SOLTEK SL-53D2 Manual de uso y cuidado
ii
Notice to End Users
This UserÕs Guide & Technical Reference is for assisting system
manufacturers and end users in setting up and installing the
mainboard.
Every effort has been made to ensure that the information in this
manual is accurate. Soltek Computer Inc. is not responsible for
printing or clerical errors. Information in this document is subject
to change without notice and does not represent a commitment on
the part of Soltek Computer Inc.
No part of this manual may be reproduced, transmitted, translated
into any language in any form or by any means, electronic or
mechanical, including photocopying and recording, for any purpose
without the express written permission of Soltek Computer Inc.
Companies and products mentioned in this manual are for
identification purposes only. Product names appearing in this
manual may or may not be registered trademarks or copyrights of
their respective companies.
SOLTEK COMPUTER INC. PROVIDES THIS MANUAL ÒAS ISÓ
WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OR
CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE. IN NO EVENT SHALL SOLTEK COMPUTER
INC. BE LIABLE FOR ANY LOSS OR PROFITS, LOSS OF BUSINESS, LOSS
OF USE OR DATA, INTERRUPTION OF BUSINESS, OR FOR INDIRECT,
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES OF ANY
KIND, EVEN IF SOLTEK COMPUTER INC. HAS BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES ARISING FROM ANY DEFECT OR
ERROR IN THIS MANUAL OR PRODUCT.
© Copyright 1997 Soltek Computer Inc. All right reserved
Web site: http://www.soltek.com.tw
Edition: August 1997
Version: 1.0
SL-53D2/D5 SERIAL
Contents iii
Contents
Chapter 1: Introduction --------------------------------------- 1
Features -------------------------------------------------------------------------1
CPU ------------------------------------------------------------------------1
Chipset -------------------------------------------------------------------- 1
L2 Cache ------------------------------------------------------------------1
Main Memory ----------------------------------------------------------- 1
BIOS ------------------------------------------------------------------------ 2
I/O Function -------------------------------------------------------------2
Other Functions --------------------------------------------------------- 2
Mainboard Setting for Pentium MMX-166----------------------------- 3
Chapter 2: Hardware Setup---------------------------------- 4
CPU VCORE Voltage Setting---------------------------------------------- 4
JP1: CPU VCore Voltage Setting -----------------------------------4
JP2: Single/Dual Voltage Select Jumper ------------------------- 5
Intel Pentium MMXÐ166/200/233 --------------------------------------- 6
AMD K6 CPU Settings------------------------------------------------------7
AMD K6 Ð 166/200/233 ---------------------------------------------- 7
Cyrix 6x86MX (M2) Ð PR150/166/200/233/266 ---------------------8
Cyrix 6x86L Ð PR133+/PR150+/PR166+/PR200+ CPUs----------- 9
Intel Pentium/AMD K5 CPU Settings-------------------------------- 10
CPU 1.5X Clock Setting (Red Caps) ------------------------------ 10
CPU 2.0X Clock Setting (Red Caps) ------------------------------ 11
CPU 2.5X Clock Setting (Red Caps) ------------------------------ 11
CPU 3.0X Clock Setting (Red Caps) ------------------------------ 12
System Memory Configuration----------------------------------------- 12
Jumper Settings ------------------------------------------------------------- 13
JBAT1: Clear CMOS Data ------------------------------------------ 13
JBF & JCK: Bus Ratio and External Bus Clock Select-------- 13
Power Connector ----------------------------------------------------- 14
iv
IDE LED Activity Light: (J2 pin1Ð4)------------------------------ 15
Infrared Port Module Connector (J2 pin6Ð10) ----------------- 15
J2 pin12, 13: Reserved ----------------------------------------------- 15
SMI Switch (J2 pin14, 15)-------------------------------------------- 15
Speaker Connector (J1 pin1Ð4) ------------------------------------ 15
Reset Switch (J1 pin5, 6)--------------------------------------------- 15
Power LED and Keylock Switch (J1 pin8Ð12)------------------ 15
Turbo LED (J1 pin14, 15)-------------------------------------------- 16
USB: USB Connector ------------------------------------------------ 17
J2 Switch Signal Summary ----------------------------------------- 18
J1 Switch Signal Summary ----------------------------------------- 19
Chapter 3: BIOS Setup ---------------------------------------20
Standard CMOS Setup ---------------------------------------------------- 21
BIOS Features Setup ------------------------------------------------------- 23
Chipset Features Setup --------------------------------------------------- 26
Power Management Setup ----------------------------------------------- 29
PnP/PCI Configuration Setup ------------------------------------------ 32
Load Setup Defaults ------------------------------------------------------- 34
Integrated Peripherals ---------------------------------------------------- 34
Supervisor/User Password---------------------------------------------- 38
IDE HDD Auto Detection ------------------------------------------------ 39
Save & Exit Setup ---------------------------------------------------------- 39
HDD Low Level Format -------------------------------------------------- 40
Exit Without Saving ------------------------------------------------------- 40
Introduction 1
Chapter 1
Introduction
Features
CPU
1. Supports Intel Pentium P54C/MMX (P55C) CPUs at 90
~ 233 MHz;
2. Supports Cyrix 6x86(L) CPUs at PR133+~ PR200+MHz
and 6x86MX (M2) CPUs at PR166+~ PR266+;
3. Supports AMD K5: PR90 ~ PR200 and AMD K6: 166 ~
233;
4. Provides SOCKET 7 ZIF Socket;
5. Supports 75MHz CPU clock.
Chipset
1. VIA Apollo VPX chipset;
2. PCI Rev 2.1 and APM1.1 compliant.
L2 Cache
1. Onboard supports 256K/512k write back cache with
Pipelined Burst SRAMs.
Main Memory
1. Memory range from 4MB (minimum) to 512MB
(maximum) with DRAM Table Free configurations;
2. Supports Fast Page Mode/EDO/Synchronous DRAM
with 60ns/70ns DRAM speed;
3. Supports 4 pcs 72pin SIMM sockets and 1 piece of
168pin DIMM sockets (3.3V unbuffered type).
2
BIOS
1. AWARD Plug and Play BIOS;
2. Supports Advanced Power Management Function;
3. Flash Memory for easy upgrade.
I/O Function
1. Integrated USB (Universal Serial Bus) controller with
two USB ports;
2. Supports 2 IDE channels with 4IDE devices (including
120MB IDE floppy);
3. Provides PCI IDE Bus Master function;
4. One floppy port (including 3.5", 1.2MB Mode 3
function);
5. Two high speed 16550 FIFO UART ports;
6. One parallel port with EPP/ECP/SPP capabilities;
7. PS/2 mouse connector;
8. Infrared module connector.
Other Functions
1. AT Form Factor with 22cm x 23cm;
2. 4 PCI Master slots and 3 ISA slots;
3. Supports SCSI/CD-ROM Boot function;
Note: 1. Make sure that the SDRAM module not only has to be
168 pin DIMM but designed for 3.3V unbuffered
SDRAM as well. Double check with the SDRAM
supplier before install any SDRAMs. The mainboard
manufacturer has no obligation to any damage of the
board by using the incorrect specification of SDRAM.
2. Pentium MMX (P55C), Cyrix 6x86L/6x86MX (M2),
and AMD K6 are dual voltage CPUs. JP1/JP2 must
be set correctly (refer to page 4). Check with your
CPU supplier for the CPU voltage specification.
Introduction 3
Mainboard Setting for Pentium MMX-166
The default settings of the following figure is for the INTEL
Pentium MMX-166 with the 512K (or 256K) cache. To get
the best cooling effect, make sure that the airflow from the
CPU fan is facing the heatsink.
SL1
SL2
SL3
PCI4 PCI3 PCI2 PCI1
SIMM4
SIMM3
SIMM2
SIMM1
COM2 COM1
K/B
PS/2
Mouse
Power Con.
Heat Sinks
MMX–166
CPU
FDC37C669
+
Battery
VT82C587VP
VT82C587VP
P.B.SRAM
P.B.SRAM
1
USB
(Bank 2)
(Bank 1)
VT82C586VPX
VT826586
DIMM1 (BANK0) 3.3V Unbuffered SDRAM
Flash BIOS
JCK1
JCK2
JCK3
1
JP2
12
56
Heat
Sinks
JBF1
JBF2
JBF3
JP1
12
11 12
J2 HDLED IR
J1 T/LED
SM1
Power LEDRESETSPK
IDE1LPT
IDE1FDC
1
JBAT1
Air Flow
Figure 1Ð1. SLÐ53D2/D5 Motherboard Layout
4
Chapter 2
Hardware Setup
CPU V
CORE
Voltage Setting
JP1: CPU V
Core
Voltage Setting
VCore
Voltage JP1 VCore
Voltage JP1
3.5V
Pentium
(P54C), 6x86,
K5
11 12
12
2.9V
K6 Ð 166/200
6x86MX
(M2)
11 12
12
3.3V
11 12
12
2.8V
MMX, 6x86L
11 12
12
3.2V
K6 Ð 233
(and higher)
11 12
12
Reserved
11 12
12
Hardware Installation 5
CPU Type VCore
Pentium (P54C), 6x86, K5 3.52V
MMX (P55C) 2.8V
6x86L 2.8V
K6-166/200, 6x86MX (M2) 2.9V
K6-233 (or higher) 3.2V
Note: 1. Refer to the table above to choose the correct voltage
for the CPU everytime that you install a CPU.
2. Make sure that your JP1 & JP2 is matched with the
CPU voltage, otherwise will damage the CPU or
make the system unstable.
3 When the new CPU is announced and is not listed
on this manual, please refer to the above table, select
the correct voltage setting for it.
JP2: Single/Dual Voltage Select Jumper
JP2 is an jumper to use to select either single or dual CPU
voltage. This jumper is designed to use with JP1 together in
order to set the correct CPU voltage. Incorrect
combinations may cause the system unstable or damage
the CPU.
CPU JP2 Note
MMX, K6, 6x86L,
6x86MX (M2)
12
56
Dual Voltage
(default)
Pentium, K5, 6x86
12
56
Single Voltage
6
Intel Pentium MMX–166/200/233
Intel MMX
CPUs
JCK1
JCK2
JCK3
1
JP2
12
56
JBF1
JBF2
JBF3
JP2
12
11 12
JBF1
JBF2
JBF3
(2.8V)
3.5x clock
MMX – 233
JBF1
JBF2
JBF3
3.0x clock
MMX – 200
JBF1
JBF2
JBF3
2.5x clock
MMX – 166
Figure 2Ð1. CPU Type Configuration
Hardware Installation 7
AMD K6 CPU Settings
AMD K6 – 166/200/233
AMD K6
CPUs
JCK1
JCK2
JCK3
1
JBF1
JBF2
JBF3
JP1
12
11 12
JBF1
JBF2
JBF3
JP2
12
56
AMD K6 – 233
JBF1
JBF2
JBF3
AMD K6 – 200
JBF1
JBF2
JBF3
AMD K6 – 166
JP1
12
11 12
(2.9V)
JP1
12
11 12
(2.9V)
JP1
12
11 12
(3.2V)
Figure 2Ð2. CPU Type Configuration
Note: K6Ð233 CPU is 3.2V or 2.1V depending on its prcess.
Please check its spec before using it.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Placa madre de SOLTEK
SOLTEK
SOLTEK SL-75DRV5 Manual de usuario
SOLTEK
SOLTEK SL-65MIV-C Manual de usuario
SOLTEK
SOLTEK 75DRV Manual de usuario
SOLTEK
SOLTEK SL-65GS Manual de usuario
SOLTEK
SOLTEK SL-85LIR Manual de usuario
SOLTEK
SOLTEK SL-75KIV Manual de usuario
SOLTEK
SOLTEK SL-845GLI Manual de usuario
SOLTEK
SOLTEK SL-55D5 Manual de uso y cuidado
SOLTEK
SOLTEK 865Pro-FGR Manual de usuario
SOLTEK
SOLTEK SL-65MIE Manual de usuario
SOLTEK
SOLTEK SL-65ME Manual de usuario
SOLTEK
SOLTEK SL-75DRV2 Manual de usuario
SOLTEK
SOLTEK SL-61A Manual de uso y cuidado
SOLTEK
SOLTEK SL-75KAV Manual de usuario
SOLTEK
SOLTEK SL-55F5 Manual de usuario
SOLTEK
SOLTEK 75FRN2 Series Manual de usuario
SOLTEK
SOLTEK SL-85DR Manual de usuario
SOLTEK
SOLTEK SL-85DRV+ Manual de usuario
SOLTEK
SOLTEK SL-85MIR3 Manual de usuario
SOLTEK
SOLTEK SL-67EV1 Manual de uso y cuidado
Manuales populares de Placa madre de otras marcas
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Manual de usuario
Gigabyte
Gigabyte GA-9IVDT Manual de usuario
Texas Instruments
Texas Instruments ADS8372EVM Manual de usuario
Commell
Commell MS-C73 Manual de usuario
IBT Technologies
IBT Technologies MB860 Manual de usuario
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manual de usuario
