StarTech.com SV565UTPHDU Manual de usuario
Manual Revision: 06/27/2014
For the most up-to-date information, please visit: www.startech.com
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
SV565UTPHDU / SV565UTPDUV
1920x1200 Uncompressed DVI over
Cat5e/6 KVM Extender - 330ft (100m)
*actual product may vary from photos
Instruction Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not
represent an endorsement of a product or service by StarTech.com, or an endorsement of the
product(s) to which this manual applies by the third-party company in question. Regardless
of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby
acknowledges that all trademarks, registered trademarks, service marks, and other protected
names and/or symbols contained in this manual and related documents are the property of
their respective holders.
Instruction Manual
1
Table of Contents
Introduction............................................................................................2
Packaging Contents ................................................................................................................................. 2
System Requirements.............................................................................................................................. 2
Product Overview ..................................................................................3
Front View - SV565UTPHDU .................................................................................................................. 3
Rear View - SV565UTPHDU .................................................................................................................... 3
Front View - SV565UTPDUV................................................................................................................... 4
Rear View - SV565UTPDUV..................................................................................................................... 4
LED Indicators............................................................................................................................................. 5
Cabling.......................................................................................................................................................... 5
Installation .............................................................................................6
Hardware Installation .............................................................................................................................. 6
Verifying Installation................................................................................................................................ 8
Troubleshooting........................................................................................................................................ 9
Specications..........................................................................................13
Technical Support ..................................................................................14
Warranty Information............................................................................14
Instruction Manual
2
Introduction
Packaging Contents
• 1 x Local Extender Unit
• 1 x Remote Extender Unit
• 2 x Mounting Brackets
• 1 x HDMI Cable
• 1 x USB Cable
• 2 x Universal Power Adapters
• 6 x Power Cords (2 sets, NA/EU/UK)
• 1 x Quick Start Guide
System Requirements
• A USB-compatible computer with an HDMI/DVI output
• USB 1.1 or 2.0 Keyboard / Mouse
• An HDMI/DVI display
• A minimum of Cat 5e (UTP) cable with two Cat 5e RJ45 connectors
(if using surface cabling)
OR
• A minimum of Cat 5e UTP cabling with two information outlets and two Cat 5e
patch cords with Cat 5e RJ45 connectors (if using premise cabling).
NOTE: While Cat 5e UTP is the minimum category of twisted pair cabling, for the best
experience, and to minimize interference and cross-talk, Cat 6 STP or better is strongly
recommended. When using Cat 5e cabling, the layout and quality of your cable runs
and connections become extremely important. Please refer to the Cabling section on
page 5 for more detailed information. Any reference to Cat 5e cabling should be read
as Cat 5e or better.
Instruction Manual
3
Product Overview
Front View - SV565UTPHDU
Rear View - SV565UTPHDU
Remote Unit
Local Unit
Instruction Manual
4
Rear View - SV565UTPDUV
Remote Unit
Local Unit
Front View - SV565UTPDUV
Instruction Manual
5
LED Indicators
Power LED (Green) On: The system is powered and ready to use
O: The system is not powered
Link LED (Green)
On: Local and Remote extenders are able to communicate
across the link
O: There is no communication between the local and
remote extenders
USB LED (Green)
On: The local extender and the host computer are
communicating with each other and working
Flashing: The host has suspended communication with the
local extender
O: The host and the local extender are not communicating
or not connected
Video LED (Green)
On: HDCP (digital rights management) content is being
transmitted
Flashing: Video (non-HDCP) content is being transmitted
O: No video is being transmitted
Cabling
Solid core Category 6 STP cable with Category 6 RJ45 connectors is recommended
for best performance. Using Cat 5e or unshielded Cat 6 cabling may leave your
signal more susceptible to interference and noise which may result in poor video
performance or reduced extension distance.
Cable Type Maximum Distance Notes
Uncoiled Coiled
Solid Core Cat 5e UTP 100m (330 ft) 70m (229 ft) High susceptibility to
electrical interference
Solid Core Cat 5e STP 100m (330 ft) 80m (262 ft) Moderate susceptibility to
electrical interference
Solid Core Cat 6 UTP 100m (330 ft) 100m (330 ft) High susceptibility to
electrical interference
Solid Core Cat 6 STP 100m (330 ft) 100m (330 ft) Recommended
Solid Core Cat 7 STP 100m (330 ft) 100m (330 ft) Recommended
Instruction Manual
6
Installation
Hardware Installation
Preparing your site
1. Determine where the computer is to be located and set up the computer.
2. Determine where you want to locate the remote desktop, including the monitor,
keyboard, mouse and any other USB device(s).
3. If you are using surface cabling, the product supports a maximum distance of
100m (330 ft).
OR
If you are using premise cabling, ensure Cat 5e cabling is installed between the two
locations with Cat 5e information outlets located near both the computer and the
USB device(s), and the total length, including patch cords, is no more than 100m.
Installing the Local Extender Unit
1. Place the local extender unit near the computer.
2. Connect the supplied USB cable to the USB port on the local extender, and an
available USB 2.0/1.1 Type A Port on the computer.
3. Connect the supplied video cable to the local extender (HDMI/DVI In), and an
available HDMI/DVI Port on the computer.
Instruction Manual
7
Installing the Remote Extender Unit
1. Place the remote extender unit near the monitor and USB device(s) in the desired
remote location.
2. Connect an HDMI/DVI cable (not included) to the remote extender (HDMI/DVI Out)
to the monitor.
3. Plug your USB Device(s) into the USB ports on the remote extender.
Connecting the Local Extender to the Remote Extender
With Surface Cabling
1. Plug one end of the Cat 5e cabling (not included) into the Link port (RJ45) on
the local extender.
2. Plug the other end of the Cat 5e cabling into the Link port (RJ45) on the
remote extender.
With Premise Cabling
1. Plug one end of a Cat 5e patch cord (not included) into the Link port (RJ45) on
the local extender.
2. Plug the other end of the patch cord into the Cat 5e information outlet near
the host computer.
3. Plug one end of the second Cat 5e patch cord (not included) into the Link port
(RJ45) on the remote extender.
4. Plug the other end of the second patch cord into the Cat 5e information outlet
near the USB device(s).
Instruction Manual
8
Connecting Power to the Local and Remote Extenders
1. Plug the supplied 5V, 3A power adapter into a suitable AC outlet near the
local extender.
2. Connect the power adapter to the local extender.
3. Plug the supplied 5V, 3A power adapter into a suitable AC outlet near the
remote extender.
4. Connect the power adapter to the remote extender.
Connecting a USB Device
1. Install any software required to operate the USB device(s). Refer to the
documentation provided for your USB device(s).
2. Connect the USB device to the device port on the remote extender.
3. Check that the USB device is detected and installed properly in the
operating system.
Verifying Installation
1. On the local and remote extender units, check that the Power, Link, USB, and Video
LEDs are on. If the Link LED is o, then the cabling between the local and remote
extenders is not installed properly or is defective.
Cat 5e (or better) UTP
Otros manuales para SV565UTPHDU
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Extensor de StarTech.com
StarTech.com
StarTech.com IPUSB2HD3 Manual de usuario
StarTech.com
StarTech.com ST122UTPAL Manual de usuario
StarTech.com
StarTech.com ST121HD20FXA Manual de usuario
StarTech.com
StarTech.com UTPE Series Manual de usuario
StarTech.com
StarTech.com EOC110K Manual de usuario
StarTech.com
StarTech.com USB110EXT2 Manual de usuario
StarTech.com
StarTech.com ST121UTPMINI Manual de usuario
StarTech.com
StarTech.com IPUSB2VGA2 Manual de usuario
StarTech.com
StarTech.com ST12MHDLNV Manual de usuario
StarTech.com
StarTech.com USBthere USB204EXT Manual de usuario
StarTech.com
StarTech.com ST124HDBT Manual de usuario
StarTech.com
StarTech.com USB2004EXTV Manual de usuario
StarTech.com
StarTech.com 410VDSLEXT2 Manual de usuario
StarTech.com
StarTech.com SV565UTPDUV Manual de usuario
StarTech.com
StarTech.com IREXT2 Manual de usuario
StarTech.com
StarTech.com SV565UTPDUA Manual de usuario
StarTech.com
StarTech.com ST12MHDLANU Manual de usuario
StarTech.com
StarTech.com ST121WHD Manual de usuario
StarTech.com
StarTech.com ST1212T Manual de usuario
StarTech.com
StarTech.com 8STST121HDBT20S Manual de usuario
