Antari M-1 Manual de usuario

User Manual for the Antari M-1 Mobile Fog Machine

Save and read these instructions

Bitte lesen Sie und sichern Sie diese Anweisungen

Lisez et Gardez ces instructions

M-1 Mobile Fogger

Thank you for choosing Antari’s M-1 Mobile Fogger. You now own a

sturdy and portable state-of-the-art fog machine. Prior to use, we

suggest that you carefully read all of the instructions. By following the

suggestions found in this user manual, you can look forward to

exceptional performance from your Antari Mobile Fog Machine for years

to come.

Please follow these operation, safety and maintenance instructions

to ensure a

long and safe life for your fog machine.

Specifications

Output: 100 cu.ft. / min

Power Consumption: 75 W

Tank Capacity: 110 cc

Battery: DC 12V / 2.3 Ah

Consumption: 2 cc / min

Weight: 2.7 Kg

Dimensions (mm): L 227 W 66 H 81

Continuous Output Duration:10-12 minutes (battery)

Unlimited (power adaptor)

CAUTION!

Pay attention to all warning labels and instructions printed on the

exterior of your Antari M-1 Fog Machine

Danger of electric shock

Keep this device dry.

Always remove the battery or unplug the power adaptor to your Antari

M-1 Fog Machine before filling the liquid tank.

Keep fog machine upright.

Remove the battery or unplug the power adaptor when not in use.

This machine is not waterproof or splash proof. If moisture, water, or

fog liquid gets inside the housing, immediately remove power and

contact a service technician or your Antari dealer before using it again.

No user serviceable parts inside. Refer to your Antari dealer or other

qualified service personnel.

Danger of burns

For adult use only. Fog machine must be installed out of the reach of

children. Never leave the unit running unattended.

Keep nozzle at least 50 cm (20 in.) away from contact with anything

while in operation.

The fog vapor at point of release is under pressure and is extremely

hot.

Never aim the output nozzle directly at people.

Fog machine output is hot. Avoid coming within 50 cm of the output

nozzle during operation.

Place the fog machine in a well-ventilated area. Never cover the

vents on the front of the M-1. Never aim the output nozzle at open

flames.

The output nozzle becomes hot during operation. Keep flammable

materials at least 50 cm away from the nozzle.

Always allow your Antari Fog Machine to cool down before attempting

to clean or service it. Danger of explosion

Do not expose the battery to excessive heat, keep away from open

flames and do not attempt to remove the case.

Never add flammable liquids of any kind (oil, gas, perfume) to the fog

liquid.

Use only the high quality, water/glycol based fog liquid that your Antari

dealer recommends. Other fog liquids may generate a poor fog effect,

clog the internal components or “spit” fog liquid.

Always make sure there is sufficient liquid in the fog liquid tank. The

fluid level can be monitored via the window at the back of the machine.

Operating this unit without liquid will cause damage to the pump and

the heater.

If your Antari Fog Machine fails to work properly, discontinue use

immediately. Drain all fog liquid from the tank, pack the unit securely

(preferably in the original packing material), and return it to your Antari

dealer for service.

Always drain fog liquid from the tank before shipping or transporting

this unit.

Never drink fog liquid. If it is ingested, call a doctor immediately. If

fog liquid comes in contact with skin or eyes, rinse thoroughly with

water.

Unpacking & Inspection

Open the shipping carton and check that all equipment necessary to

operate the system has arrived intact. In addition to this user manual,

you should receive the following items:

1. M-1 Mobile fogger

2. 12V – 2.3Ah rechargeable battery

3. Rechargeable battery charger

4. Power cable for the battery charger

5. 500 cc bottle of Antari fog liquid

6. Briefcase sized Mobile Fogger flight case

Before beginning initial setup of your Antari Fog Machine, make sure

that there is no evident damage caused by transportation.

In the event that the unit’s housing or cable is damaged, do not plug it

in and do not attempt to use it until after contacting your Antari dealer

for assistance.

Setup

Remove all packing materials from the fog machine. Check that all

foam and plastic padding is removed, especially in the nozzle area.

Fill with Antari Fog Liquid or dealer recommended high-quality

water-based fog fluid. Any other types of fluid can damage the unit.

When filled, place cap back on liquid tank.

Charge the battery. Plug the adaptor into a grounded electrical outlet.

The green light on the battery charger will light up when it is connected

to the power supply. Then connect the charging head to the battery.

Please note the battery required 8hr charging time on first charge. The

battery will be fully charged in approximately 2~3 hr.

The charge will last between 10-12 minutes of constant fog output

before needing to be re-charged.

Plug the charged battery into the bottom of the M-1 Mobile Fogger with

the label face up.

1. Lift-up the plate before inserting the battery.

2. Make sure the battery is inserted on the right position (see photo).

The green light by the front of the handle will flash when the button is

first pressed. This indicates the battery has enough charge to power

the M-1.

When the red light starts to flash, the battery needs to be charged.

The machine will still be able to fog for a short period of time after the

red light begins flashing.

Operation

To generate smoke, press the button on the front of the M-1 Mobile

Fogger’s handle.

There are two operation modes that can be selected for the M-1.

1. Operation mode 1. Allows the fog machine to fog as long as the

handle’s button or the remote control’s button is pressed down. To

stop fogging, stop pressing the button!

2. Operation mode 2. Works on a press once to start and press again

to stop basis. In this mode, start fogging by pressing the button.

The M-1 will fog continuously until the button is pressed a second

time.

Use the small switch on the right side of the M-1. The switch is inside

the case and is adjusted through the small hole on the side of the

case.

To select operation mode 1. Slide the switch towards the back of

the M-1 (towards the cap on the liquid tank).

To select operation mode 2. Slide the switch towards the front of

the M-1 (towards the nozzle).

When an optional remote is connected, please see the detailed

instructions for their operation below.

The machine will fog until the battery charge runs down or the M-1

runs out of fog liquid. When the M-1 is connected to the optional

power adaptor, carefully monitor the level of the fog liquid to make sure

the machine does not run out of liquid. Operating continuously, the

machine will run out of liquid in approximately 50 minutes.

A full battery charge will power the M-1 for a period of 10-12 minutes

before needing to be recharged. When using the battery, the charge

will run down several times before the fluid needs to be refilled.

Note: There is no warm-up time with the M-1 Mobile Fogger. Unlike

most other fog machines, you do not have to wait for the heater to

warm-up before fogging.

Installation

The M-1 Mobile Fogger can be carried in hand or installed in a fixed

location as desired.

Wherever the machine is placed, it is important that fog does not shoot

directly at any one’s face, at open flames or directly into any heat

susceptible material.

The machine can be held or installed at any angle. After refilling the

liquid tank, screw the cap on tightly. Failing to do so will result in

leakage if the machine is placed at an angle.

Optional Remote Control Operation

There are two optional remote controls designed for the M-1 Mobile

Fogger.

1. MCT-1 Timer Remote Control: This remote control is connected

via an 8-meter cord. The duration of the fog blast is set at 10

seconds. The interval is controlled by the dial on the remote and is

adjustable between 3 and 220 seconds.

2. MCR-1 Wireless Remote Control: This remote control consists of

two components. The transmitter is on a small key chain and has

a range of up to 50 meters from the receiver. The receiver

connects to the side of the M-1 Mobile Fogger and can attach to the

M-1’s case via a magnetic strip. Pressing the remote control’s

button once starts the M-1 fogging. A second press stops the

M-1’s fog output.

Warning: The battery must be removed and the power adaptor

unplugged before connecting or disconnecting either of the remote

controls to the M-1 Mobile Fogger.

Optional Power Adaptor

When desired the M-1 Mobile fogger can be powered by an optional

power adaptor which plugs into a standard electrical outlet. The adaptor

connects to a dummy battery which plugs into the battery slot on the M-1.

This allows for unlimited operation of the fog machine. The

disadvantage is that a power supply is required and the mobility of the

M-1 is reduced as a result. The advantage is that the machine can fog

continuously over an unlimited period of time.

Important

Always monitor tank fluid level as you are fogging. Running a fog

machine with no fluid can permanently damage the unit.

If you experience low output, pump noise or no output at all, remove

the battery immediately. Check fluid level and re-charge the battery.

When the liquid tank is full and the battery is charged, plug the battery

in and press the button on the handle.

If the machine is still not working and you are unable to determine the

cause of the problem, do not continue pushing the remote button, as

this may damage the unit. Do not open the case. There are no user

serviceable parts inside. Return the machine to an Antari dealer for

service.

Performance Notes

All fog machines develop condensation around the output nozzle.

Because this may result in some moisture accumulation on the surface

below the output nozzle, consider this condensation when installing

your unit.

Fog machines may sputter small amounts of fog occasionally during

operation and for a minute or so after being turned off. This is normal

and is not indicative of a defect.

After continuous operation, the case of the fog machine will become

warm, especially at the front of the machine. Take care in handling

the machine during and shortly after fogging. Only carry the M-1

Mobile Fogger by the handle and let the machine cool down before

packing it in a carrying case.

C08M1

Otros manuales para M-1

Tabla de contenidos

Otros manuales de Máquina de niebla de Antari

Antari

Antari S-120 Manual de usuario

Antari

Antari M-9 RGBAW Manual de usuario

Antari

Antari F-450 Manual de usuario

Antari

Antari HZ-500 Manual de usuario

Antari

Antari Z-80 Manual de usuario

Antari

Antari W-508 Manual de usuario

Antari

Antari M-11 Manual de usuario

Antari

Antari Z-1200II Manual de usuario

Antari

Antari DNG-200 Manual de usuario

Antari

Antari AF-5X Manual de usuario

Antari

Antari Z-3000II Manual de usuario

Antari

Antari Z-1000X MK3 Manual de usuario

Antari

Antari Fog cooler DNG-100 Manual de usuario

Antari

Antari M-8 Manual de usuario

Antari

Antari FT-100 Fire Training Manual de usuario

Antari

Antari Z-1000 III Manual de usuario

Antari

Antari LCU-1 Manual de usuario

Antari

Antari FT-100 Fire Training Manual de usuario

Antari

Antari FT-200 Manual de usuario

Antari

Antari M-7X Manual de usuario

Antari

Antari PM-1 Manual de usuario

Antari

Antari F-80Z Manual de usuario

Antari

Antari M-5 Manual de usuario

Antari

Antari FT-20X Manual de usuario

Manuales populares de Máquina de niebla de otras marcas

Boost

Boost BOOST-FOG400LED-BK Manual de usuario

Home Accents Holiday

Home Accents Holiday FM1000-ASH Manual de usuario

EuroLite

EuroLite ZEITGEIST FOG-1200 Manual de usuario

Dyna-Fog

Dyna-Fog CYCLONE ULTRA 2734 Manual de usuario

PROEL

PROEL DRAGO HEAVY PLFD150HY Manual de usuario

Sparklyn

Sparklyn Y846 Manual de usuario

Magicfx

Magicfx CO2 Gun Manual de usuario

Ibiza

Ibiza LSM500LAS Manual de usuario

Venue Lighting Effects

Venue Lighting Effects ULTRA MINI-FOGGER Manual de usuario

High End

High End F-100 Manual de usuario

Chauvet

Chauvet ARENA 2100 FLEX Manual de usuario

Beamz

Beamz F1600 Manual de usuario

Sagitter

Sagitter SG ARS900C Manual de usuario

KISANKRAFT

KISANKRAFT KK-STF-480 Manual de usuario

Orion

Orion OT-U250PP Guía

Beamz

Beamz S2500 Manual de usuario

American DJ

American DJ Dyno-Fog II Manual de usuario

JB Systems

JB Systems FX 1700 Manual de usuario