SOMFY Cord Lift 32 RTS Manual de usuario
1Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
Cord Lift 32 RTS
Ref. 5113050A
EN
Installation guide
Notice d’installation
Guida all’installazione
Guía de instalación
Guia de instalação
Οδηγός εγκατάστασης
FRITESPTEL
2Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
Por la presente, Somfy declara que el producto cumple con los requisitos básicos y
demás disposiciones de la directiva 1999/5/CE. Podrá encontrar una declaración
de conformidad en la página web www.somfy.com/ce. Aplicable para la UE, Suiza y
Noruega. Fotos no contractuales.
ES
EN
Somfy hereby declares that this product conforms to the essential requirements and
other relevant provisions of Directive 1999/5/CE. A Declaration of Conformity is avai-
lable at www.somfy.com/ce. Usable in EU, CH and NO. Images are not contractually
binding.
FR
Par la présente, Somfy déclare que l’appareil est conforme aux exigences essentielles
et aux autresdispositions pertinentes de la directive 1999/5/CE. Une déclaration de
conformité est mise à disposition à l’adresse internet www.somfy.com/ce. Utilisable en
UE, CH et NO. Images non contractuelles.
IT
Somfy dichiara che il dispositivo è conforme ai requisiti essenziali e alle altre dispo-
sizioni pertinenti della direttiva 1999/5/CE. Una dichiarazione di conformità è disponi-
bile all’indirizzo Internet www.somfy.com/ ce. Utilizzabile in UE, CH e NO. Le immagini
hanno uno scopo puramente indicativo.
Pelo presente documento, a Somfy declara que o aparelho está conforme às exigências
fundamentais e às outras disposições pertinentes da directiva 1999/5/CE. Uma
Declaração de Conformidade encontra-se disponível na Internet, em www.somfy.com/
ce. Utilizável na UE, Suíça e Noruega. Imagens não contratuais.
PT
Με το παρόν έγγραφο, η Somfy δηλώνει ότι η συσκευή συμμορφώνεται με τις ουσιώδεις
απαιτήσεις και τις λοιπές σχετικές διατάξεις της οδηγίας 1999/5/ ΕΕ. Μια δήλωση
συμμόρφωσης διατίθεται στην ιστοσελίδα www.somfy.com/ce. Μπορεί να χρησιμοποιηθεί
στην ΕΕ, την Ελβετία και τη Νορβηγία. Οι εικόνες δεν αποτελούν τμήμα της σύμβασης.
EL
3Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
CONTENTS
1. Introduction 2
2. Safety 2
2.1. Safety and responsibility 2
2.2. Specic safety advice 3
3. Installation 3
3.1. Motor preparation 3
3.2. Tube preparation 3
3.3. Motor/tube assembly 3
3.4. Mounting the motorized tube on
the brackets 3
4. Wiring 4
5. Commissioning 4
5.1. Programming the RTS
transmitter 4
5.2. Checking the rotation direction 4
5.3. Adjusting the end limits 4
5.4. Recording the RTS transmitter 5
5.5. Favorite position: MY position /
Recording MY position. 5
6. Operation 5
6.1. Mode selection: Roller or
Tilting mode 5
6.2. Up, Down, My: In roller mode 5
6.3. Up, Down, My: In tilting mode 6
7. Additional setting 6
7.1. Favorite position: MY position 6
7.2. End limit re-adjustement 7
7.3. Adjusting the tilting speed 7
7.4. Modifying the motor rotation
direction 7
7.5. Modifying the wheel rotation
direction 8
7.6. Adding/Deleting RTS transmitter 8
7.7. Erasing the transmitters from
the memory 8
7.8. Erasing the memory of the motor 8
8. Troubleshooting 9
9. Technical data 9
1. INTRODUCTION
The Cord lift 32 RTS is a motor specially dedicated to interior applications.
The Cord lift 32 RTS can motorize roman, pleated and cellular shades.
The Cord lift 32 RTS is a battery operated motor, powered with lithium primary bat-
teries or NiMH batteries with solar pack. The motor can also be powered by a power
supply.
Warning : The Cord lift 32 RTS is compatible only with the «Sunis Indoor WireFree
RTS» sensor.
Warning : The Cord lift 32 RTS cannot be used with sealed double glazing.
4Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
2. SAFETY
2.1. Safety and responsibility
• This Somfy product must be installed by a professional motorisation and home
automation installer, for whom these instructions are intended.
• Before installation, check that this product is compatible with the associated equip-
ment and accessories.
• These instructions describe how to install, commission and use this product.
• Moreover, the installer must comply with current standards and legislation in the
country in which the product is being installed, and inform his customers of the ope-
rating and maintenance conditions for the product.
• Any use outside the sphere of application specied by Somfy is not approved. Such
use, or any failure to comply with the instructions given herein will invalidate the war-
ranty, and Somfy refuses to accept liability.
Subject to technical modications.
To avoid damaging the product:
1) Never immerse it in liquid!
2) Avoid impacts!
3) Never drill holes in it!
4) Do not drop it!
2.2. Specic safety advice
In addition to the safety instructions described in this guide, be sure to also
observe the instructions set out in the attached document «Safety instructions
to follow and keep».
Damaged electric products and batteries should not be disposed of with normal
household waste. Make sure to drop them in specially provided containers or
at an authorized organization that will ensure they are recycled.
1
3
2
4
5Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
3. INSTALLATION
1) If needed, Snap the headrail adapters
on the motor.
2) Snap the proper shaft adapter on the
motor.
3) Press the shaft adapter until the drive
rod anges “snap” into the shaft adapter.
Slide the motor into headrail until the
shaft “snap” into the adapter shaft.
For optimal radio reception, the
antenna should be kept straight
and outside the headrail.
3.1. Motor mounting
3.2. Motor integration inside the headrail
1
2
3
6Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
Plug the battery with the motor supply
cable.
Warning: Do not unplug the battery
when the motor works.
4. WIRING
5. COMMISSIONING
5.1. Programming the RTS transmitter
Press the UP and DOWN buttons
simultaneously on the RTS transmitter:
the shade jogs and the control point is
preprogrammed in the motor
Press the RTS transmitter UP button:
a) If the shade raises (a), the rotation
direction is correct: move to the section
entitled 5.3 «Adjusting the end limits».
b) If the shade is lowers (b), the rotation
direction is incorrect: move to the next
step.
b1) Press the RTS transmitter MY
button until the shade jogs: the
rotation direction has been modied.
b2) Press the RTS transmitter UP
button to check the rotation direction.
5.2. Checking the rotation direction
a
b
=
=
b2b1
7Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
The end limits can be set in any order.
1) Press and hold the UP button to move the
shade to the desired position. If necessary
adjust the Up position, using the UP or
DOWN buttons.
2) Press the MY and DOWN buttons
simultaneously and release them once the
shade begins to move.
The up limit is memorized.
3) Press the MY button when the shade
reaches the desired Down position.
If necessary adjust the down position, using
the UP or DOWN buttons.
4) Press the MY and UP buttons
simultaneously and release them when the
shade begins to move.
The Down limit is memorized. The shade
moves up and will stop at its upper limit.
5) To conrm the end limits, press and hold
the MY button until the shade jogs.The end
limits are recorded.
1 2
3 4
5
5.3. Adjusting the end limits
8Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
5.4. Recording the RTS transmitter
After recording the end limits:
Briey press the programming button on
the back of the transmitter. The shade jogs.
The transmitter is recorded.
If desired, to set the MY position, move the
shade to the desired position with the UP
or DOWN button then press the MY button
until the shade jogs.
PROG.
5.5. Favorite position: MY position / Recording MY position
6. OPERATION
1) Move the shade away from the end
limits.
2)Simultaneously press the UP and DOWN
buttons until the shade jogs.
3) Press and hold the MY and DOWN
buttons simultaneously until the shade jogs
to change from Roller mode to Tilting mode.
6.1. Mode selection: Roller or Tilting mode
The Cord Lift 32 RTS is designed to work in 2 modes: Tilting mode or Roller mode.
This feature allows the Roll Up 28 RTS to be set according to the type of blind you are
working with.
The Cord Lift 32 RTS is set by default to work in Roller mode.
1
23
9Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
1) To move the shade from a limit to the
other limit, press briey the UP or DOWN
button.
2) To stop the shade, press the MY button.
3) If a MY position is recorded,To move the
shade to this MY position, press briey the
MY button.
6.2. Up, Down, My: In roller mode
1
2
3
1) To move the shade from a limit to the
other limit, briey press (less than 0,5s) the
UP or DOWN button.
2) To stop the shade, press the MY button.
3) If a MY position is recorded,To move the
shade to this MY position, press briey the
MY button.
The shade rst goes to the down end limit,
then to the MY position.
4) To tilt the slats, press and hold the UP
or DOWN button or use the scroll of the
remote control, until the slats reach the
desired position.
6.3. Up, Down, My: In Tilting mode
1
2
3
4
10 Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
7. ADDITIONAL SETTING
1) Changing the MY position
To change the MY position, go to the
new desired MY position with the UP and
DOWN buttons then press the MY button
until the shade jogs.
2) Deleting the MY position
To delete the MY position, press the MY
button to move to this position and press
the MY button until the shade jogs.
1
2
7.1. Favorite position: MY position
Readjusting the upper end limit
1) Press the UP button, to move the shade
to the upper end limit.
2) Press and hold the UP and DOWN
buttons simultaneously until the shade jogs.
3) Press and hold the UP or DOWN button
to move the shade to the new desired
position.
4) To conrm the new limit press and hold
the MY button until the shade jogs.
Readjusting the lower end limit
1) Press the DOWN button to move the
shade to the lower end limit.
2) Press and hold the UP and DOWN
buttons simultaneously until the shade jogs.
3) Press and hold the UP or DOWN button
to move the shade to the new desired
position.
4) To conrm the new limit press and hold
the MY button until the shade jogs.
1 2
34
1 2
34
7.2. End limit readjustment
Tabla de contenidos
Idiomas:
Otros manuales de Motor de SOMFY
SOMFY
SOMFY Sonesse 30 DCT Manual de usuario
SOMFY
SOMFY ELIXO 2000 230V RTS Manual de usuario
SOMFY
SOMFY LT RTS CMO Manual de funcionamiento
SOMFY
SOMFY LT50 CMO Instrucciones de uso
SOMFY
SOMFY J4 io Manual de instrucciones
SOMFY
SOMFY Sonesse Ultra 50 Manual de usuario
SOMFY
SOMFY sonesse 30 rts Manual de instalación
SOMFY
SOMFY Elite Smart Shades R28 WireFree RTS Instrucciones de funcionamiento
SOMFY
SOMFY Ilmo 40 WT Manual de usuario
SOMFY
SOMFY Sonesse ULTRA 30 WireFree RTS Li-ion Instrucciones de funcionamiento
SOMFY
SOMFY SONESSE 30 ZIGBEE Manual de usuario
SOMFY
SOMFY Sonesse 50 RA Manual de usuario
SOMFY
SOMFY Centreo RTS Manual de usuario
SOMFY
SOMFY MAESTRIA+ 60 io Manual de usuario
SOMFY
SOMFY LT 50 PA Manual de usuario
SOMFY
SOMFY Maestria 50 RTS Instrucciones de funcionamiento
SOMFY
SOMFY Roll Up 28 RTS Manual de usuario
SOMFY
SOMFY Sonesse 30 PoE Manual de usuario
SOMFY
SOMFY TILT&LIFT 25 WF ZIGBEE Manual de usuario
SOMFY
SOMFY MAESTRIA+ 50 io Manual de usuario
