Volt VPL-370 Series Manual de usuario

VOLT®Low Voltage Landscape Lighting

VOLT® Pagoda Path Light

VPL- 370 Series

INSTALLATION INSTRUCTIONS

Specications and product details subject to change without notice.

[email protected] • 813.978.3700

Help Hotline:

1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)

- 1 -

VOLT®Pagoda Path Light

VPL- 370 Series

INSTALLATION INSTRUCTIONS

www.voltlighting.com

Important: Please Read Before Installation

IMPORTANT SAFETY INSTRUCTIONS

This luminaire is intended for installation in accordance with local codes

and the National Electric Code (NEC). Failure to adhere to these codes and

instructions may result in serious injury, property damage and void the

warranty.

These instructions do not intend to cover all variations in installation,

operation maintenance or mounting situations.

1. Make sure that the power is turned OFF before installing or servicing this

luminaire.

2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or

more from pool, spa or fountain.

3. This luminaire is intended to be used only with a power supply

(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.

4. Wiring connections must be made with UL listed wire connectors that are

suitable for outdoor use.

5. Position the low voltage wire and wire connector so that it is located

within 6 inches (15.2 cm) from a building structure, a luminaire or tting.

6. The main low voltage cable is intended for shallow burial - less than 6

inches (152 mm).

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS

Lighted lamp is HOT!

WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.

1. Turn off/unplug and allow to cool before replacing lamp.

2. Lamp gets HOT quickly! Contact only switch/plug when turning on.

3. Do not touch the hot lens, guard or enclosure.

4. Keep lamp away from materials that may burn.

5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may

damage lamp.

6. Do not operate the luminaire tting with a missing or damaged shield.

SAVE THESE INSTRUCTIONS

- 2 -

Package Contents

Product Dimensions

A. (1) Pagoda Hat C. (1) Stake

B. (1) 6” Stem

[email protected] • 813.978.3700

4.25”

11.5”

4.75”

Install Stake

Board

Stake

Soil

Ground

Determine the desired location for mounting

the luminaire. Hammer the stake into the

ground until ange of stake is ush to grade.

To avoid damage to the stake, place a board on

top of the stake while hammering.

NOTE: If the ground is hard and the stake

is difcult to install, make a crosscut in the

ground using a at shovel.

Parts Required (sold separately)

- 3 -

A. (1) Bulb

VOLT®Pagoda Path Light

VPL-370 Series

Install Stem to Stake

Wire Connection

6” Stem

Socket

Stake

Pigtail

Wireway Slot

Pigtail

Main Supply Cable

Wire Connectors

Clear away an area in the ground at

the wireway slot on top of the stake.

Lay the luminaire pigtail into the

wireway slot and screw the stem onto

the stake. If the xture does not look

straight, adjust by pushing or pulling

on the stake only.

Strip both leads from the luminaire pigtail. Using two wire connectors

(sold separately), connect the leads from the luminaire to the main low

voltage supply cable leads.

- 4 -

INSTALLATION INSTRUCTIONS

[email protected] • 813.978.3700

- 5 -

Install/Replace Bulb

Install Bulb

Install Pagoda

Place the pagoda hat over the bulb

and thread onto the top end of the

stem. Hand tighten until snug.

Socket

Pagoda

Bulb

Stem

Insert the bulb with the correct wattage

and type marked on the luminaire label.

CAUTION: Do not exceed maximum

wattage marked on luminaire label.

NOTE: DO NOT touch bulb with bare

hands. Use soft cloth to handle bulb.

Please reverse Step 5 - Step 4 to expose the bulb and replace it with the

correct wattage and type marked on the luminaire label. Reinstall inner

lens and shade.

IMPORTANT: Bi-Pins must be protected from moisture and dust at all times.

Always reinstall shade and lens when moved.

VOLT®Pagoda Path Light

VPL- 370 Series

Replace Lens

Remove Pagoda

Loosen the pagoda hat and remove it

from the top end of the stem by pulling

it up and over the bulb.

Loosen the screws from the bottom of

the pagoda. Remove the bottom tier

to expose the lens and replace it with

the new replacement shade. Reinstall

the bottom tier to hold the shade and

secure it with the screws removed

previously. Tighten until snug.

Reinstall the pagoda onto the stem.

Stem

Bottom Tier

Screw

Pagoda

Lens

Replace Lens

- 6 -

INSTALLATION INSTRUCTIONS

- 7 -

is-VPL-370-ver5.pdf

Specications and product details subject to change without notice.

[email protected] • 813.978.3700

www.voltlighting.com

Help Hotline:

1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)

- 8 -

Tabla de contenidos

Otros manuales de Iluminación de paisajes de Volt

Volt

Volt VPL-3024-BBZ Manual de usuario

Volt

Volt VUL-6802-25-BBZ Manual de usuario

Volt

Volt VHS-67 Series Manual de usuario

Volt

Volt 390 Series Manual de usuario

Volt

Volt VAL-1811-40-BBZ Manual de usuario

Volt

Volt VWL-705-BBZ Manual de usuario

Volt

Volt Guardsman VPL-1011 Manual de usuario

Volt

Volt VSPL-1047-BBZ Manual de usuario

Volt

Volt VFL-4601-4-BBZ Manual de usuario

Volt

Volt VAC-STK-PWR-PGR Manual de usuario

Volt

Volt VPL-1024 Manual de usuario

Volt

Volt VWL-55 Series Instrucciones de funcionamiento y seguridad

Volt

Volt VAL-2015-BBZ Manual de usuario

Volt

Volt VAL-2001 Series Manual de usuario

Volt

Volt RGBW Max All-Star VAL-2045-ABK Manual de usuario

Volt

Volt BRASS BULLY VWL-5 Series Manual de usuario

Volt

Volt VAL-2103-0-BBZ Manual de usuario

Volt

Volt All-Star Brass Tommy Light Manual de usuario

Volt

Volt VPL-1044-4-BBZ Manual de usuario

Volt

Volt VFL-450X-BBZ Manual de usuario

Volt

Volt LED Top Dog Tommy Light Manual de usuario

Volt

Volt VPL-1041-4-BBZ Manual de usuario

Volt

Volt VFL-4007-4-BBZ Manual de usuario

Volt

Volt VAL-2010-BBZ Manual de usuario

Manuales populares de Iluminación de paisajes de otras marcas

Intex

Intex SL1006 Manual de usuario

LED Group

LED Group ROBUS R2IN13W Manual de usuario

Patriot Lighting

Patriot Lighting 343-1484 Manual de usuario

Hess

Hess SERA G: SERA S Manual de usuario

LIGMAN

LIGMAN JET 44 Manual de usuario

LIGMAN

LIGMAN MALTA 1 Manual de usuario

Cooper Lighting

Cooper Lighting MCGRAW-EDISON WBG Manual de usuario

Cooper Lighting

Cooper Lighting Invue 42 - 175W Manual de usuario

Saxby Lighting

Saxby Lighting Islay 68784 Manual

LIGMAN

LIGMAN EU-10016-3 Manual de usuario

Cooper Lighting

Cooper Lighting McGraw-Edison ZD Credenza Manual de usuario

LIGMAN

LIGMAN KI-60475 Manual de usuario

Cooper Lighting

Cooper Lighting Generation CLB25MWW5C373 Manual de usuario

Malibu Boats

Malibu Boats CL905K Manual de usuario

LIGMAN

LIGMAN NYB-30161 Manual de usuario

LIGMAN

LIGMAN SI-80021 Manual de usuario

Malibu Boats

Malibu Boats CM110P Manual de usuario

U.S.T.E.

U.S.T.E. VISTA 8202 Manual de usuario