StarTech.com USB2004EXTGB Manual de usuario
USB Extender
4-Port USB 2.0 Extender over
Cat5 or Cat6
Instruction Manual
USB2004EXT
USB2004EXTGB
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which the receiver•
is connected.
Consult the dealer or an experienced radio/TV technician for help.•
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only
and do not represent an endorsement of a product or service by StarTech.com, or an
endorsement of the product(s) to which this manual applies by the third-party company
in question. Regardless of any direct acknowledgement elsewhere in the body of
this document, StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this
manual and related documents are the property of their respective holders.
i
Table of Contents
Introduction..................................................................... 1
Packaging Contents.....................................................................1
System Requirements .................................................................1
Local Unit.....................................................................................2
Remote Unit.................................................................................3
Installation....................................................................... 4
Hardware Installation...................................................................4
Driver Installation.........................................................................5
Wiring Diagram ............................................................... 6
Specifications.................................................................. 7
Technical Support........................................................... 8
Warranty Information...................................................... 8
1
Introduction
The StarTech.com USB 2.0 extender over Cat5 or Cat6 offers a
simple USB extension, allowing you to place four USB 2.0 devices
up to 100m/330ft away from the computer, which is more than 20
times longer than the normal USB cable length restrictions. The USB
extender is comprised of both the Local and Remote units, which
can be connected together using standard UTP Cat5, Cat5e, or Cat6
Ethernet cabling. Supporting full Hi-Speed USB 2.0 data transfer
speeds up to 480Mbps, the extender is also backward compatible with
USB 1.0/1.1 (1.1Mbps/12Mbps respectively).
Packaging Contents
1 x USB 2.0 Extender Local Unit•
1 x USB 2.0 Extender Remote Unit•
1 x Power Adapter•
1 x Instruction Manual•
System Requirements
USB enabled computer system with available port•
USB compliant operating system•
Available power outlet at remote location•
2
Local Unit
RJ45 connector
RJ45
Link LED
RJ45
Activity LED
Power
LED
Host
LED
USB connector
(Host)
LED Description
Power Turns on when power is being supplied via the
USB port.
Host Turns on when the host computer system
detects the extender.
RJ45 Link Indicates connectivity between the Local and
Remote unit.
RJ45 Activity Indicates data transmission between the Local
and Remote units.
3
Remote Unit
RJ45 connector
DC Power connector
RJ45
Link LED
RJ45
Activity LED
LED Description
Power Turns on when power is being supplied via the
external powr adapter.
Host Turns on when the host computer system
detects the extender.
RJ45 Link Indicates connectivity between the Local and
Remote unit.
RJ45 Activity Indicates data transmission between the Local
and Remote units.
USB Port Indicates a USB peripheral device is connected
and detected on the host computer system.
USB Hub
Connector
Power
LED
Host LED
USB port
LEDs
4
The Local Unit can be connected to the host computer system either1.
when it is powered on or off.
Connect the Local Unit directly to a USB port on the host computer2.
system via the integrated USB cable. The Power LED should light
up if/when the host computer is powered on.
Connect the UTP (CAT5e, CAT6, etc.) network cable to the RJ453.
connector on the Local Unit.
NOTE: Ensure that the total length of cable between the Local and
Remote units is 100m or less. The cabling must also not go through
any networking equipment (e.g. router/switch/hub/etc.).
Setup the Remote Unit near the remote USB peripheral(s).4.
Connect the other end of the UTP cable from the Local Unit to the5.
RJ45 connector on the Remote Unit.
Connect the power adapter to the Remote Unit. The Power LED6.
should light up. The Host LED should start flashing if the Local Unit
is powered. The host computer system should detect a USB hub
as being connected, and the Host LED on both units should light up
steady.
Plug the remote USB peripheral(s) into the USB Hub connector(s)7.
on the Remote Unit. The corresponding USB port LED should light
up. The USB device(s) should be detected as if connected directly
to the host computer system.
Install the drivers for the connected USB peripheral(s) as necessary.8.
Installation
Hardware Installation
5
Driver Installation
The USB Extender itself does not require a driver installation for
any operating system that supports USB. The USB Extender is a
pass-through hub, so is only seen as a standard Generic USB hub.
Drivers will still be required for any USB peripherals connected to the
extenders.
NOTE: A additional level of USB hubs can be used on the USB
extender (one hub per port), to provide additional USB ports. An
externally powered USB hub is recommended.
6
Wiring Diagram
The USB Extender uses all four pairs of wires in the UTP cable, so
either T568A or T568B termination can be used. Both ends of the
cable must use the same termination.
T568A Termination
Pin Wire Color Pair
1 White/Green 3
2 Green 3
3 White/Orange 2
4 Blue 1
5 White/Blue 1
6 Orange 2
7 White/Brown 4
8 Brown 4
T568B Termination
Pin Wire Color Pair
1 White/Orange 2
2 Orange 2
3 White/Green 3
4 Blue 1
5 White/Blue 1
6 Green 3
7 White/Brown 4
8 Brown 4
7
Specications
USB2004EXT
USB2004EXTGB
Bus Interface USB 2.0
Connectors
(Local Unit)
1 x RJ45
1 x USB type A male
Connectors
(Remote Unit)
1 x RJ45
4 x USB type A
LEDs (Local Unit) 1 x Power
1 x Host
LEDs (Remote Unit)
1 x Power
1 x Host
4 x USB Detect
Maximum Data Transfer Rate USB 2.0: 480Mbps
Maximum Cable Distance 100m / 330ft
USB Power (per port) Remote Unit: 500mA
Integrated Cable Length Local Unit: 6”
Power Adapter 5VDC, 3A
Operating Temperature 0°C ~ 50°C (32°F ~ 122°F)
Storage Temperature -5°C ~ 60°C (23°F ~ 140°F)
Humidity 0 ~ 80% RH
Dimensions (Local Unit) 44.0mm x 87.0mm x 24.0mm
Dimensions (Remote Unit) 110.0mm x 69.0mm x 28.0mm
Weight Local Unit: 60g
Remote Unit: 200g
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Extensor de StarTech.com
StarTech.com
StarTech.com ST121 Series Manual de usuario
StarTech.com
StarTech.com USB2G4LEXT2NA Manual de usuario
StarTech.com
StarTech.com EOC110K Manual del sistema
StarTech.com
StarTech.com SV565UTPUSA Manual de usuario
StarTech.com
StarTech.com WIFI2VGA Manual de usuario
StarTech.com
StarTech.com ST121R Manual de usuario
StarTech.com
StarTech.com ST121R Manual de usuario
StarTech.com
StarTech.com HD202A Manual de usuario
StarTech.com
StarTech.com STUTPEALR Manual de usuario
StarTech.com
StarTech.com SV565UTP Manual de usuario
StarTech.com
StarTech.com ST121HDBT20L Manual de usuario
StarTech.com
StarTech.com 8STST12MHDLAN Manual de usuario
StarTech.com
StarTech.com USB2001EXTV Manual de usuario
StarTech.com
StarTech.com USB2G4LEXT2 Manual de usuario
StarTech.com
StarTech.com 110VDSLEXT Manual de usuario
StarTech.com
StarTech.com USBthere USB221EXT Manual de usuario
StarTech.com
StarTech.com ST121HDBTE Manual de usuario
StarTech.com
StarTech.com ST1212T Manual de usuario
StarTech.com
StarTech.com HDBOOST4K Manual de usuario
StarTech.com
StarTech.com ST222HDBT Manual de usuario
