Vello BG-S3-2 Manual de usuario
USER’S MANUAL
BG-S3-2
BAT TERY GRIP
Designed for the
Sony Alpha a7 II Series
Mirrorless Cameras
Introduction
The Vello BG-S3-2 battery grip offers extended shooting
time and comfort when shooting in a vertical (portrait)
orientation. The grip is compatible with the Sony Alpha
a7 II series mirrorless cameras and accepts up to two Sony
NP-FW50 rechargeable batteries. It offers an alternate
shutter release button, AF/MF/AEL button, three custom
buttons, and front and rear dials, making the grip ideal for
shooting portrait photography. There is also a convenient
control-lock switch to prevent unwanted triggering of the
grip’s controls. And for connectivity, there is a mount on
the bottom for standard tripods, and a mount on the top
for hand straps.
Please read through this entire
manual before using the BG-S3-2
battery grip.
2
Precautions
1.
The BG-S3-2 should be used only with compatible
devices specified in this manual.
2.
Use only with the batteries and battery holders
recommended in this manual.
3.
If you notice smoke, noise, or an unusual smell from
the battery pack, discontinue use immediately. Remove
the batteries, and take the device to a Vello authorized
reseller.
4.
The battery level may not display properly if batteries
are installed before mounting the grip.
5. Remove batteries from the grip when not in use.
6. Do not attempt to disassemble.
7.
Avoid exposing this product to water or extreme
humidity, and keep it in a cool, dry place.
8. Keep out of reach of children.
9. All images are for illustrative purposes only.
3
OVERVIEW INTRODUCTION
ASSEMBLY
Overview
2
3
25
4
24 22
16
14
15
6
5
23
9
24
18
17
7
26
20
8
10 11 12 13
21
1
19
4
1Camera battery door holder
2Front dial
3Nonslip grip
4Tripod socket
5Battery compartment door
6Battery compartment lock
7Thumbwheel lock
8Battery tray lock
9Battery compartment
10 Mounting screw
11 AF/MF / AEL button
12 C3 custom button/enlarge viewing
13 Control lock switch
14 Hand strap mount
15 Rear dial
16 Shutter release button
17 C1 custom button
18 C2 custom button
19 Electrical contacts
20 Battery tray
21 Battery 1 latch
22 Battery slot 1
23 Slot 1 contacts
24 Slot 2 contacts
25 Battery slot 2
26 Battery 2 latch
5
ASSEMBLY OVERVIEW INTRODUCTION
Attaching the Battery Grip
1.
Ensure that the camera
power is turned off. Open
the camera’s battery door,
and remove the battery.
2.
Remove the camera’s
battery door by pulling the
release latch on the inside of
the door as indicated above.
3.
Store the camera’s battery
door in the BG-S3-2’s
battery door compartment.
Align the door with the
compartment’s slot as
indicated, and slide the door
in. Press the door’s release
latch to lock it in place.
6
4.
Swing and lock the door
shut.
5.
Insert the BG-S3-2’s
electrical contacts into the
camera’s battery chamber,
and seat the camera onto
the grip’s mounting screw.
6.
Rotate the thumbwheel
lock until secure.
7
OVERVIEW
ASSEMBLY INTRODUCTION
Inserting the Batteries
1.
Turn the camera power off.
Rotate the grip’s battery
compartment lock to Open,
and open the door.
2.
Press the battery tray
latch to the left to release
the battery tray. Pull the
tray out of the battery
compartment.
3.
Align your battery’s
contacts with either battery
tray slot 1 or 2, and insert
the battery. Make sure the
battery is secure. Insert
batteries into one or both
slots
8
4.
Slide the battery tray
into the grip’s battery
compartment, close the
door, and rotate the battery
compartment lock to Close.
5.
Turn on the camera’s
power, and make sure the
grip’s control lock switch is
set to On.
Note: When removing the grip,
turn off the camera power and
remove the batteries.
9
OVERVIEW
ASSEMBLY INTRODUCTION
Power source Up to two NP-FW50 rechargeable Li-ion batteries
Operating temperature 32°F to 104°F (0°C to 40°C)
Dimensions (H × W × D) 4 × 5 × 2.5 in. (10.2 × 12.7 × 6.4 cm)
Weight 6.1 oz. (173 g) without batteries
Specifications
When two batteries are installed in the BG-S3-2, your camera will automatically select the battery with less power
remaining. The battery level will appear on your camera’s LCD, with the battery level percentage for only the battery
in use. When the battery is depleted, your camera will switch to the other battery in the grip.
Battery Status
10
Tabla de contenidos
Otros manuales de Accesorios para cámaras de Vello
Vello
Vello FreeWave Viewer Manual de usuario
Vello
Vello BG-C6 Manual de usuario
Vello
Vello BG-N4.2 Manual de usuario
Vello
Vello BG-S3 Manual de usuario
Vello
Vello IR Remote Mini Manual de usuario
Vello
Vello shutterboss Manual de usuario
Vello
Vello Off-Camera TTL Flash Cord Manual de usuario
Vello
Vello BG-N18 Manual de usuario
Vello
Vello BG-P1 Manual de usuario
Vello
Vello Freewave micro Manual de usuario
Vello
Vello BG-S5 Manual de usuario
Vello
Vello BG-C10-2 Manual de usuario
Vello
Vello LAE-CM-CEF Manual de usuario
Vello
Vello LAG-MFT-NF Manual de usuario
Vello
Vello LAE-MFT-CEFA Manual de usuario
Vello
Vello BG-N11 Manual de usuario
Vello
Vello BG-S4-2 Manual de usuario
Vello
Vello BG-C1 Manual de usuario
Vello
Vello LAE-MFT-CEFII Manual de usuario
Vello
Vello BG-N15-2 Manual de usuario
