Tenda 4G180 Manual de usuario
Quick Installation Guide
4G LTE Mobile Wi-Fi
4G180
Package contents
• Mobile Wi-Fi × 1 • Li-ion Battery × 1 • SIM Card Adapter × 1
• USB Cable × 1 • User Manual × 1
Please read this guide before you start with the quick setup upon the first use.
You can see the product name and model on the product label.
This guide instructs how to install and connect the device. For more information
such as the description of symbols displayed on relevant materials, please visit
www.tendacn.com.
Contents
01 / English
09 / Nederlands
15 / Melayu
21 / Русский
27 / Polski
33 / Čeština
39 / Deutsch
45 / Español
51 / Français
57 / Italiano
63 / Română
69 / ไทย
75 / Vietnamese
English
01
LED indicators
StatusLED Description
Solid green
Blinking green
Solid red
Connected to the internet.
Signal detected,but no internet access.
No signal.
Solid green
Blinking green
Solid red
Remaining battery percentage is above 25%.
Charging the battery.
Blinking green
for 5 times
Blinking green
Off
There are unread SMS messages.
No unread SMS messages.
Solid on
Blinking
Off
No device is connected to the Wi-Fi network.
The Wi-Fi network is disabled.
Blinking red Remaining battery percentage is below 20%.
Signal
Battery
Message
Wi-Fi
Remaining battery percentage is between
20% and 25%.
New SMS message is received or the
storage is full.
There is at least one device connected to
the Wi-Fi network,or a WPS negotiation is
in process.
English
02
WPS
Buttons/
Port/Slot
1
2
Reset3
Description
SIM card slot
Power button.
• Hold it for about 3 seconds to turn on/off the
Hotspot.
• Press it once to turn on its LED indicators.
WPS button.
When the WPS function is enabled,the Wi-Fi
LED indicator will blink.
Hold the button down for about 3 seconds to
enable the WPS function.Enable the WPS
function on a WPS-supported device to establish
a WPS negotiation.
Reset button.
Hold the button using a sharp object for about 6
seconds to reset the Hotspot.
SD card slot4
5
Insert your SD card here to increase storage
space.
Insert your SIM card here.
Micro USB
input port
6Used to charge the Hotspot, or to provide wired
device internet access using the USB cable.
No.
Buttons/Ports/Slots
2
1
3
5
4
6
English
03
Install SIM card and battery
❶
4GLTE
Mobile Wi-Fi
❷
SSID: Tenda_xxxxxx
Wi-Fi Key: xxxxxxxx
❸
❹
4GLTE
Mobile Wi-Fi
Open from the lower left
corner
Slide and flip to open, and
then insert a micro SIM (3FF)
card into the slot.
Metal connectors
English
04
Turn on the Hotspot
Solid green
Hold the button till all LED indicators flash once.
When the Hotspot is connected to the internet, you will find:
If the Hotspot is not connected to the internet after a long time, refer to Q1 in FAQ.
Tips
English
05
Access the internet
For the computer connected in a wired manner for the first time, you need to manually
install the CD drive popped up on the computer before you can access the internet.
If you cannot access the internet, refer to Q2 in FAQ.
If you cannot log in to the web UI, refer to Q3 in FAQ.
Tips
•
•
•
To access the internet through the Hotspot:
You can log in to the web UI by visiting 192.168.0.1 to further
configure the Hotspot.
Wireless: Connect your wireless device to the Wi-Fi network of
the Hotspot with the SSID and Wi-Fi key at the top of the
device after opening the back cover.
Wired: Connect a PC or laptop to the Hotspot using the USB
cable.
•
•
SSID: Tenda_XXXXXX
Wi-Fi Key: XXXXXX
SSID: Tenda_xxxxxx
Wi-Fi Key: xxxxxxxx
English
06
Charge your Hotspot
With no battery installed, 4G180 can still be powered on as long as it is connected to a
power supply device (such as a power adapter, laptop or portable charger) with the
USB cable.
If you need to use 4G180 with a power supply device always connected, you can
remove the battery for protection to extend its lifespan.
After the battery is fully charged, you can remove the charger to avoid shorter battery
lifespan caused by overcharge.
Tips
•
•
•
Method 1: Connect to a power socket (5V 1A).
Method 2: Connect to a computer by using the USB cable.
5V 1A
English
07
FAQ
Q2: I cannot access the internet. What should I do?
A2: Try the following solutions:
Ensure that the Hotspot is connected to the internet. If not,
refer to Q1.
Ensure that your wired device is connected to the Hotspot
properly and set to obtain an IP address automatically.
Try with your wireless device closer to the Hotspot.
Ensure that your wireless device is connected to the Wi-Fi
network of the Hotspot.
Ensure that your SIM card is pre-paid and has enough
balance.
Check if your SIM card is locked with a PIN code. If so,
contact your ISP for the PIN code, visit the web UI (default:
192.168.0.1) on a connected device, and follow the
instructions on the web UI to unlock the SIM card.
Try another SIM card.
Q1: The Hotspot is not connected to the internet after a
long time. What should I do?
A1: Try the following solutions:
Reset the Hotspot.
08
Q3: I cannot log in to the web UI. What should I do?
A3: Try the following solutions:
For wired devices: Ensure that the wired device, such as a
computer, obtains an IP address automatically.
Ensure that you entered 192.168.0.1 correctly in the
address bar of a browser.
Try another browser or with another device.
- Ensure that you connect your device to the Wi-Fi network
of the Hotspot.
- Ensure that you have disabled the mobile data (if any) of
your wireless device.
For wireless devices:
If the problem persists, reset the Hotspot and try again.
Start a web browser on a connected device and visit
192.168.0.1 to log in to the web UI.
Change Network Name (SSID) and Wi-Fi Key (or Pass
Phrase) as required.
Find Network Settings and choose Wi-Fi Settings.
Enter the login password (default: admin) and click Login.
Q4: How to change the Wi-Fi name (SSID) and Wi-Fi key?
A4: Follow the steps below:
❶
❷
❸
❹
Q5: How to reset the Hotspot?
A5: Follow the steps below:
Hold the button using a sharp object for about 6 seconds.
Find the Reset hole in the lower part of the Hotspot.
Remove the back cover.
❶
❷
❸
Otros manuales para 4G180
2
Tabla de contenidos
Idiomas:
Otros manuales de Enrutador de red de Tenda
Tenda
Tenda G1005D Manual de usuario
Tenda
Tenda S108 Manual de usuario
Tenda
Tenda O3 Manual de usuario
Tenda
Tenda W268R Manual de usuario
Tenda
Tenda FH305 Manual de usuario
Tenda
Tenda AC9 Manual de usuario
Tenda
Tenda TEG1016D Manual de usuario
Tenda
Tenda RX27 Pro Manual de usuario
Tenda
Tenda teg2124t Manual de usuario
Tenda
Tenda 3G150M Manual de usuario
Tenda
Tenda Nova MW6 Manual de usuario
Tenda
Tenda W303R Manual de usuario
Tenda
Tenda V300 Manual de usuario
Tenda
Tenda S105 Manual de usuario
Tenda
Tenda RX12 Pro Manual de usuario
Tenda
Tenda Nova MW Series Guía de instalación
Tenda
Tenda AC1200 Manual de usuario
Tenda
Tenda W3002R Manual de usuario
Tenda
Tenda AC15 Manual de usuario
Tenda
Tenda PON ONT HG9 Manual de usuario
Manuales populares de Enrutador de red de otras marcas
NETGEAR
NETGEAR FS526T - Switch Manual de usuario
Korenix
Korenix JetNet 5710G Series Manual de usuario
Automated Logic
Automated Logic ZN551 Manual del propietario
Cisco
Cisco ASR 1000 Series Manual del operador
EnGenius
EnGenius ESR-9710 Manual de usuario
Cisco
Cisco 805 Series Instrucciones de funcionamiento y seguridad