StarTech.com PCIBT Manual de usuario

Network Adapter

10-Mbps PCI 10BaseT Ethernet Card

Installation Manual

PCIBT

General Description

The StarTech 10Mbps PCI Ethernet Card is a network adapter that combines low cost,

reliable performance, and easy Plug and Play installation. It is capable of operating in

full-duplex mode, which doubles its data throughput to 20 Mbps. This network adapter

is fully compliant with industry specifications for 10Mbps twisted-pair

Ethernet networks.

Features

lFully compliant with IEEE 802.3 10BaseT Ethernet specifications.

lSupports full duplex mode to double data transmission rate.

lAutomatic polarity correction for 10BaseT.

lIncludes a built-in 32 kb SRAM buffer to speed data transmission.

lJumperless Plug & Play installation.

lDrivers for: Novell Netware3.x, 4.x, Windows NT3.1, NT3.5, NT4.0, Windows for

workgroups 3.x, Windows 95, 98, 2000, ME, Lantastic 4.x, 5.x, 6.x, SCO UNIX.

System Requirements

1. An IBM-PC compatible computer.

2. One PCI slot.

3. One free IRQ.

4. One of the following operating systems: Windows 95/98, Windows Me,

Windows NT 4.0/2000, MS-DOS/Windows 3.1.

Getting Started

This section is designed to help you prepare the Network Adapter for installation. Please

read through this section carefully before attempting to install the card.

Unpacking the PCIBT

This package should contain:

1 x PCIBT card

1 x driver disk

Installation

Network Adapters, like all computer equipment, are subject to static electricity. Be sure

that you are properly grounded. StarTech.com recommends that you wear an

anti-static strap.

Installing the Card:

1. Make sure your system is unplugged and you are grounded.

2. Remove the cover of your system.

3. Remove the covering plate from a free PCI bay. (a PCI Bay is usually a short white

slot found on the motherboard)

4. Insert the Network Adapter, and make sure it is firmly seated in the slot.

5. Using a #6-32 x 1/4” screw secure the card in place.

6. Put your computer case back on.

7. Connect to the network using AUI, thin or twisted-pair cables depending on the

connector you are using.

Configuration/Diagnostics

The PCIBT is basically self-configurable and requires no intervention from the user.

There are only 2 items that can be configured: Full/Half duplex, and Boot ROM

enabled/disabled. You can also run diagnostic of the card from the Setup.exe

program provided.

Insert the floppy diskette provided. Prompt the Setup.exe and you will see

the following:

• Auto Configuration

• Manual Setup Configuration

• View current Configuration

• Diagnostic

• Exit

Please follow the easy menu-driven program to configure the card.

Driver Installation

For detailed information, please refer to the document in the diskette provided.

Examples:

1. For NetWare client, please execute the following:

lsl

pciodi

ipxodi

netx or vlm

2. For NetWare server, please execute the following:

load pcisrv

bind ipx pcisrv

load monitor

Boot ROM Installation (Optional)

The PCIBT provides a socket for a remote boot ROM. With a boot ROM, a host computer

can load the operating systems over the network.

1. Plug in the boot ROM to the appropriate position, make sure the direction is correct.

2. Enable the boot ROM function. Please see Setup program for details.

Troubleshooting

Most common factors that cause an adapter to fail are configuration conflicts and cabling

problems. PCI cards shouldn’t have any conflict problems due to plug and play

specification. If there is, check the cable and its connector and/or use the adapter LED

indicators and Diagnostic Program For information on the Diagnostic Program, please

see the Setup program. If the problem persists, call your dealer for help.

LED Indicators

The LEDs help you monitor the network status. Their functions depend on the type of

cable used.

*Link monitors the data link status on the UTP cable. It turns ON when there is data

link, and off when there is a bad connection.

*Activity blinks when there is data transmission/reception.

FCC Warning

This equipment complies with the limits for a Class A digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable protection when the

equipment is operated in a commercial environment. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used properly, may cause

harmful interference to radio communications. Operation of the equipment in a

residential area is likely to cause harmful interference.

Tabla de contenidos

Otros manuales de Tarjeta PCI de StarTech.com

StarTech.com

StarTech.com PEXMSATA3422 Manual de usuario

StarTech.com

StarTech.com PCI1S550 Manual de usuario

StarTech.com

StarTech.com PEX4S952LP Manual de usuario

StarTech.com

StarTech.com PEX2S650 Manual de usuario

StarTech.com

StarTech.com PEX867WAC22 Manual de usuario

StarTech.com

StarTech.com PEXUSB3S24 Manual de usuario

StarTech.com

StarTech.com PEX4S553S Manual de usuario

StarTech.com

StarTech.com PEX2S953 Manual de usuario

StarTech.com

StarTech.com PEXUSB311AC2 Manual de usuario

StarTech.com

StarTech.com PCISOUND5LP Manual de usuario

StarTech.com

StarTech.com PCIPOST Manual de usuario

StarTech.com

StarTech.com PEXHDCAP4K Manual de usuario

StarTech.com

StarTech.com PEX1000SFP2 Manual de usuario

StarTech.com

StarTech.com PCI1224PUSB Manual de usuario

StarTech.com

StarTech.com PEX4S950 Manual de usuario

StarTech.com

StarTech.com PCISATA2A133 Manual de usuario

StarTech.com

StarTech.com 8STPEXUSB3S44V Manual de usuario

StarTech.com

StarTech.com PCI1394_2 Manual de usuario

StarTech.com

StarTech.com PEXHDCAP2 Manual de usuario

StarTech.com

StarTech.com PCI2S4851050 Manual de usuario

StarTech.com

StarTech.com ECHDCAP Manual de usuario

StarTech.com

StarTech.com PEXUSB3S4 Manual del sistema

StarTech.com

StarTech.com PEXUSB3S42 Manual de usuario

StarTech.com

StarTech.com ST1000SPEX Manual de usuario

Manuales populares de Tarjeta PCI de otras marcas

ERMA

ERMA SSI 1417 Manual de usuario

SIIG

SIIG CyberSerial Dual PCI Instrucciones de montaje

Moxa Technologies

Moxa Technologies CP-102E Manual de usuario

I-Bus

I-Bus IBC2602 Manual de usuario

Exsys

Exsys EX-60102 Manual de usuario

Chelsio Communications

Chelsio Communications T5 Series Manual de usuario

Conrad Electronic

Conrad Electronic 97 46 71 Manual de usuario

Micro Innovations

Micro Innovations USB650A Manual de usuario

KTI Networks

KTI Networks KF-310 Manual de usuario

Asus

Asus SpaceLink WL230 Manual de usuario

SIIG

SIIG SC2475 Manual de usuario

TRENDnet

TRENDnet TEW-703PI Manual de usuario

Belkin

Belkin F5D7000F Manual de usuario

Pericom

Pericom PI7C7100 Manual de usuario

ADLINK Technology

ADLINK Technology cPCI-3548 Manual de usuario

Digium

Digium TE200 Series Manual de usuario

Allo.com

Allo.com 2nd Gen E1/T1/J1 Manual de usuario

Western Digital

Western Digital FireWire PCI Adapter Manual de usuario