, XGA,

SXGA, UXGA, QXGA, WVGA, WSVGA,

WXGA, WSXGA, WUXGA, WQXGA

and HDTV

Maximum Resolution: Dual link DVI up to

2560 x 1600 @ 60 Hz (monitor and

video card support for the maximum

resolution will vary and should be veriﬁed

for compatibility)

Video Adaptors

The local port connectors and cable

connectors on the SC380 switch

are DVI-I. Analog monitors require an

adaptor to connect to the VGA port

(VAD-27). Monitors with digital-only

connectors can be plugged directly

into the DVI-I connector on the SC380

switch.

Target Video Connectors

All of the target video connectors

and cable connectors on the SC380

switch are DVI-I. Target servers with

analog connectors require an adaptor

to connect to the VGA port (VAD-

28). Target servers with digital only

connectors must use an adaptor to

match up with the DVI-D port (VAD-31).

Cables

Users can choose from single-head DVI-I

cables of varying lengths and select

whether or not to use audio (speakers

and microphone).

Contact an Avocent representative for

ordering details.

Rack Mounting the Switch

NOTE: Please refer to the separate safety

sheet for important information on safely

rack mounting your switch.

1. Remove two 8-32 x 1/4 in. truss

head screws from the side of the

switch and discard.

2. Place one rack mount bracket on

the side of the switch with the

ﬂange facing the front of the switch.

Adjust the bracket forward or back

to align the mounting holes.

3. Secure the bracket with the 8-32

x 3/8 in. stainless steel screws

included with the rack mount

brackets.

4. Repeat steps 1-3 for the opposite

side.

QUICK INSTALLATION GUIDE SwitchView™SC380 8-Port DVI-I/USB Switch with Audio

Otros manuales de Cambiar de Avocent

Avocent

Avocent DSR Series DSR1031 Manual de instrucciones

Avocent

Avocent DSR Series DSR1022 Manual de usuario

Avocent

Avocent AutoView 2020 Instrucciones de instalación y mantenimiento

Avocent

Avocent PS/2 KVM Manual de usuario

Avocent

Avocent ESP-4 MI Instrucciones de instalación y mantenimiento

Avocent

Avocent DSR SWITCH - Instrucciones de instalación y mantenimiento

Avocent

Avocent DSR Series DSR1020 Manual de instrucciones

Avocent

Avocent Cybex SwitchView SC8 DVI Manual de usuario

Avocent

Avocent Single port KVM over IP switch Manual de usuario

Avocent

Avocent SwitchView IP 1020 Instrucciones de instalación y mantenimiento

Avocent

Avocent AutoView 1515 Manual de usuario

Avocent

Avocent DSR Series DSR1030 Manual de usuario

Avocent

Avocent SwitchView SC120 Manual de usuario

Avocent

Avocent DSR DSR800 Instrucciones de instalación y mantenimiento

Avocent

Avocent AMX Switch Series Manual de usuario

Avocent

Avocent SwitchView 100 Series Manual de usuario

Avocent

Avocent SWITCHVIEW PC Manual de usuario

Avocent

Avocent SwitchView SC120 Manual de usuario

Avocent

Avocent DSR Series DSR1021 Instrucciones de instalación y mantenimiento

Avocent

Avocent AutoView 1000R Instrucciones de instalación y mantenimiento

Avocent

Avocent AutoView 3100 Manual de usuario

Avocent

Avocent AUTOVIEW 3008 Instrucciones de instalación y mantenimiento

Avocent

Avocent DSR Series DSR1010 Instrucciones de instalación y mantenimiento

Avocent

Avocent DS1800 Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario