ZKTeco VF Series Manual de usuario

VF Series

Version: 1.0

Date: March, 2018

QUICK START GUIDE

VF Series

Version: 1.0

Date: March, 2018

VF Series Quick Start Guide

Version: 1.0

1. Overview

Take VF300/380 as an example:

USB Port

Left side view

Touch Screen

Front view

Indicator

Camera & Card Read Area

Reset Button

Lock Button Sensor Aux-in

COM

BUT

GND

SEN

AUX

12V

GND

COM

Alarm

+12V Out

TCP/IP

Power

Tamper Alarm Switch

Rear view

Speaker

2. Installation Environment

Recommended location:

The device can be installed in indoor and outdoor places. Direct sunlight shall

be avoided if the device is installed in outdoor places. Install the device

indoors at least 10 feet (3m) away from windows, and 6.5 feet (2m) away from

light fixtures.

Not recommended locations:

Direct sunlight Direct sunlight Indirect sunlight Too close to

outdoors through window through window light fixtures

3. Installation Steps

Step1:

Affix the paper template to the wall and drill three

holes within the three marked circles on the paper

template.

We recommend affixing the template about 3.6 feet

(1.1m) above the ground, assuming the average

height of your users is 5-6 feet tall (1.55m-1.85m).

The installation height 4 feet (1.2m) is applicable for

the body height over 5.4 feet (1.65m).

①②③④

Step2:

Align the wall mounted base to the holes on the wall, and use three screws to

fix it onto the wall (figure①); align the iron board to the holes on the wall

mounted base, and use four screws to fix it onto the wall mounted base

(figure②); connect the device with the iron board (from the top down), to

ensure it is tightly jointed with the board (figure③); finally use one screw to fix

the device and the iron board (figure④).

4. Cautions

Recommended standing position:

1) Recommended:

2) Several wrong ways:

For users 5-6 feet tall (1.55m-1.85m) we

recommend users stand about 2 feet (0.5m) from

the wall.

When viewing your image on the device display

window, step away if your image appears too

bright. Step closer if your image appears too dark.

When enrolling users and then

subsequently verifying those users, it’s

important those users consistently stand

(or sit) at the same distance and angle

from the device.

Different posture Different height

Too close Too far

Enrollment and verification:

During the enrollment, follow the voice prompts by

focusing eyes inside the green box. The user needs to move the face up or

down during face registration. The pose for registration is shown in the figure

above.

During the verification, position your head such that

your face appears in the center of the device display

window. Focus your face inside the green box.

5. Troubleshooting

The face cannot be recognized by the device in veriﬁcation.

Solutions:

1) Check if your facial expression, standing posture and distance during

veriﬁcation are the same with that in enrollment.

2) Check if the device is under direct sunlight or near the windows.

Veriﬁcation fails as user wears glasses during veriﬁcation but not in face

enrollment.

Solution: You can enroll your face wearing glasses in the ﬁrst or second time of

face capturing, since the device supports 3 times of capturing face templates.

The device makes a misjudgment in veriﬁcation.

Solution: There is a certain probability of misjudgment. You can re-enroll your

face.

Otros manuales para VF Series

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Controladores de acceso IP de ZKTeco

ZKTeco

ZKTeco RevFace15 Manual de usuario

ZKTeco

ZKTeco Ultima Series Manual de usuario

ZKTeco

ZKTeco White LCD Series Manual de usuario

ZKTeco

ZKTeco C3 Manual de usuario

ZKTeco

ZKTeco MiniAC Plus Manual de usuario

ZKTeco

ZKTeco SpeedFace-V5L Manual de usuario

ZKTeco

ZKTeco G4 Manual de usuario

ZKTeco

ZKTeco Ultima Series Manual de usuario

ZKTeco

ZKTeco SpeedFace-V3L Manual de usuario

ZKTeco

ZKTeco ProFace X Series Manual de usuario

ZKTeco

ZKTeco KF1000 Series Manual de usuario

ZKTeco

ZKTeco FA50 Manual de usuario

ZKTeco

ZKTeco Horus Manual de usuario

ZKTeco

ZKTeco F18 Manual de usuario

ZKTeco

ZKTeco KF1000-U Manual de usuario

ZKTeco

ZKTeco F18 Manual de usuario

ZKTeco

ZKTeco SilkID F21-ID Manual de usuario

ZKTeco

ZKTeco TF1600 ZKTeco Manual de usuario

ZKTeco

ZKTeco ProCapture-T Manual de usuario

ZKTeco

ZKTeco SpeedFace-VSL Series Manual de usuario

ZKTeco

ZKTeco LF10 Manual de usuario

ZKTeco

ZKTeco F18 Manual de usuario

ZKTeco

ZKTeco SCR-100 Plus Manual de usuario

ZKTeco

ZKTeco F19 Manual de usuario

Manuales populares de Controladores de acceso IP de otras marcas

Jantar

Jantar REX A-1-9 Manual de usuario

2N Access Unit Hoja de instrucciones

Kedacom

Kedacom KSCA120 Series Manual de usuario

H3C

H3C WX2880X Manual de usuario

G4S

G4S S870-EX Guía

PRASTEL

PRASTEL M2000PE Manual de usuario

Allegion

Allegion interflex IF-281 Cylinder Manual de usuario

TECOM

TECOM TS1067E Manual de usuario

Fermax

Fermax Memokey 100C Guía del usuario

Fermax

Fermax CITYLINE MEMOKEY Manual de instrucciones

Software House

Software House iSTAR Pro 2U RM Manual de instrucciones

AKCP

AKCP SP+ Manual de usuario

Bpt

Bpt HNA/102 Manual de usuario

Civintec

Civintec CV9601T-T-1F Manual de usuario

BioMax

BioMax N-X90W Manual de usuario

FingerTec

FingerTec s-Kadex Manual de usuario

H3C

H3C WX5002ACCESSCONTROLLER Manual de usuario

C Prox Ltd

C Prox Ltd DPN-2 Manual de usuario