Swann SW212-HXD Manual de usuario
1
Advanced security made easy™
SW212-HXD
www.swannsecurity.com
SR212-HXD-10006-040609
Home Outdoor Security Kit
1 Real & 1 Imitation Camera
Quick Start Guide
PNP-150/2D™
plug&playsecurity
222
FCC Verification:
NOTE: This equipment has been tested and found to comply with the limits for
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference in a residen-
tial installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna
· Increase the separation between the equipment and the receiver
· Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected
· Consult the dealer or an experienced radio/TV technician for help
IMPORTANT: Prohibition against eavesdropping.
Except for the operations of law enforcement officers conducted under lawful
authority, no person shall use, either directly or indirectly, a device operated pursu-
ant to the provisions of this Part for the purpose of overhearing or recording the
private conversations of others unless such use is authorized by all of the parties
engaging in the conversation.
WARNING: Modifications not approved by the party responsible for compliance
could void user’s authority to operate the equipment.
IMPORTANT SAFETY INSTRUCTIONS:
· Make sure product is fixed correctly and stable if fastened in place
· Do not operate if wires and terminals are exposed
Before You Begin
2
3
Table of Contents
Package Contents
Before You Begin 2
Table of Contents 3
Package Contents 3
Connection Guide 4-5
Viewing the Camera on Your TV or VCR 6
Tips & Suggestions 6
Troubleshooting Guide 7
Helpdesk / Technical Support Details 8
Warranty Information 8
3
PNP-150 Security Camera
PNP-150 Imitation Camera
Camera Stand x 2
BNC Extension Cable
BNC to RCA Adapter
Power Adapter
Quick Start Guide
Security Stickers
Mounting Hardware
Advancedsecurity made easy™
SW212-HXD
www.swannsecurity.com
SR212-HXD-10006
EN140109
Home Outdoor Security Kit
1 Real & 1 Imitation Camera
Quick Start Guide
PNP-150/2D™
plug&playsecurity
444
INPUT
2A. Connecting Directly to TV 2B. Connecting to Your Existing DVR
Connect the camera
cable to the Extension
Cable
1
Connect the Extension
Cable to the Power
Adapter
3
Connect the BNC to RCA
Adapter and connect to Video
Input on your TV or VCR
2Connect the BNC Extension
Cable to an open channel on
the back of the DVR
2
Plug in the Camera
Power Adapter
4
4
Connection Guide
5
INPUT
2A. Connecting Directly to TV 2B. Connecting to Your Existing DVR
Connect the camera
cable to the Extension
Cable
1
Connect the Extension
Cable to the Power
Adapter
3
Connect the BNC to RCA
Adapter and connect to Video
Input on your TV or VCR
2Connect the BNC Extension
Cable to an open channel on
the back of the DVR
2
Plug in the Camera
Power Adapter
4
5
666
Viewing the Camera on Your TV or VCR
Tips & Suggestions
Viewing the PNP-150 on a TV
After connecting the PNP-150 Camera directly to your TV and powering it on as
described on page 4, tune the TV to the correct input channel.
On your TV’s remote control, the input button is usually labelled as Input, Source,
A/V, Channel 0, AUX etc.*
Viewing and Recording the PNP-150 on a VCR
Connect the PNP-150 into an available input channel on your VCR in the same
manner as the TV connection listed on page 4. Turn on your VCR and TV as if
you were about to play a VCR tape.
On your VCR’s remote control, find the input button with is usually labelled as L1,
L2, Input, Source, A/V, Channel, 0, AUX etc.* Insert a tape and push record to
record the camera.
*Consult the TV or VCR instruction manual for details about changing input
channels
Never aim the camera directly at the sun as it may damage the sensor
Test all connections and ensure the camera is working correctly prior to permanent
installation
Install cameras high enough or out of reach to avoid tampering
Place Security Stickers in a visible location to alert potential thieves they are being
monitored
Mix real cameras with dummy cameras to give the impression of increased security
coverage
Purchase a Swann DVR to record multiple cameras simultaneously and easily moni-
tor your property.
Place cameras in high traffic areas such as doorways to maximise security
Use only the included Power Supply and do not modify or cut wires
6
7
Troubleshooting Guide
Technical Specifications
Problem: I can’t see the camera on my TV.
Solution: Ensure the camera is plugged in and the TV or VCR is tuned to the
correct input channel.
Problem: When I view my camera at night I only see a bright spot and no image.
Solution: Night Vision will reflect when shining through a window. Move the
camera to the other side of the window or another location.
Problem: The BNC Extension Cable will not connect to my TV.
Solution: Connect the BNC to RCA adapter to the end of the Extension Cable
and plug into the TV.
Problem: On my Swann DVR, Video Loss appears where my camera should be.
Solution: Check the Extension cable is securely connected to the camera and
check the connection is secure on the back of the DVR. Also ensure the camera
has power by trying a second power outlet.
7
Video
Image Sensor 1/3” Color Super CMOS
Video Quality 400 TV Lines
Number of Effective Pixels NTSC: 510 x 492 / PAL: 628 x 582
Minimum Illumination 0 Lux (IR on)
Day/Night Mode Color during day / switches to B&W night
White Balance Automatic
Signal / Noise Ratio > 50dB
Electronic Shutter 1/60 - 1/15,000 NTSC / 1/50 - 1/15,000 PAL
Gain Contr=ol Automatic
Backlight Compensation Yes
Lens 6mm
Viewing Angle 53 degrees
Night Vision
Number of Infra-Red LEDs 30
Infra-Red Wavelength 850nm
Night Vision Distance Up to 30ft / 9m
Infra-Red LED Life 10,000 hours
General
Operating Power DC 12V
Operating Temperature -10°C ~ 50°C / 14°F ~ 122°F
Body Construction ABS Plastic
Dimensions - Camera 5.5” x 2.8” x 2.8” / 140mm x 70mm x 70mm
Dimensions – Stand 4.5” x 2.3” x 2.3”/ 120mm x 60mm x 60mm
Weight – Camera & Stand 0.5lbs / 235g
888 © Swann Communications 2009
Advanced security made easy™
Swann Communications warrants this product against defects in workmanship and material
for a period of one (1) year from it’s original purchase date. You must present your receipt
as proof of date of purchase for warranty validation. Any unit which proves defective during
the stated period will be repaired without charge for parts or labour or replaced at the sole
discretion of Swann. The end user is responsible for all freight charges incurred to send the
product to Swann’s repair centres. The end user is responsible for all shipping costs incurred
when shipping from and to any country other than the country of origin.
The warranty does not cover any incidental, accidental or consequential damages arising
from the use of or the inability to use this product. Any costs associated with the fitting or
removal of this product by a tradesman or other person or any other costs associated with
its use are the responsibility of the end user. This warranty applies to the original purchaser
of the product only and is not transferable to any third party. Unauthorized end user or
third party modifications to any component or evidence of misuse or abuse of the device will
render all warranties void.
By law some countries do not allow limitations on certain exclusions in this warranty. Where
applicable by local laws, regulations and legal rights will take precedence.
Swann Communications USA Inc.
12636 Clark Street
Santa Fe Springs CA 90670
USA
Swann Communications PTY. LTD.
Building 4, 650 Church Street,
Richmond, Victoria 3121
Australia
Warranty Information
Helpdesk / Technical Support Details
Swann Technical Support
All Countries E-mail: tech@swannsecurity.com
Telephone Helpdesk
See http://www.worldtimeserver.com for information on time zones and the
current time in Melbourne, Australia compared to your local time.
USA toll free
1-800-627-2799
(Su, 2pm-10pm US PT)
(M-Th, 6am-10pm US PT)
(F 6am-2pm US PT)
USA Exchange & Repairs
562-777-2551
(M-F, 9am-5pm US PT)
AUSTRALIA toll free
1300 138 324
(M 9am-5pm AUS ET)
(Tu-F 1am-5pm AUS ET)
(Sa 1am-9am AUS ET)
NEW ZEALAND toll free
0800 479 266
INTERNATIONAL
+61 3 8412 4610
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Sistema de seguridad de Swann
Swann
Swann USB 2.0 DVR Guardian Manual de usuario
Swann
Swann SW276-ASL Manual de usuario
Swann
Swann RL-0507A Manual de usuario
Swann
Swann DVR4-2500 Manual de usuario
Swann
Swann Digital EagleEye ADW-400 Manual de usuario
Swann
Swann 960H Pro series Manual de usuario
Swann
Swann SW351-WSA Manual de usuario
Swann
Swann DVR4-1200 Manual de usuario
Swann
Swann DVR8-4200 Manual de usuario
Swann
Swann SWDVK-840004F Manual de usuario
Swann
Swann MicroCam III Manual de usuario
Swann
Swann SWDVK-840004D Manual de usuario
Swann
Swann SecuraView Manual de usuario
Swann
Swann One Manual de usuario
Swann
Swann Mobile viwer Manual de usuario
Swann
Swann SW351-MDA Manual de usuario
Swann
Swann ADW-200 Manual de usuario
Swann
Swann SW344-DPS Manual de usuario
Swann
Swann SW351-WSA Manual de usuario
Swann
Swann ADW-350 Manual de usuario
Manuales populares de Sistema de seguridad de otras marcas
Highway Safety Group
Highway Safety Group EA401 Manual de usuario
Siren
Siren LED GSM Manual de usuario
Detection Systems
Detection Systems 7090i Instrucciones de montaje
Se-Kure Controls
Se-Kure Controls MicroMini SK-4841 Manual de usuario
Siemens
Siemens FDM273 Manual de usuario
DSC
DSC PC 4010 Manual del propietario