Uniz SLASH Manual de usuario
GETTING STARTED
SLASH 3D printer quick start guide
UNIZ PRINTING SYSTEM
A. SLASH 3D Printer
B. Power Cord
C. USB Cable
D. Extra Resin Bottle(s)
E. Clean Bottle
PRODUCT DESCRIPTION
ACTION BUTTON COLOR GUIDE
UNPACK YOUR SYSTEM
SET-UP YOUR PRINTER
Put SLASH on a flat horizontal platform.
LOAD THE RESIN
1. Remove rigid cap.
2. Puncture the rubber cap with the needle and push it all the
way down into the bottle holder.
3. Pull the plug (small) on top to open the vent.
4. Put rigid cap at the opposite side of bottle
Do not remove the rubber cap at any time.
Never fill the resin tray manually; the pump will do this for you.
Beware of the sharp Needle.
LIGHT IT UP
USING THE SOFTWARE
* Please refer to the “Software manual” for more details.
1. Plug in USB cable and connect to your computer.
2. Plug in power cord and turn on.
1. Double click the icon on the desktop of computer. (Please
keep USB connection at this time)
a. Click the “SLICE” button;
b. Click the sliding bar on the right to choose slicing parameter;
c. Define parameters of different zones;
d. Start slicing (check the box to skip verify process).
e. It will start to print when slice finished if you pitch on this.
2. Load a model (*.stl).
3. Start slicing.
a. When slicing is finished, click “print”to send data to SLASH and
start to print.
POST PRINT
4. Print.
1. Clean the bottom of Building Platform (Wipe off any uncured
resin).
2. Rotate the lock arm.
3. Take it off.
ENJOY!
4. Shovel the model off from Building Platform with a scrapper.
Watch out for the scrapper, and don’t hurt your hand!
Otros manuales para SLASH
1
Tabla de contenidos
Otros manuales de Impresora 3D de Uniz
