SOMFY Sonesse 40 PA Manual de usuario

www.somfy.com

Sonesse®40 PA

Ref: 5064822A

Notice d’installation page 8

Par la présente, Somfy déclare que l’appareil est conforme aux exigences essentielles et

aux autres dispositions pertinentes de la directive 1999/5/CE. Une déclaration de confor-

mité est mise à disposition à l’adresse internet www.somfy.com/ce. Utilisable en UE CH et

NO.

Installation instructions page 2

SOMFY hereby declares that this product complies with the essential requirements and

other relevant provisions of Directive 1999/5/EC. A Declaration of Conformity is available at

the web address www.somfy.com/CE. Suitable for use in EU, CH and NO

Guía de instalación página 20

Por la presente, Somfy declara que el aparato cumple las exigencias esenciales y el resto

de disposiciones pertinentes de la directiva 1999/5/CE. Podrá encontrar una declaración de

conformidad en la página web www.somfy.com/ce.

Guida di installazione pag. 14

Somfy dichiara che questo dispositivo è conforme ai requisiti essenziali e alle altre dispo-

sizioni pertinenti della Direttiva 1999/5/CE. Una dichiarazione di conformità è disponibile

all’indirizzo Internet www.somfy.com/ce.

ENFRITES

CONTENT

1 Introduction

2 Safety

2.1 General information

2.2 General safety advice

3 Installation

4 Commissioning

4.1 Checking the rotation direction

4.2 Adjusting the end limits

5 Use

6 Troubleshooting

7 Technical data

8 Environment

1 Introduction

Product Description

The Sonesse®40 is a motor specially dedicated to interior applications.

The Sonesse®40 motor range can motorize all interior applications: Roller shades, Vene-

tian blinds, Roman shades, Pleated & cellular shades, Projection screens.

The Sonesse®40 is designed to ensure quiet operations.

Warning: The Sonesse® 40 isn’t compatible with wind functions.

2 Safety

2.1 General information

• This Somfy product must be installed by a professional motorisation and home automa-

tion installer, for whom these instructions are intended.

• Before installation, check that this product is compatible with the associated equipment

and accessories.

• These instructions describe how to install, commission and use this product.

• Moreover, the installer must comply with current standards and legislation in the country

in which the product is being installed, and inform his customers of the operating and

maintenance conditions for the product.

• Any use outside the sphere of application specied by Somfy is not approved. Such use,

or any failure to comply with the instructions given herein will invalidate the warranty, and

Somfy refuses to accept liability.

2.2 Specic safety advice

The safety instructions that must be observed, besides the usual rules, are

explained in these instructions and in the attached «Safety Instructions» document.

Never immerse the

motor in liquid!

Never drill holes in

the motor!

Avoid impacts!

Do not drop it!

3 Installation

Motor preparation

1) Fit the crown (a) and drive wheel (b) to the

motor.

2) Measure the length (L) between the end of the

drive wheel and the head end.

Tube preparation

1) Cut the tube to the required length.

2) Deburr the tube and remove the debris.

For smooth roller tubes, cut a notch with the

following measurements: e = 7 mm h = 10 mm

Motor/tube assembly

1) Slide the motor into the tube.

For smooth roller tubes, position the notch

previously cut on the crown.

2) Fix the tube to the motor with self-tapping

screws or steel pop rivets depending on the

dimension (L - 5 mm).

Mounting the motorized tube on the

brackets

If necessary, screw the bracket interface on the

motor head.

1) Mount the motorized tube on the end bracket

(c).

2) Mount the motorized tube on the motor bracket

(d).

Wiring

1) Switch off the power supply.

2) Connect the motor according to the

information in the table below.

Blue Brown

White Black

1 Neutral 2 Live

RANGE

230V-50Hz

120V 60Hz

Blue Brown220V 60Hz

Green

4 Earth

Black

Red

3 Live

Black

White Black110V 50/60Hz NARed

OFF

L = …

Ø > 37

L = …

Ø > 37

4 Commissioning

4.1 Checking the rotation direction

Switch on the power supply.

1) Press the control point UP button:

a) If the shade is raised (a), the rotation direction

is correct: move to the section entitled «Adjusting

the end limits».

b) If the shade is lowered (b), the rotation direction

is incorrect: move to the next step.

2) Switch off the power supply.

Reverse the two live wires on the control point.

3) Switch on the power supply.

Press the control point UP button

to check the rotation direction.

4.2 Adjusting the end limits

The limits can be set in any sequence.

1) Up limit

Press the control point UP button to raise the

shade to the Up limit and turn the corresponding

adjustment screw to set this limit.

2) Down limit

Press the control point DOWN button to lower the

shade to the Down limit and turn the correspon-

ding adjustment screw to set this limit.

5 Use

Up, Down & Stop

1) To move the shade from a limit to the other

limit, press briey the UP or DOWN button.

2) To stop the shade, press the STOP button.

6 Troubleshooting

The motor doesn’t work:

Verify:

• The wiring of the motor.

• The power supply specications.

• The heat generated (wait for the cooling of the motor).

The equipment stops too soon:

Veriy:

• The operation of end-limits during the rotation of the motor.

• The crown is properly tted to the tube.

• The end-limits of the motor are properly adjusted.

• That the shade is within the recommended weight limit.

The equipment is noisy:

Verify that:

• The wheel and the crown are well adapted to the used tube.

• The mechanical plays between motor, accessories, tube and end of tube must be de-

creased to the maximum.

• The wheel is properly xed to the tube.

• The equipment is not constrained between the brackets.

• The length of the notch is adapted to the motor hook or to the used crown.

• Debris, screws or other are not in your tube.

• The power supply specications.

• The temperature of the environment is in conformity with the operating temperature.

7 Technical data

8 Environment

Damaged electric products and batteries should not be disposed of with

normal household waste.

Make sure to drop them in specially provided containers or at an authorized

organization that will ensure they are recycled

Operating temperature

Protection rating

0°C / 60 °C

IP 44

Power supply 230V/50Hz - 120V/60Hz - 220V/60Hz -

110V 50/60Hz

SOMMAIRE

1Introduction

2 Sécurité

2.1 Informations générales

2.2 Consignes générales de sécurité

3 Installation

4 Mise en service

4.1 Contrôle du sens de rotation

4.2 Réglage des ns de course

5 Utilisation

6 Dépannage

7 Caractéristiques techniques

8 Environnement

Otros manuales para Sonesse 40 PA

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Motor de SOMFY

SOMFY

SOMFY Sonesse Ultra 50 RS485 Manual de usuario

SOMFY

SOMFY LT RTS CMO Manual de funcionamiento

SOMFY

SOMFY Roll Up 28 RTS Manual de usuario

SOMFY

SOMFY Elite Smart Shades R28 WireFree RTS Manual de instalación

SOMFY

SOMFY RDO 50 CSI Manual de usuario

SOMFY

SOMFY ilmo 50 WT Manual de usuario

SOMFY

SOMFY Movelite WireFree RTS Manual de usuario

SOMFY

SOMFY Oximo io Manual de usuario

SOMFY

SOMFY J4 RTS Instrucciones de montaje

SOMFY

SOMFY Sonesse Utra 50 DC Manual de usuario

SOMFY

SOMFY LIGHTING OUTDOOR RTS Instrucciones de funcionamiento

SOMFY

SOMFY Glydea Instrucciones de funcionamiento

SOMFY

SOMFY J4 1TN Manual de usuario

SOMFY

SOMFY Oximo 50 S auto RTS Instrucciones de montaje

SOMFY

SOMFY GOME MOTION Roll Up 28 WT Manual de usuario

SOMFY

SOMFY SGH RTS Manual de usuario

SOMFY

SOMFY ILMO WT Manual de funcionamiento

SOMFY

SOMFY ORIENTA Manual de usuario

SOMFY

SOMFY WIREFREE LT-30RT Instrucciones de funcionamiento

SOMFY

SOMFY J4 1TN Manual de usuario

SOMFY

SOMFY Sonesse Ultra 50 RTS Manual de usuario

SOMFY

SOMFY SONESSE 30 ZIGBEE Manual de usuario

SOMFY

SOMFY Sonesse 50 PA Manual de usuario

SOMFY

SOMFY ST50 Guía del usuario

Manuales populares de Motor de otras marcas

Rotax

Rotax 125 senior MAX evo Manual de usuario

Kohler

Kohler K361 Manual de usuario

MTD

MTD OHV Series Manual de usuario

Kohler

Kohler COMMAND CH18-745 Manual de usuario

Mercury

Mercury D4.2L D-Tronic Manual de usuario

Selve

Selve SE Plus-RC Series Manual de usuario

Perkins

Perkins 1206E-E66TA Manual de usuario

Skov

Skov DA 174 Manual

Rossi

Rossi TX11 Series Manual de usuario

Siemens

Siemens SIMOTICS T-1FW3 Hoja de instrucciones

AL-KO

AL-KO PRO 350 Manual de usuario

MTU

MTU 12 V 4000 Lx4 Manual de usuario

Nanni

Nanni N3.30 Manual de instrucciones

Nanni

Nanni N5.160 CR2 Manual de usuario

KSB

KSB SuPreme Series Instrucciones de instalación

Hiwin

Hiwin EM1 Series Manual de usuario

Rotax

Rotax 912 i series Instrucciones de funcionamiento

Siemens

Siemens SIMOTICS XP 1MB1 Manual de usuario