SOLTEK SL-61A Manual de uso y cuidado

Notice to End Users

This UserÕs Guide & Technical Reference is for assisting system

manufacturers and end users in setting up and installing the

mainboard.

Every effort has been made to ensure that the information in this

manual is accurate. Soltek Computer Inc. is not responsible for

printing or clerical errors. Information in this document is subject to

change without notice and does not represent a commitment on the

part of Soltek Computer Inc.

No part of this manual may be reproduced, transmitted, translated

into any language in any form or by any means, electronic or

mechanical, including photocopying and recording, for any purpose

without the express written permission of Soltek Computer Inc.

Companies and products mentioned in this manual are for

identification purposes only. Product names appearing in this

manual may or may not be registered trademarks or copyrights of

their respective companies.

SOLTEK COMPUTER INC. PROVIDES THIS MANUAL ÒAS ISÓ

WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED,

INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OR

CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A

PARTICULAR PURPOSE. IN NO EVENT SHALL SOLTEK COMPUTER

INC. BE LIABLE FOR ANY LOSS OR PROFITS, LOSS OF BUSINESS, LOSS

OF USE OR DATA, INTERRUPTION OF BUSINESS, OR FOR INDIRECT,

SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES OF ANY

KIND, EVEN IF SOLTEK COMPUTER INC. HAS BEEN ADVISED OF THE

POSSIBILITY OF SUCH DAMAGES ARISING FROM ANY DEFECT OR

ERROR IN THIS MANUAL OR PRODUCT.

Web site: http://www.soltek.com.tw

email: [email protected]; [email protected]

Edition: July 1997

Version: 2.0

SL-61A SERIAL

Contents iii

Contents

Chapter 1: Introduction --------------------------------------- 1

Features -------------------------------------------------------------------------1

CPU ------------------------------------------------------------------------1

Chipset -------------------------------------------------------------------- 1

L2 Cache ------------------------------------------------------------------1

Main Memory ----------------------------------------------------------- 1

BIOS ------------------------------------------------------------------------ 2

Super I/O Function ----------------------------------------------------2

Other Functions --------------------------------------------------------- 2

Mainboard Layout with Default Settings ------------------------------3

Chapter 2: Hardware Setup---------------------------------- 4

CPU Type Configuration---------------------------------------------------4

CPU 3.5X Clock Setting ----------------------------------------------- 4

Pentium II (klamath) Ð 233/66MHz -------------------------- 4

CPU 4.0X Clock Setting ----------------------------------------------- 5

Pentium II (klamath) Ð 266/66 MHz ------------------------- 5

System Memory Configuration------------------------------------------- 5

CPU Installation -------------------------------------------------------------- 6

Intel Single Edge Cartridge (S.E.C.) Cartridge Disassembly

Process Application Note ------------------------------------------------ 10

Thermal Plate Removal --------------------------------------------- 12

Tool ----------------------------------------------------------------- 12

Procedure --------------------------------------------------------- 12

Thermal Grease Removal ------------------------------------------- 14

Materials ----------------------------------------------------------- 14

Procedure --------------------------------------------------------- 14

Jumper Settings ------------------------------------------------------------- 16

Factory Fixed Jumpers----------------------------------------------- 16

JP1, JP3: DIMM Connector Power Source---------------------- 16

JP11: AT/ATX Power Select--------------------------------------- 16

FAN: Onboard FAN (12V) Connector -------------------------- 16

JP9: Clear CMOS Data ---------------------------------------------- 17

SW1: 1Ð2 Bus Clock Select ----------------------------------------- 17

SW1: 3Ð6: Bus Ratio Select ----------------------------------------- 18

IDE LED Activity Light: (J1 pin1Ð4)------------------------------ 18

Infrared Port Module Connector (J1 pin6Ð10) ----------------- 18

J1 pin12, 13: PWR Switch------------------------------------------- 18

SLEEP Switch (J1 pin14, 15) ---------------------------------------- 19

Speaker Connector (J2 pin1Ð4) ------------------------------------ 19

Reset Switch (J2 pin5, 6)--------------------------------------------- 19

Power LED and Keylock Switch (J2 pin8Ð12)------------------ 19

Turbo LED (J2 pin14, 15)-------------------------------------------- 19

USB: USB Connector ------------------------------------------------ 20

J1 Switch Signal Summary ----------------------------------------- 21

J2 Switch Signal Summary ----------------------------------------- 22

AT Power Connector ------------------------------------------------ 22

Chapter 3: BIOS Setup ---------------------------------------23

Standard CMOS Setup ---------------------------------------------------- 24

BIOS Features Setup ------------------------------------------------------- 26

Chipset Features Setup --------------------------------------------------- 29

Power Management Setup ----------------------------------------------- 32

PnP/PCI Configuration Setup ------------------------------------------ 34

Load Setup Defaults ------------------------------------------------------- 36

Integrated Peripherals ---------------------------------------------------- 36

Supervisor/User Password---------------------------------------------- 41

IDE HDD Auto Detection ------------------------------------------------ 42

Save & Exit Setup ---------------------------------------------------------- 42

Exit Without Saving ------------------------------------------------------- 42

Introduction 1

Chapter 1

Introduction

Features

CPU

1. Supports Intel Pentium II (klamath) CPU using SLOT1

at 166 ~ 533 MHz

2. Supports CPU voltage autodetect circuit

Chipset

1. Intel 82440FX chipset

2. PCI Rev 2.1 compliant

L2 Cache

1. CPU Card supports 256K/512k write back cache with

Pipelined Burst SRAMs

Main Memory

1. Memory range from 8MB (minimum) to 384MB

(maximum) with DRAM Table Free configurations

2. Supports Fast Page Mode/EDO/BEDO DRAM with

50ns/60ns/70ns DRAM speed

3. Supports 4 pcs 72pin SIMM sockets and 2 pcs 168pin

DIMM sockets (3.3V or 5V EDO/FP type)

4. DRAM supports ECC or Parity function

BIOS

1. AWARD Plug and Play BIOS

2. Supports Advanced Power Management Function

3. Flash Memory for easy upgrade

Super I/O Function

1. Integrated USB (Universal Serial Bus) controller with

two USB ports.

2. Supports 2 IDE channels with 4IDE devices (including

120MB IDE floppy)

3. Provides PCI IDE Bus Master function

4. One floppy port (including 3.5", 1.2MB Mode 3 function)

5. Two high speed 16550 FIFO UART ports

6. One parallel port with EPP/ECP/SPP capabilities

7. PS/2 mouse connector

8. Built-in RTC, CMOS, keyboard controller on single I/O

chip

9. Peripherals boot function (with ATX power)

Other Functions

1. BABY AT size 22cm x 33cm

2. 4 PCI Master slots and 4 ISA slots

3. Supports SCSI/CD-ROM Boot function.

Introduction 3

Mainboard Layout with Default Settings

The default settings of the following figure is for the

Pentium II (Klamath) 233/66 and AT power

SL7 SL5 SL3 SL1

PCI1 PCI2 PCI3 PCI4

I/O

PS/2

Mouse K/B

AT Power Con

ATX Power Con

Printer Con

FDD Con

IDE1 Con

IDE2 Con

82371SB

SM4SM3SM2SM1

USB

COM2

COM1

82441FX

82442FX

FLASH BIOS

–

BAT

PENTIUM II SLOT1 Pentium II-233

KLAMATH

W49C65-03

JP11

JP1

(5V)

JP3

(3.3V)

JP9

HDDLED

SPK RESET KEYLOCK T/LED

IR CON PWRSLEEP

1FAN PWR

PCI SLOTS

ISA SLOTS

DIMM for EDP/EP DRAM

Off

SW1

Figure 1Ð1. Motherboard Layout

Chapter 2

Hardware Setup

CPU Type Configuration

CPU 3.5X Clock Setting

Pentium II (klamath) – 233/66MHz

82371SB 82441FX

Pentium II (Klamath)-233

KLAMATH

Off

SW1

Figure 2Ð1. CPU Type Configuration

Hardware Installation 5

CPU 4.0X Clock Setting

Pentium II (klamath) – 266/66 MHz

82371SB 82441FX

Pentium II (Klamath)-266

KLAMATH

Off

SW1

Figure 2Ð2. CPU Type Configuration

System Memory Configuration

This 82440FX motherboard supports 72-pin SIMMs and 168

pin DIMM of 4MB, 8MB, 16MB, or 32MB to form a memory

size between 8MB to 384MB. Each bank must have 2 pcs of

DRAM modules (w/i same size and type) installed.

82440FX chipsets provide ÒTable-FreeÓ function. It means

that users can install DRAM with any configuration and in

any bank, and that is why the DRAM table is not needed.

CPU Installation

Follow the following steps in order to install your Intel

Pentium II (Klamath) properly.

Step 1:

Be sure you are in contact with heat sink vendors for

attaching the heat sink on to the CPU.

Heat Sink

Latch

Intel Pentium II (Klamath)

CPU Side View

Heat Sink

Intel Pentium II (Klamath)

Latch

CPU Top View

Notice that the heat sink may be different from the drawings

shown here.

Step 2:

Install the 2 pairs of screws, which are shown in the

following drawing, onto the mainboard under the word

KLAMATH.

Two of the screws are right around the word of KLAMATH

and the other pair of screws should be inserted opposite the

first pair.

Tabla de contenidos

Otros manuales de Placa madre de SOLTEK

SOLTEK

SOLTEK SL-75LIV Manual de usuario

SOLTEK

SOLTEK K8AV2-R Manual de usuario

SOLTEK

SOLTEK SL-85DRV3 Manual de usuario

SOLTEK

SOLTEK SL-75MIV Manual de usuario

SOLTEK

SOLTEK SL-85DRV+ Manual de usuario

SOLTEK

SOLTEK SL-67FV1 Manual de usuario

SOLTEK

SOLTEK SL-KT880E-GR Manual de usuario

SOLTEK

SOLTEK SL-85ERV4-R Manual de usuario

SOLTEK

SOLTEK SL-85DR Manual de usuario

SOLTEK

SOLTEK SL-865G3 Manual de usuario

SOLTEK

SOLTEK 65kv Manual de usuario

SOLTEK

SOLTEK SL-85DR-C Manual de usuario

SOLTEK

SOLTEK 85MR3 Manual de usuario

SOLTEK

SOLTEK SL-85SID Manual de usuario

SOLTEK

SOLTEK 86SP2 Manual de usuario

SOLTEK

SOLTEK SL-85MR2 Manual de usuario

SOLTEK

SOLTEK 85DRV5-L Manual de usuario

SOLTEK

SOLTEK SL-B9D-FGR Manual de usuario

SOLTEK

SOLTEK SL-65EP Manual de usuario

SOLTEK

SOLTEK KT400-R Manual de usuario

SOLTEK

SOLTEK SL-75DRV5 Manual de usuario

SOLTEK

SOLTEK SL-56H5 Manual de usuario

SOLTEK

SOLTEK SL-65MIE Manual de usuario

SOLTEK

SOLTEK SL-XP865G-3IG Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario