Remarks:
* means optional and supplied with certain models only.
2Safety and Compliance information
2.1 Installation
Use a power adapter or a PoE device that meets requirements. Otherwise, the device may be damaged.
Make sure the length of the power cable between the power adapter and the camera is not too long, otherwise the voltage of
the camera is lowered, causing the camera to work abnormally. If it is required to lengthen the power cable, lengthen the cable
between the power adapter and the mains.
Do not hold the tail cable by hand for weight bearing. Otherwise, the cable connector of the camera could be loosened.
When connecting to an external interface, use an existing connection terminal, and ensure that the cable terminal (latch or
clamp) is in good condition and properly fastened. Ensure that the cable is not tense during mounting, with a proper margin
reserved to avoid poor port contact or loosening caused by shock or shake.
During the process of transportation, special attention is required for the protection of the transparent dome cover to prevent
friction, scratch and contamination, etc. In order to keep the cover clean, do not remove the protective film on the cover during
mounting. After mounting is finished, remove the film before the device is powered on.
2.2 Maintenance
Caution: There will be risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the
instructions.
If there is dust on the front glass surface, remove the dust gently using an oil-free brush or a rubber dust blowing ball.
If there is grease or a dust stain on the front glass surface, clean the glass surface gently from the center outward using lens
cleaning cloth. If the grease or the stain still cannot be removed, use lens cleaning cloth dipped with detergent and clean the
glass surface gently until it is removed.
Do not use organic solvents, such as benzene or ethanol when cleaning the transparent dome cover.
2.3 Laser Safety (if applicable)
Installation and maintenance must be carried out by trained and qualified personnel.
The camera must be mounted at least 6 meters above the ground.
To avoid the risk of fire, the laser illuminator must be clear of obstacles within a minimum range of 30 centimeters.
Make sure laser is disconnected from power before examination.
Never stare into beam or view through any optical instruments. Avoid exposure to direct or scattered radiation. Be especially
cautious during installation and maintenance.
