1
BEFORE INSTALLATION
Parts
Check that the following parts are included in the packaging:
32
1
4
6
13
12
9
15
16 17
5
7
10
11
8
14
!
"#$%&&'
"("()*"+,-
%
#.-),-
,
,
,"
,/
0(1"$#2,"3,"
4-)5)66,-
'7358,-)
Contact your dealer if anything is missing.
Installation requirements
For detailed instructions concerning sauna construction/ventila-
tion etc., go to: http://www.tylö.se/byggabastu and download this
document: "Building a sauna.pdf".
To ensure safe use of the heater, check that the following criteria
are met:
• The sauna cabin should meet the requirements for
and according to: "Building a sauna.pdf".
• The sauna cabin should meet the requirements for
and according to: "Building a sauna.pdf".
• Cable (EKK) or electrical ducting for connecting the heater
must be run on the outside of the heat insulation.
• Cable installation must be correctly performed (see The sec-
tion called Connection/wiring diagram, Page 8).
• Fuse size (A) and power cable size (mm²) must be suitable
for the heater (see The section called Connection/wiring dia-
gram, Page 8).
• The sauna ventilation must comply with the instructions in this
manual (see The section called Positioning the inlet vent,
Page 3, The section called Positioning the outlet vent,
Page 4).
• The position of the sauna heater, control panel and sensors
must comply with the instructions in this manual.
• The heater output (kW) must be suitable for the sauna volume
(m³) (see Page 1). The minimum and maximum
volumes must not be exceeded.
1
*9:
:-*";"<
.*
=.
Output kW Sauna volume min./max. m³
6,6 4-8
8 6-12
!"#$%&'&()%(('%'*(+',('%%
&%-('(*.''-%+%,-/%'(+',%
0,1%&(%&&2,(%&,
!"#$%,00&%(%,('%'0(*,%&%
&%+',0,1
!"#3,'0(*.'%2(,%(*&%
,&*,&*+'-+,('-(&&%+',0
,1
!"#**(2,(&'%%&(-/4
0-&(&%&&'-%('(*++&
('%,
