American Standard Colony Corner 1730 SERIES Manual de usuario

INSTALLATION INSTRUCTIONS

753451-100 Rev. A © American Standard Inc. 2003

All product names listed herein are trademarks

of American Standard Inc. unless otherwise noted.

HIGH GLOSS ACRYLIC

SHOWN LESS ALL FITTINGS

COLONY™ CORNER WHIRLPOOL/BATHING POOL

1730 SERIES

FOR AFTER-SALES SERVICE CALL 1 (800) 442-1902 WEEKDAYS.

THANK YOU...

for selecting an American Standard bath. Your new

bath is shipped to you after careful inspection. The

whirlpool version is completely assembled with pump,

motor, and system piping. All you need to finish the

installation are your selected fittings and electrical

connections for a whirlpool.

To insure maximum performance and pleasure from

this product, please follow the instructions and

cautions.

GENERAL INSTALLATION INFORMATION

Carefully uncrate and inspect your new bath for any shipping damage. If such damage is found, report it to your vendor

immediately. After inspection and during installation, protect the bath from construction damage. After installation, and before

enclosing with wallboard, tile, etc., water test the unit and check for leaks.

If a whirlpool, do not make modifications to the whirlpool system or remove pump from factory mounting. This could adversely affect

the safety and performance of the whirlpool and void the warranty. Do not handle or move the whirlpool by the pump, motor, or

piping system.

Fittings (bath filler, shower arm, etc.) are not provided with the bath and must be ordered separately. Framing and enclosing

materials are provided by others. Check for availability of optional American Standard wall tiling bead (required for recess

installations).

Protect all finished surfaces of the whirlpool during construction and installation using a drop cloth.

WARNING! Do not lift whirlpool by the piping harness at any time.

List of Optional Components (not included):

• Apron Kit*

* see your American Standard Distributor

List of Required Components (not included):

• Drain 1583.470*

• Bath Filler*

* see your American Standard Distributor

List of Required Tools and Supplies:

Tools

• Level

• Tape Measure

• Pipe Wrench

• Slip Joint Pliers

• Screw Driver

• Standard

Woodworking Tools

• Personal Safety

Equipment

• Caulking Gun

Supplies

• Nails

• Putty

• Caulking (waterproof)

• 1 x 3 or 2 x 2

Stringers

• Drop Cloth

• 15 amp GFCI

Outlet

• Cement, Plaster,

Grout

495mm

(19-1/2) 117mm

(4-5/8)

C/L OF DRAIN

OUTLET

51mm

(2)

1546mm

(60-7/8)

ALT.

PUMP

1064mm

(41-7/8)

686mm

(27)

318mm

(12-1/2)

1168mm

)(46

1514mm

(59-5/8)

TOP OF

DECK

445mm

(17-1/2)70mm

(2-3/4)

ROUGH

FLOOR

83mm

(3-1/4)

BATH SUPPORT MATERIAL 38mm (1-1/2)

O.D.TAILPIECE

PUMP

PROVIDE ACCESS

FOR SERVICING

PUMP & CONTROLS

(6) JETS

ON/OFF

SWITCH

2 AIR

VALVES

LEVELING

STRINGER

NOT FOR

SUPPORT

483mm

(19)

2134mm

)(84

60 x 60 x 19-1/2 In.(1524 x 1524 x 495mm)

115 Lbs. (52 Kg.)

908 Lbs. (412 Kg.)

95 Gal. (360 L.)

65 Gal. (246 L.)

30 x 50 In. (762 x 1270mm)

45-1/2 x 63-1/2 In.(1156 x 1613mm)

13 In. (330 mm)

36 Lbs./Sq. Ft. (177 Kgs/Sq. m.)

27.8

GENERAL SPECIFICATIONS FOR 1730 WHIRLPOOL

INSTALLED SIZE

WEIGHT

WEIGHT w/WATER

GAL. TO OVERFLOW

WHIRLPOOL MIN. OPERATING VOL.

BATHING WELL AT SUMP

BATHING WELL AT RIM

WATER DEPTH TO OVERFLOW

FLOOR LOADING

(PROJECTED AREA)

PTS.

CUBE (FT3)

WHIRLPOOL ELECTRICAL SPECIFICATIONS

1.1 HP, 9.9 AMPS, 120V.SYSTEM I PUMP

* NOTE: If the optional apron (PN 0730.121) is to be used with this

tub, the stringer height must be referenced from the finished floor.

TYPICAL CORNER INSTALLATION

UNLESS AN ACCESS OPENING OF AT LEAST

12" X 24" (305 X 610 mm) IS PROVIDED,

WARRANTY SERVICE WILL NOT BE PERFORMED.

59-1/2

(1511 mm)

CUTOUT

59-1/2

(1511 mm)

CUTOUT

(762 mm)

17-1/2

(445 mm)

(305 mm)

(610 mm)

LEFT-HAND DRAIN

ACCESS PANEL

RIGHT-HAND DRAIN

ACCESS PANEL

LEVELING

STRINGER

FRAMING AND INSTALLATION

THE VARIETY OF INSTALLATIONS POSSIBLE FOR THIS BATH MAY REQUIRE FRAMING PROCEDURES OTHER THAN THOSE

SHOWN.

LOCATE STUDS AS REQUIRED. INSURE ROUGH DIMENSIONS ARE PROPER, PLUMB AND SQUARE. FOR WHIRLPOOLS,

PROVISION MUST BE MADE IN ALL INSTALLATIONS FOR AN ACCESS OPENING FOR SERVICING PUMP AND

CONTROLS.

THE FOLLOWING PROCEDURE MUST BE USED FOR ALL INSTALLATIONS: STRINGER OR PIER HEIGHT SHOULD BE AS

INDICATED. THIS BATH MUST BE SUPPORTED ALONG IT'S ENTIRE BOTTOM. WE RECOMMEND THE USE OF

MORTAR AS A BEDDING MATERIAL (SAND IS NOT RECOMMENDED). APPLY ENOUGH BEDDING TO SUPPORT THE

COMPLETE BOTTOM OF THE BATH. AFTER THE BEDDING HAS BEEN POURED, AND BEFORE IT SETS, POSITION

WHIRLPOOL OR BATH WITHIN INSTALLATION UNTIL THE RIM IS LEVELED AGAINST THE LEVELING STRINGERS (SEE

"TYPICAL CORNER INSTALLATION") SHOWN BELOW. THE RIM OF THE BATH MUST NOT SUPPORT WEIGHT. ALLOW

THE BEDDING MATERIAL TO COMPLETELY HARDEN BEFORE APPLYING WEIGHT TO THE RIM OR BOTTOM OF THE

BATH. ANY FINISH MATERIAL SUCH AS WALL BOARD OR TILE MUST BE SELF-SUPPORTING IF IT CONTACTS THE

DECK OF THE BATH.

753451-100 Rev. A (2)

SUGGESTED INSTALLATION

METHODS

LEVELING SURFACE

WATERPROOF

SEALANT

SUNKEN OR ISLAND

INSTALLATION RECESSED INSTALLATION

BATH

WATERPROOF

SEALANT

TILE

BEAD

STRIP

LEVELING

STRINGER

BATH

*NOTE: If the optional apron (PN 0730.121) is to be used with this tub, the stringer

height must be referenced from the finished floor.

ELECTRICAL DIAGRAM

READ AND FOLLOW ALL INSTRUCTIONS

BLACK

WHITE

120 VAC

GND.

SEPARATE 15 AMP GFCI

OUTLET

WHIRLPOOL MOUNTED

AIR SWITCH OR

WALL TIMER

ELECTRICAL INSTALLATION

PUMP/MOTOR

ELECTRICAL INSTALLATION INSTRUCTIONS

All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other

applicable codes.

WARNING:

When using electrical products, basic precautions should always be observed, including the following:

1. DANGER: RISK OF ELECTRIC SHOCK

Connect only to a circuit protected by a ground-fault circuit interrupter.

2. Grounding is required. The unit should be installed by a licensed electrician and grounded.

3. Install to permit access for servicing.

4. All building materials and wiring should be routed away from the pump body and heater (if equipped).

The whirlpool should be installed on a 120 vac, 15 amp dedicated circuit. The circuit should be hard-wired from the

electrical power supply panel. The circuit must be a three (3) wire circuit from the electrical supply panel. A grounded

neutral wire and a third wire, earth ground, are essential.

753451-100 Rev. A (3)

WIRE SELECTION GUIDE

DRAIN CONNECTION AND SYSTEM TEST

Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the

pump couplings and make sure they are hand-tight. Clean the whirlpool and fill with water to a point 2" above the top of

the highest jet. Recheck the pump couplings and make certain that they are not leaking. (Although the pump couplings

are factory tightened and inspected, some loosening may have occured during transit.) Make sure the whirlpool is

connected to the electrical supply and turn the whirlpool on. Check for leaks around all piping connections while the

whirlpool is running.

POST INSTALLATION CLEAN-UP

Remove all construction debris from bath. Tile grout can be removed with a wooden popsicle stick or tongue depressor.

Do not use wire brushes or any other metal implement on bath surface.

Post installation clean-up generally can be completed using warm water and liquid dishwashing detergent. Stubborn dirt or

stains may be removed using granular Spic and Span®mixed with water.

Painter's naphtha can be used to remove excess adhesives and/or wet oil-base paint.

HARSH CHEMICALS SHOULD NEVER BE USED ON ACRYLIC SURFACES.

Abrasive cleaners must not be used since they will scratch and dull the surface. Dulled areas can be restored by rubbing

with a white automotive-type polishing compound and waxing with a liquid wax.

Maximum distance from

fusebox to motor The sizes shown on this

chart are recommendations

for copper conductors

only. Always follow

local and national

electrical codes

Motor

Hi Performance

Rating

50' 100'

120V Power Line

150' 200'

12 12 10 8

753451-100 Rev. A (4) SPIC AND SPAN®IS A REGISTERED TRADEMARK OF PROCTER & GAMBLE

1.1

Tabla de contenidos

Otros manuales de Bañera de American Standard

American Standard

American Standard DXV LYNDON D12536-004 Manual de usuario

American Standard

American Standard Spectra Bathtub 2696.102 Manual de usuario

American Standard

American Standard Princeton 2394 Manual de usuario

American Standard

American Standard Hampton Integral Apron Whirlpool 2425.118W Manual de usuario

American Standard

American Standard Colony 2675.018 Manual de usuario

American Standard

American Standard Virtuoso Whirlpool 7236.028 Manual de usuario

American Standard

American Standard Rondo Elite Whirlpool 7242E Series Manual de usuario

American Standard

American Standard Cambridge 2460.028 Manual de usuario

American Standard

American Standard Princeton 2394.202.ICH Manual de usuario

American Standard

American Standard Lifetime 2645L Manual de usuario

American Standard

American Standard Salem 14 0153.015 Manual de usuario

American Standard

American Standard Ellisse Oval Bathtub 2709.XXXW Manual de usuario

American Standard

American Standard Cadet Whirlpool 2771.018H Manual de usuario

American Standard

American Standard Heritage 2806.018 Manual de usuario

American Standard

American Standard Green Tea 3575.018WC.K2 Manual de usuario

American Standard

American Standard Elevate RHO 2576102 Manual de usuario

American Standard

American Standard Whirlpool/Bathing Pool 2748.XXXW Manual de usuario

American Standard

American Standard 6030ST3 Manual de usuario

American Standard

American Standard Colony 1749.118 Manual de usuario

American Standard

American Standard Evolution 2771V.002 Manual de usuario

American Standard

American Standard Cadet Whirlpool 2771.018 Manual de usuario

American Standard

American Standard Princeton Recess Bath w/ Luxury Ledge and Integral Overflow 2394.202... Manual de usuario

American Standard

American Standard MAINSTREAM 2734 Series Manual de usuario

American Standard

American Standard Mainstream 2948LC-RHO.020 Manual de usuario

Manuales populares de Bañera de otras marcas

Agua

Agua BARTOLI-66 Manual de usuario

PAA

PAA PRELUDE Manual de usuario

BETTE

BETTE SILHOUETTE Manual de usuario

Kohler

Kohler K-820-GC Guía de inicio rápido

Oliveri

Oliveri Naples Manual de usuario

Lyons

Lyons Elite ETLxx663219 Series Manual de usuario

Woodbridge

Woodbridge BJ500 Instrucciones de montaje

Whirlpool

Whirlpool Ariel ARL-702 Manual de usuario

TEIKO

TEIKO EXCELLENT DUO Manual de usuario

Kohler

Kohler K-1111-H2 Guía de inicio rápido

agape

agape MARSIGLIA AVAS1075 Manual de usuario

Kohler

Kohler K-1151 Instrucciones de montaje

Kohler

Kohler K-1158 Guía de inicio rápido

Kohler

Kohler K-1244 Instrucciones de montaje

Kallista

Kallista P50045-G5 Instrucciones de montaje

Kohler

Kohler K-1164-HB Guía de inicio rápido

Kohler

Kohler Hourglass K-1209-LA Guía de inicio rápido

Ariel

Ariel AM Series Manual de usuario