Waring CB15 SERIES Manual de usuario

1 GALLON BLENDERS WITH SPIGOT

LICUADORAS DE 4 L CON GRIFO

MÉLANGEURS DE 4 L AVEC ROBINET

120V

For your safety and continued enjoyment of this product,

always read the instruction book carefully before using.

Para su seguridad y para disfrutar plenamente de este producto,

siempre lea las instrucciones cuidadosamente antes de usarlo.

Aﬁn que votre appareil vous procure en toute sécurité beaucoup de satisfaction,

lire attentivement le mode d’emploi avant de l’utiliser.

CB15 SERIES

SERIE CB15

SÉRIE CB15

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions

should always be taken, including the following:

1. READ ALL INSTRUCTIONS.

2. Unplug from outlet when not in use, before putting

on or taking off parts, and before cleaning.

3. To protect against electrical hazards, do not immerse

the blender base in water or other liquids.

4. Avoid contact with moving parts.

5. Do not operate any appliance with a damaged cord or

plug, or after the appliance malfunctions or is dropped

or damaged in any manner. Return appliance to the

nearest authorized service facility for examination, repair

or electrical or mechanical adjustment.

6. The use of attachments, including canning jars, not

recommended by the appliance manufacturer may

cause hazards.

7. Do not use outdoors.

8. Do not let cord hang over edge of table or counter, or

touch hot surfaces.

9. Keep hands and utensils out of container while blending

to prevent the possibility of severe personal injury and/or

damage to the blender. A rubber scraper may be used

but must be used only when the blender is not running.

10. Blades are sharp. Handle carefully.

11. Always operate blender with cover in place.

12. When blending hot liquids, completely remove the

stopper in the cover before turning on the blender.

See Hot Blending Instructions, page 12.

13. This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge.

14. Children should be supervised to ensure that they do not

play with the appliance.

15. DO NOT use carbonated liquids in the blender jar or

any blending container. Using carbonated liquids in the

included blender jar or any other compatible blender jar

may result in injury.

16. DO NOT blend oil or oil-based products such as peanut

butter for greater than 5 minutes.

17. Never remove blender jar from base unit until the blade

and coupling have completely stopped.

18. Spigot assembly must be handwashed only. Do not run

the spigot through the dishwasher.

19. The contents of the blender cannot reach beyond 140˚F

when operating with a spigot. Note that when blending

the temperature of the contents will increase due to the

friction of the blade.

SAVE THESE INSTRUCTIONS

SPECIFICATIONS

• Capacity: 4 Litre Working Capacity

• Rating: 120 Volts–60HZ–Single Phase AC –15.0 Amps.

(U.S. models only)

• Base: Die-cast – grey coating

• Container: Stainless steel with stainless steel blades –

rubber clamp-on lid

• Bearing: High-performance ball bearing

• Cord: 7 foot (2.44 m) – 3-conductor ground cord with

strain relief in base

• Overall Height: 26 inches (66 cm)

• Weight: 38 pounds (17.2 kg) net

Shipping Weight 41 pounds (18.6 kg)

• cETLus, NSF, Listed

• Operating Cycle: 3 min ON/1 min OFF

120V GROUNDING INSTRUCTIONS

For your protection, this appliance is equipped with a

3-conductor cordset.

120-volt units are supplied with a molded 3-prong

grounding-type plug (NEMA 5-15P) and should be used

in combination with a properly connected grounding type

outlet as shown in Figure 1.

If a grounding type outlet is not available, an adapter, shown

in Figure 2, may be utilized to enable a 2-slot wall outlet to

be used with a 3-prong plug. (Note: Use of an adapter is

not permitted in Canada and Europe.)

Referring to Figure 3, the adapter must be grounded by

attaching its grounding lug under the screw of the outlet

cover plate.

Caution: Before using an adapter, it must be determined

that the outlet cover plate screw is properly grounded. If in

doubt, consult a licensed electrician. Never use an adapter

unless you are sure it is properly grounded.

Green/Yellow: Earth Ground • Blue: Neutral • Brown: Live

Note: User-installed cordset plugs are not permitted

in Europe.

SPIGOT ASSEMBLY (FOR SF MODELS ONLY)

Your spigot assembly includes the main spigot housing,

O-ring and rubber insert.

1. Plastic Feed Cap

2. Vinyl Lid

3. Metal Clamps

4. Spigot Adapter

5. O-ring

6. Spigot housing

7. Lever

8. Rubber Insert

SPIGOT ASSEMBLY (FOR SF MODELS ONLY)

Your spigot assembly includes the main spigot housing,

O-ring and rubber insert.

The O-ring comes assembled

in the jar spigot adapter but

can be removed for cleaning.

Always make sure the O-ring

is positioned securely in the

adapter on the jar before

inserting and operating the

spigot function. Figure 1.

The rubber insert has two loops

on the inside to t the lever

(refer to gure 2). The lever only

needs to be positioned into the

bottom loop. In the event that

one loop breaks, you can ip

the insert upside down and use

the other loop.

To assemble the rubber insert

pinch both sides as seen in

gure 3 and position the insert

inside the housing so that the

lever slides inside the rubber

insert and the bottom loop (for

the lever) is near the spigot

hole. Be sure that the bottom

of the rubber insert is ush

with the bottom of the spigot

housing.

Push the bottom of the lever

through the bottom loop of the

rubber insert.

g. 1

g. 2

g. 3

g. 4

Once assembled, insert the

spigot into the adapter on the

jar and rotate clockwise until

the spigot completely stops

as shown in gure 5.

CB15/CB15SF OPERATION

1. Before starting, make sure that the blender cord is

unplugged.

2. Position container assembly on

motor base so that it is rmly

seated and not tilting to one side.

Plug blender cord into outlet.

3. Put ingredients into container.

Always add liquid ingredients rst, unless otherwise

specied in recipe. Do not ll above MAX line.

Place cover securely on container and fasten the

cover clamps.

4. Press the STANDBY button to turn on the blender.

Green LED will illuminate. For continuous operation,

press either the LOW, MED, or HIGH button. When

nished blending, press STOP. For momentary

operation, press the PULSE button; motor will run

on HIGH speed until the button is released.

Note: Your CB15 utilizes a Slow Start™ feature.

When pressing MED or HIGH, the unit will start in the

LOW position for 1 second and then switch to the

setting selected. This allows for a more even blending

of ingredients in container.

5. Always hold container with one hand when starting

and while blending. Never operate without jar lid

properly clamped in place.

g. 5

6. Allow motor to come to a complete stop before

removing container. Never place the container on the

motor base or remove it from the motor base while

the motor is running.

7. Press the STANDBY button again to turn off the

blender.

8. Remove the container from the motor base and

empty the contents.

9. Wash and dry container after each use, according to

Cleaning and Sanitizing Instructions, page 13.

10. Not for waterjet cleaning.

11. The use of ear protection is recommended during

extended operating periods.

Spigot Instructions

When pouring jar contents through the spigot, simply

push the lever toward the blender jar. If contents are

too thick, it can be difcult to pour through the spigot.

Running the blender on LOW while pouring can help

the ow. Make sure to always have the lid positioned on

the blender with the clamps locked when running the

blender.

CB15T/CB15SF OPERATION

1. Before starting, make sure that the blender cord is

unplugged.

2. Position container assembly

on motor base so that it is

rmly seated and not tilting

to one side. Plug blender cord

into outlet.

3. Put ingredients into container. Always add liquid

ingredients rst, unless otherwise specied in recipe.

Do not ll above MAX line. Place cover securely on

container and fasten the cover clamps.

4. Press the STANDBY button to turn on the blender.

Press the UP arrow or DOWN arrow. The initial time

will be 10 seconds.

5. Push the UP arrow to set the time required. The timer

will advance only in 10-second intervals. Timer can be

set to the maximum of 3 minutes.

6. Select and press a speed button; the blender will

start and run for that selected time. It will count

down in 1-second intervals and stop at 0. NOTE: If

you want to increase or decrease time while timer is

counting down, press UP or DOWN arrows. Timer will

increase or decrease in 10-second intervals. After

5 seconds the timer will turn off and return to manual

mode.

7. When using the timer again, the initial time will be the

last time set. NOTE: If unit has been unplugged, the

timer will default back to 10 seconds.

8. Always hold container with one hand when starting

and while blending. Never operate without container

lid properly clamped in place.

9. Allow motor to come to a complete stop before

removing container. Never place the container on the

motor base or remove it from the motor base while

the motor is running.

7. Press the STANDBY button again to turn off the

blender.

8. Remove the container from the motor base and

empty the contents.

9. Wash and dry container after each use, according to

Cleaning and Sanitizing Instructions, page 13.

10. Not for waterjet cleaning.

11. The use of ear protection is recommended during

extended operating periods.

Spigot Instructions

When pouring jar contents through the spigot, simply

push the lever toward the blender jar. If contents are

too thick, it can be difcult to pour through the spigot.

Running the blender on LOW while pouring can help

the ow. Make sure to always have the lid positioned on

the blender with the clamps locked when running the

blender.

CB15V/CB15SF OPERATION

1. Before starting, make sure that the blender cord is

unplugged.

2. Position container assembly

on motor base so that it is

rmly seated and not tilting

to one side. Plug blender cord

into outlet.

3. Put ingredients into container. Always add liquid

ingredients rst, unless otherwise specied in recipe.

Do not ll above MAX line. Place cover securely on

container and fasten the cover clamps.

4. Press the green STANDBY button to turn on the

blender. Green LED will illuminate and remain steady.

Select the desired speed with the variable speed

control knob. Press the red START/STOP button to

begin blending. You may change the speed with the

variable speed control knob anytime during blending.

When nished blending, press START/STOP button.

Otros manuales para CB15 SERIES

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Licuadora de Waring

Waring

Waring BIG STIX WSB50 Manual de usuario

Waring

Waring BIG STIX WSB50 Manual de usuario

Waring

Waring MBB1000 Series Manual de usuario

Waring

Waring MX1200XTX Manual de usuario

Waring

Waring BB300 Manual de usuario

Waring

Waring HGB140 Manual de usuario

Waring

Waring WPB Manual de usuario

Waring

Waring MBB Manual de usuario

Waring

Waring BB320 Manual de usuario

Waring

Waring CB15V Manual de usuario

Waring

Waring MMB Series Manual de usuario

Waring

Waring Mx series Manual de usuario

Waring

Waring HPB305 Manual de usuario

Waring

Waring Ellipse Manual de usuario

Waring

Waring WSB40 Manual de usuario

Waring

Waring 4 Litre Blender Manual de usuario

Waring

Waring TBB160 Manual de usuario

Waring

Waring NuBlend BB180PK Manual de usuario

Waring

Waring PRO MX1000R Manual de usuario

Waring

Waring PRO MEGAMIX HPB300 Manual de usuario

Waring

Waring PRO MX1000R Manual de usuario

Waring

Waring Blender Manual de usuario

Waring

Waring Xtreme MX1300XTX Manual de usuario

Waring

Waring BOLT WSB38X Manual de usuario

Manuales populares de Licuadora de otras marcas

ROTOR

ROTOR 1125.201 Manual de usuario

Braun

Braun Multiquick 5 Vario series Manual de usuario

ARENDO

ARENDO MIRA 305424 Manual de usuario

CHEF-BUILT

CHEF-BUILT CCB-3500 Manual de usuario

Viconte

Viconte VC-4406 Manual de usuario

Oster

Oster BLSTAB-CB0 Manual de usuario

HOFFEN

HOFFEN MC-3005 Manual de usuario

Black & Decker

Black & Decker BLC18750DM Manual de usuario

Sunbeam

Sunbeam 4182 Manual de usuario

Bialetti

Bialetti FMX35 Manual de usuario

Black & Decker

Black & Decker BL8000 Manual de usuario

Duronic

Duronic BL530 Manual de usuario

Exquisit

Exquisit MS 3002 wes Manual de usuario

Lumme

Lumme LU-KP1891A Manual de usuario

Binatone

Binatone HB-735 Manual de usuario

Moulinex

Moulinex LM936E10 Manual de usuario

Oster

Oster VERSA Manual de instalación y operación

Ninja

Ninja NN210Q Manual de usuario