Aries 2162001 Manual de usuario

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287.8634 •2152001-INS-RB•PAGE 1

INSTALLATION MANUAL

Parts List

1Bull bar

2Driver / left mounting bracket

2Passenger / right mounting bracket

1Driver / left bull bar bracket

1Passenger / right bull bar bracket

1LED wiring harness*

4Hex bolt, M8

4Flat washer, M8

4Nylock nut, M8

4Hex bolt, M10

4Flat washer, M10

4Nylock nut, M10

2Nylock nut, M12

2Hex bolt, M12

2Flat washer, M12

* Wiring harness only included

with LED-equipped models

Torque Speciﬁcations

Metric

M6 bolt 3 ft-lbs.

M8 bolt 7 ft-lbs.

M10 bolt 16 ft-lbs.

M12 bolt 28 ft-lbs.

SAE

1/4" bolt 3 ft-lbs.

5/16" bolt 7 ft-lbs.

3/8" bolt 16 ft-lbs.

7/16" bolt 20 ft-lbs.

1/2" bolt 28 ft-lbs.

Use above torque setting unless otherwise noted

Tools Required

Ratchet Wrench, 13mm

Socket, 13mm Wrench, 17mm

Socket, 17mm Level

Socket Extension

Level of Difﬁculty

Easy

Notes and Maintenance

Before you begin installation, read all instructions thoroughly.

Proper tools will improve the quality of installation and reduce the time required.

To protect the product, wax after installing. Regular waxing is recommended

to add a protective layer over the finish. Do not use any type of polish or wax

that may contain abrasives that could damage the finish.

For polished, gloss and other smooth finishes,

polish may be used to clear small scratches and scuffs on the finish.

Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive

cleaners, abrasive pads, wire brushes or other similar products that may damage the ﬁnish.

Refer to the table to the left when securing hardware during the

installation process to help prevent damage to the product or vehicle.

Product Image

2162001

2162101

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287.8634 •2152001-INS-RB •PAGE 2

Step 1

Remove the splash guard.

Step 2

Once the splash guard is removed,

remove the factory bolt on the driver side.

Step 3

After the bolt is out, take the driver-side

bracket and attach using the factory bolts.

With the bottom bolt snug, use an M12 bolt,

flat washer and nylock nut to secure

the top of the bracket.

Snug the hardware,

but do not fully tighten.

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287.8634 •2152001-INS-RB•PAGE 3

Step 5

To attach the bull bar mounting brackets,

lay the bull bar on a flat surface.

Insert two M8 hex bolts into the inner rail slot.

Place the driver-side bracket over the

bolts and secure the bracket to the bull

bar using an M8 flat washer and M8

nylock nut.

Snug the hardware,

but do not fully tighten.

Step 6

With help, lift the bull bar into place

and align the mounting tabs on the

outside of the mounting brackets.

Step 7

Insert an M10 hex bolt with a flat washer

on the outside of the bracket and an M10

flat washer and nylock nut on the inside.

Snug the hardware,

but do not fully tighten.

Repeat this process

for all mounting locations.

Step 4

Repeat steps 2 and 3 on the passenger side.

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287.8634 •2152001-INS-RB•PAGE 4

Step 9

Disconnect the supplied switch

from the wiring harness and install

in the desired location.

With the switch installed, route the wiring

harness to the LED lights and the switch.

Reconnect the blue, red and black spade

connectors to the switch as shown.

Note: The black wire connects

to the gold switch terminal.

Plug the male connector on the wiring

harness into the female connector

attached to the LED lights.

Step 10

Connect the red fused wire with the ring

terminal to the positive battery post.

Connect the black wire ring terminal

to the negative battery post or other

suitable vehicle grounding point.

Mount the supplied relay to the vehicle

and secure all wires with zip ties away

from moving parts to avoid damage.

Test the lights to ensure proper function.

Step 8

Level and adjust the bull bar into the

desired position and tighten all hardware

to the recommended torque specifications

listed in the table on the first page.

If your bull bar is not equipped

with lights, skip to step 11.

If your bull bar is equipped with lights,

complete steps 9 and 10.

Note: If the LED lights are being used

with a 24V system, the 12V relay will

need to be replaced with a 24V unit.

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287.8634 •2152001-INS-RB •PAGE 5

Step 11

Congratulations on the installation of

your new ARIES AdvantEDGE™bull bar.

With the bull bar installed, periodic

inspections should be performed to ensure

all mounting hardware remains tight.

To protect your investment, see the

'Notes and Maintenance' section on

the first page of this instruction manual.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Accesorios para automóviles de Aries

Aries

Aries P35-2004 Manual de usuario

Aries

Aries S224054-2 Manual de usuario

Aries

Aries S224045 Manual de usuario

Aries

Aries 2153002 Manual de usuario

Aries

Aries P3067 Manual de usuario

Aries

Aries AL235033 Manual de usuario

Aries

Aries 203015 Manual de usuario

Aries

Aries 204001 Manual de usuario

Aries

Aries 4499 Manual de usuario

Aries

Aries Pro Series Manual de usuario

Aries

Aries 204017 Manual de usuario

Aries

Aries 2165102 Manual de usuario

Aries

Aries 2072101 Manual de usuario

Aries

Aries 2055117 Manual de usuario

Aries

Aries AL239042 Manual de usuario

Aries

Aries 2051179 Manual de usuario

Aries

Aries AL235041 Manual de usuario

Aries

Aries 2154001 Manual de usuario

Aries

Aries 363006-2 Manual de usuario

Aries

Aries 2074150 Manual de usuario

Aries

Aries 1110313 Manual de usuario

Aries

Aries 2057975 Manual de usuario

Aries

Aries 2074140 Manual de usuario

Aries

Aries 3020000 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario

Prorack

Prorack K1163 Manual de usuario