Audiovox VBP800 Manual de usuario
VBP800VBP800
VBP800VBP800
VBP800
PORTABLE 8" LCD MONITOR AND DVD PLAYER
IN A BAG
Notice:
This Product incorporates copyright protection technology that is pro-
tected by method claims of certain U.S. Patents and other intellectual
propertyrightsownedbyMacrovisionCorporationandotherrightsown-
ers. Use of this copyright protection technology must be authorized by
MacrovisionCorporation,andisintendedforhomeandotherlimitedview-
ing uses only unless otherwise authorized by Macrovision Corporation.
Reverse engineering or disassembly is prohibited.
An LCD panel and/or video monitor may be installed in a motor vehicle
and visible to the driver if the LCD panel or video monitor is used for
vehicle information, system control, rear or side observation or naviga-
tion. If the LCD panel or video monitor is used for television reception,
video or DVD play, the LCD panel or video monitor must be installed so
thatthesefeatures will onlyfunctionwhenthe vehicle is in“park”orwhen
the vehicle’s parking brake is applied.
An LCD panel or video monitor used for television reception, video or
DVD play that operates when the vehicle is in gear or when the parking
brake is not applied must be installed to the rear of the driver’s seat
where it will not be visible, directly or indirectly, to the operator of the
motor vehicle.
3
A. Introduction
Thankyou for selectingthe VBP800 portableDVDplayer in abag.
The main features include a 8" Screen (16:9Aspect Ratio) Liquid
Crystal Display (LCD) monitor and a DVD player. The unit applies
thelatest stateof the artelectronics and isdesigned for usein ho-
tels,officeshomeorvehicle.Theunit isconstructedtoprovideyears
ofreliable,trouble-free service,andiscompact sothatyou cantake
it with you anywhere and is designed for quick and easy
installation.Pleasereadthe entire instructionmanualsuppliedwith
thisproductpriorto operation. Thedocumentationwillassistyouin
installing the system properly to obtain the best equipment perfor-
mance. Allmanualsshouldbestoredforlateruse.
B. Cautions and Warnings
1. Placement
To prevent fire or electric shock, do not expose this appliance to
rain or moisture. Do not place the set on an unstable cart, stand,
tripod,bracketor table topreventitfrom falling. Keep theunitaway
fromstrong magnets, heatsources,direct sunlight,excessivedust.
If the unit is brought directly from a cold to a warm location, mois-
ture may condense inside the unit. When you move it from a cold
to a warm location, wait for about one hour before operating the
unit,orremovethedisc and leave the unit turned on untilthemois-
ture evaporates.
2. Installation
Ensure that the VBP800 is installed in accordance with the in-
structions and illustrations provided in this manual.
3. Object and Liquid
Do not push objects of any kind into the unit through openings; do
not spill or spray liquid of any kind on or in the system (this may
result in a fire or electric shock). Do not place anything heavy on
the unit. To ensure proper ventilation and proper operation, never
cover or block the slots and openings with a cloth or other mate-
rial.
4. Disassembly
Do not attempt to disassemble the cabinet. There is a risk of elec-
tric shock and/or exposure to Laser Radiation. Contact qualified
service personnel if your system is in need of repair.
4
5. Cleaning Unit
Whencleaning,make surethesystemis unplugged fromthepower
source. Do not use liquid cleaners or aerosol cleaners. Use a
cloth lightly dampened with water for cleaning the exterior of the
system only.
6. Disc
Do not use irregularly shaped discs such as heart or star-shaped
discs as they may cause the unit to malfunction. Do not stick pa-
per, tape or glue on the disc. Do not expose the disc to direct sun-
light or heat sources such as hot air ducts. Do not touch the sur-
face of disc. Handle the disc by its edge. Clean the disc by wiping
the disc from the center out with a cleaning cloth. Remove the disc
from the unit and store it in its case after playing. Some playback
operations of discs may be intentionally fixed by software produc-
ers. Since this unit plays discs according to the disc contents the
software producers designed, some playback features may not be
available.Also refer to the instructions supplied with the discs.
C. Contents
1. 1 x 8’’ LCD Monitor & DVD Player Combo
2. 1 x AC to DCAdapter
3. 1 x Remote Control w/Battery
4. 1 x Instruction Manual
5. 1 x Audio/Video Input Cable
6. 1 x Audio/Video output Cable
7. 1 x Power Adapter w/Built-In FM Modulator
8. 1 x Mounting Bag w/Straps
9. 1 x Carrying bag
10. 1 x Rechargable Battery Pack (Part Number VBB7080)
D. Powering and installation
1. Powering the system indoors
(Refer to Figure 1)
Plug one end of the AC to DC adapter into the DC 9V jack on the
rightsideofthe main unit, then plug theotherendintothe120VAC
power receptacle.
5
2. Powering the system in a car
Plug one end of the cigarette lighter adapter into the DC 9V jack on
the unit, then plug the other end into the cigarette lighter socket.
Figure 1
3. Powering the system with rechargeable Battery
Please refer to K. * Rechargeable Battery Installation and Use
(Page 33 and 35).
E. Installation Instructions
Make sure that the unit is placed into the bag with the clear plastic
coveringaroundDVD door, Load disc into the DVD compartment and
then fasten the Velcro strap across the top portion of the unit. If you
are installing the bag onto the seatback you will need to attach the
supplied Seat Standoff to the back of the mounting bag with the
Velcro bands to obtain the proper viewing angle as shown in Figure.2
6
1.Installing the System onto the seat back in a car
(Refer to Figure 2)
Figure 2
1). Take one of the supplied straps from the carrier bag. Connect
the latch to one of the upper metal rings on the mounting bag.
Connect the “S” hook to the other upper metal ring and place the
loop over the headrest. Adjust the strap until the bag is firmly
secured.
2). Take another strap from the carrier bag, and connect the latch to
the lower metal ring on the left side of the bag. Attach the “S”
hooktothesameringafterloopingthestraparoundtheseatrail.
Repeat this process for the right side. In some vehicles, it may
be necessary to attach the “S” connector to the rail directly, as it
may not be long enough to reach back to the ring.
3). Adjust the straps tightly so that the bag is secured.
Seat Standoff
7
2. Installing the system between the driver/passenger seat
(Refer to Figure 3)
Figure 3
1). Takeone strap and connect the latch to the upper metal ring on
the left side of the bag. Attach the “S” hook to the same ring
after looping the strap around the headrest of the driver’s seat.
Repeat this process for the right side (Passenger Seat).
2). Take another strap and connect the latch to lower metal ring on
the left side of the bag. Attach the “S” hook to the same ring
after looping the strap around the driver’s seat rail. Repeat this
process for the right side. In some vehicles, it may be neces-
sary to attach the “S” connector directly to the rail, as it may not
be long enough to reach back to the ring.
3). Adjust the straps tightly so that the bag is secured.
8
F. Controls, Indicators, and Connectors
1. Unit View
(Refer to Figure 4)
Figure 4
1) Menu
2) UP Button
3) LEFT Button
4) DOWN Button
5) OK Button
6) RIGHT Button
7) Open Button
8) Previous Button
9) Stop Button
10) Next Button
11) Play button
12) Pause
13) Screen Mode (WIDE) Button
14) NTSC/PAL Switch
15) Monitor Off Button
16) IR Transmitter
17) IR ON/OFF Switch
18) Remote Control Sensor
19) Power LED
20) DVD Video Output Jack
21) DVD Audio Output Jack
22) Video Input Jack
23) Audio L+R Input Jack
24) Power On/Off Switch
25) Volume +/- control
26) Headphone Jack 1
27) Headphone Jack 2
28) PAL/NTSC Switch
29) IR Switch
30) DC 9V Input Jack
31) Brightness +/- control
9
2. Remote Control View
(Refer to Figure 5)
1) DISPLAY Button
2) ANGLE Button
3) SUBTITLE Button
4) AUDIO Button
5) ZOOM Button
6) UP/DOWN/LEFT/RIGHT/
ENTER Biotins
7) RETURN Button
8) A-B Button
9) FORWARD Button
10) REVERSE Button
11) SLOW Button
12) STOP Button
13) NUMERICKEYPAD
14) SETUP Button
15) MENU Button
16) REPEAT Button
17) PREVIOUS Button
18) NEXT Button
19) PLAY Button Figure5
20) PAUSE Button
10
G. Loading and Playing a Disc
a. After connecting power to the unit, slide the POWER ON/OFF on
the right side to ON, the DVD player’s POWER indicator lights.
b. Open the disc tray by pressing OPEN at the lower right of the disc
tray, and place a disc into the tray with the disc’s label facing up.
c. Press at the right side of the door until it clicks shut. The unit will
load the disc and start playing.
d.RotateBRIGHTand VOLUME to adjust theLCD’sbrightnessand
the DVD player’s volume.
e. To stop playing a disc, press STOP.
f. ToturnofftheDVDplayer,slidePOWERON/OFFtoOFF.The
DVDplayer’sPOWER indicatorturnsoff.
g. To remove the disc, open the disc tray, then you will see a
pictureontherightinnercornerofthe covertoindicatehowto
removethe disc,justuseyour fingertoaccess therightinner
corner of the disc tray and lift up the disc and remove it from
thedisctray. Pleaserefer to Figure6.
Figure 6
Tabla de contenidos
Otros manuales de Reproductor de DVD portátil de Audiovox
Audiovox
Audiovox D1710 Manual de usuario
Audiovox
Audiovox VE1020 Manual de usuario
Audiovox
Audiovox D1530 Manual de usuario
Audiovox
Audiovox D2010 - Widescreen Ultraslim Portable DVD... Manual de usuario
Audiovox
Audiovox D1710 Manual de usuario
Audiovox
Audiovox D1817PK - DVD Player - 8 Manual de usuario
Audiovox
Audiovox AVXMTG10U Manual de usuario
Audiovox
Audiovox DT102 Manual de usuario
Audiovox
Audiovox D1500A Manual de usuario
Audiovox
Audiovox D1788ES Manual de usuario
Audiovox
Audiovox D1708PK Manual de usuario
Audiovox
Audiovox DVD1500 Manual de usuario
Audiovox
Audiovox D1805 Manual de usuario
Audiovox
Audiovox FLO TV DFL710PK Manual de usuario
Audiovox
Audiovox D1718 - DVD Player - 7 Manual de usuario
Audiovox
Audiovox Eddie Bauer PE702 Manual de usuario
Audiovox
Audiovox D1708 - DVD Player - 7 Manual de usuario
Audiovox
Audiovox D1810 - DVD Player - 8 Manual de usuario
Audiovox
Audiovox VBP3900 Manual de usuario
Audiovox
Audiovox D1726 Manual de usuario
