Aries 2165102 Manual de usuario

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287.8 634 •2165102-INS-RA •PAGE 1

INSTALLATION MANUAL 2165102

Parts List

1Bull bar

1Driver / left mounting bracket

1Passenger / right mounting bracket

1Driver / left side brace bracket

1Passenger / right side brace bracket

1Driver / left side adapter bracket

1Passenger / right side adapter bracket

2Bolt plate, M12

2Hex bolt, M12

6Flat washer, M12

4Lock washer, M12

4Hex nut, M12

4Hex bolt, M10

4Nylock nut, M10

8Flat washer, M10

4Hex nut, M8

4Flat washer, M8

4Nylock nut, M8

2Hex bolt, M14

2Lock washer, M14

2Flat washer, M14

1LED wiring harness*

* Wiring harness only included

with LED equipped models

Tools Required

Ratchet Box wrench set

Socket set Level

Socket extension --

Maintenance

To protect the product, wax after installing. Regular waxing is recommended

to add a protective layer over the finish. Do not use any type of polish or wax

that may contain abrasives that could damage the finish.

For polished, gloss and other smooth finishes,

polish may be used to clear small scratches and scuffs on the finish.

Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive

cleaners, abrasive pads, wire brushes or other similar products that may damage the ﬁnish.

Product PhotoLevel of Difﬁculty

Easy

NOTICE

Before you begin installation, read all instructions thoroughly.

Proper tools will improve the quality of installation and reduce the time required.

To help prevent damage to the product or vehicle, refer to the specified

torque specifications when securing hardware during the installation process.

Torque Speciﬁcations

Metric

M6 bolt 3 ft-lbs.

M8 bolt 7 ft-lbs.

M10 bolt 16 ft-lbs.

M12 bolt 28 ft-lbs.

SAE

1/4" bolt 3 ft-lbs.

5/16" bolt 7 ft-lbs.

3/8" bolt 16 ft-lbs.

7/16" bolt 20 ft-lbs.

1/2" bolt 28 ft-lbs.

Use above torque setting unless otherwise noted

Product Registration and Warranty

CURT Group stands behind our products with industry-leading warranties.

Provide feedback and help us to improve our products by registering your purchase at:

warranty.curtgroup.com/surveys

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287.8 634 •2165102-INS-RA •PAGE 2

Step 1

For vehicles with tow hooks, remove the

tow hooks from the vehicle by removing

the two bolts securing them to the frame.

The rear bolt will be reused.

For vehicles without tow hooks, remove the

plastic covers from the tow hook openings by

loosening the two nuts on top and removing the

star washers from the bottom pegs. The covers

will pull out through the front.

Step 4

Secure the brace bracket to the tow hook

bracket using an M12 hex bolt, two flat

washers, a lock washer and hex nut.

Snug the hardware,

but do not fully tighten.

Repeat this step on the driver side.

Step 2

For vehicles with tow hooks, reinstall the rear

bolt throught the rear slot. Secure the forward

position using the provided M14 hex bolts, lock

washers and flat washers.

For vehicles without tow hooks, loosen the rear

bolt just enough to allow the bracket to slide

between the bolt and the tube spacer that is

welded to the frame.

Snug the hardware,

but do not fully tighten.

Step 3

Place a bolt plate through the

rear of the opening, as shown.

Locate the passenger-side brace bracket and

place it on the opposite side of the bolt plate,

putting the bolt through the slot of the small tab

of the brace bracket. Secure the brace bracket

to the bolt plate using an M12 flat washer, lock

washer and hex nut.

Snug the hardware,

but do not fully tighten.

Repeat this step on the driver side.

Passenger side

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287.8 634 •2165102-INS-RA •PAGE 3

Step 5

To attach the bull bar mounting brackets,

lay the bull bar on a flat surface. Insert two

M8 hex bolts into the inner rail slot.

Step 8

Level and adjust the bull bar into the

desired position. Tighten all hardware

to the recommended torque specifications

listed in the table on page one.

If your bull bar is not equipped

with lights, skip to step 11.

If your bull bar is equipped with

lights, complete steps 9 - 10.

Note: If the LED lights are being used with

a 24V system, the 12V relay will need to be

replaced with a 24V unit.

Step 6

Place the passenger-side bracket over the

bolts and secure the bracket to the bull bar

using two M8 ﬂat washers and M8 nylock nuts.

Snug the hardware,

but do not fully tighten.

Repeat this step on the driver side.

Step 7

With assitance, lift the bull bar into

place and align the mounting tabs on

the outside of the mounting brackets.

Insert an M10 hex bolt with a

flat washer on the outside of the

bracket and an M10 flat washer and

nylock nut on the inside for each slot.

Snug the hardware,

but do not fully tighten.

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287.8 634 •2165102-INS-RA •PAGE 4

Step 9

Disconnect the supplied switch from the wire

harness and install in desired location.

With the switch installed, route the wire

harness to the LED lights and the switch.

Reconnect the blue, red and black spade

connectors to the switch, as shown.

Note: The black wire connects

to the gold switch terminal.

Plug the male connector on

the wire harness into the female

connector attached to the LED lights.

Step 10

Connect the red fused wire with the ring

terminal to the positive battery post.

Connect the black wire ring terminal

to the negative battery post or other

suitable vehicle grounding point.

Mount the supplied relay to the vehicle

and secure all wires with zip ties away

from any moving parts to avoid damage.

Test the lights to ensure proper function.

Step 11

Congratulations on the installation of

your new ARIES AdvantEDGE™bull bar.

With the bull bar installed, periodic

inspections should be performed to ensure

all mounting hardware remains tight.

To protect your investment, see the

'Notes and Maintenance' section on

the first page of this instruction manual.

Otros manuales de Accesorios para automóviles de Aries

Aries

Aries 205040 Manual de usuario

Aries

Aries 2074153 Manual de usuario

Aries

Aries S224046-2 Manual de usuario

Aries

Aries 203016 Manual de usuario

Aries

Aries 2051181 Manual de usuario

Aries

Aries 2051179 Manual de usuario

Aries

Aries S224045 Manual de usuario

Aries

Aries AdvantEDGE Manual de usuario

Aries

Aries 25201 Manual de usuario

Aries

Aries 205039 Manual de usuario

Aries

Aries 203015 Manual de usuario

Aries

Aries 3069 Manual de usuario

Aries

Aries B35-2004-3 Manual de usuario

Aries

Aries 2153002 Manual de usuario

Aries

Aries 2081205 Manual de usuario

Aries

Aries 2055100 Manual de usuario

Aries

Aries 2074106 Manual de usuario

Aries

Aries 2081300 Manual de usuario

Aries

Aries 2074142 Manual de usuario

Aries

Aries 4499 Manual de usuario

Aries

Aries B35-2000 Manual de usuario

Aries

Aries AL235040 Manual de usuario

Aries

Aries S223043 Manual de usuario

Aries

Aries AL234045 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario

Prorack

Prorack K1163 Manual de usuario