SOLTEK SL-55B5 Manual de usuario
ii
Notice to End Users
This UserÕs Guide & Technical Reference is for assisting system
manufacturers and end users in setting up and installing the
mainboard.
Every effort has been made to ensure that the information in this
manual is accurate. Soltek Computer Inc. is not responsible for
printing or clerical errors. Information in this document is subject
to change without notice and does not represent a commitment on
the part of Soltek Computer Inc.
No part of this manual may be reproduced, transmitted, translated
into any language in any form or by any means, electronic or
mechanical, including photocopying and recording, for any purpose
without the express written permission of Soltek Computer Inc.
Companies and products mentioned in this manual are for
identification purposes only. Product names appearing in this
manual may or may not be registered trademarks or copyrights of
their respective companies.
SOLTEK COMPUTER INC. PROVIDES THIS MANUAL ÒAS ISÓ
WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OR
CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE. IN NO EVENT SHALL SOLTEK COMPUTER
INC. BE LIABLE FOR ANY LOSS OR PROFITS, LOSS OF BUSINESS, LOSS
OF USE OR DATA, INTERRUPTION OF BUSINESS, OR FOR INDIRECT,
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES OF ANY
KIND, EVEN IF SOLTEK COMPUTER INC. HAS BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES ARISING FROM ANY DEFECT OR
ERROR IN THIS MANUAL OR PRODUCT.
© Copyright 1998 Soltek Computer Inc. All right reserved
Web site: http://www.soltek.com.tw
email: [email protected]
Edition: January 1998
Version: 1.0
SL–55B5 SERIAL
Contents iii
iv
Contents
Chapter 1: Introduction --------------------------------------- 1
Features -------------------------------------------------------------------------1
CPU ------------------------------------------------------------------------1
Chipset -------------------------------------------------------------------- 1
L2 Cache ------------------------------------------------------------------1
Main Memory ----------------------------------------------------------- 1
BIOS ------------------------------------------------------------------------ 3
I/O Function -------------------------------------------------------------3
Other Functions --------------------------------------------------------- 3
Mainboard Setting for Pentium MMX-166----------------------------- 4
Chapter 2: Hardware Setup---------------------------------- 5
CPU VCORE Voltage Setting---------------------------------------------- 5
JP1: CPU VCore Voltage Setting -----------------------------------5
AGP Driver for Win95 Installation --------------------------------------6
Requirement -------------------------------------------------------------6
Installation Procedure -------------------------------------------------6
Intel Pentium MMXÐ166/200/233 CPUs ------------------------------7
AMD K6 CPU Settings------------------------------------------------------8
AMD K6 Ð 166/200/233 CPUs -------------------------------------- 8
AMD K6 Ð 266/300/333/366 CPUs -------------------------------- 9
Cyrix 6x86MX (M2) Ð PR150/166/200/233/266 CPUs----------- 10
Cyrix 6x86(L) Ð PR133+/PR150+/PR166+/PR200+ CPUs------- 11
Intel Pentium/AMD K5 Ð 133/166/200 CPUs---------------------- 12
IDT C6 Ð 200/233/266 ---------------------------------------------------- 12
System Memory Configuration----------------------------------------- 13
Jumper Settings ------------------------------------------------------------- 13
JP2: Clear CMOS Data ---------------------------------------------- 13
SW1: 1~3: CPU Clock Setting ------------------------------------- 14
IDE LED Activity Light: (J1 pin1Ð4)------------------------------ 14
Contents v
Infrared Port Module Connector (J1 pin6Ð10) ----------------- 14
J1 pin12, 13: ATX Power Button ---------------------------------- 14
J1 pin14, 15: Reserved ----------------------------------------------- 14
Speaker Connector (J2 pin1Ð4) ------------------------------------ 15
Reset Switch (J2 pin5, 6)--------------------------------------------- 15
Power LED and Keylock Switch (J2 pin8Ð12)------------------ 15
Turbo LED (J2 pin14, 15)-------------------------------------------- 16
J1 Switch Signal Summary ----------------------------------------- 17
J2 Switch Signal Summary ----------------------------------------- 18
Chapter 3: BIOS Setup ---------------------------------------19
Standard CMOS Setup ---------------------------------------------------- 20
BIOS Features Setup ------------------------------------------------------- 22
Chipset Features Setup --------------------------------------------------- 25
Power Management Setup ----------------------------------------------- 29
PnP/PCI Configuration Setup ------------------------------------------ 31
Load Setup Defaults ------------------------------------------------------- 34
Integrated Peripherals ---------------------------------------------------- 34
Supervisor/User Password---------------------------------------------- 37
IDE HDD Auto Detection ------------------------------------------------ 38
Save & Exit Setup ---------------------------------------------------------- 39
HDD Low Level Format -------------------------------------------------- 39
Exit Without Saving ------------------------------------------------------- 39
Introduction 1
Chapter 1
Introduction
Features
CPU
1. Supports Intel Pentium P54C/MMX (P55C) CPUs at 90
~ 233 MHz;
2. Supports Cyrix 6x86(L) CPUs at PR133+~ PR200+MHz
and 6x86MX (M2) CPUs at PR166+~ PR266+;
3. Supports AMD K5: PR90 ~ PR200 and AMD K6: 166 ~
366;
4. Supports IDT C6: 200 ~ 266;
5. Provides SOCKET 7 ZIF Socket;
6. Supports 75MHz CPU clock;
7. Supports CPU voltage auto detect and switching circuit.
Chipset
1. VIA Apollo VP3 chipset;
2. PCI Rev 2.1 and APM1.1 compliant.
L2 Cache
1. Onboard supports 512k write back cache with Pipelined
Burst SRAMs.
Main Memory
1. Memory range from 4MB (minimum) to 1GB
(maximum) with DRAM Table Free configurations;
2. Supports Fast Page Mode/EDO/Synchronous DRAM
with 60ns/70ns DRAM speed;
2
3. Supports 2pcs 72pin SIMM sockets and 3 pcs of 168pin
DIMM sockets (3.3V unbuffered type).
BIOS
1. AWARD Plug and Play BIOS;
2. Supports Advanced Power Management Function;
3. Flash Memory for easy upgrade.
I/O Function
1. Integrated USB (Universal Serial Bus) controller with
two USB ports;
2. Supports 2 IDE channels with 4IDE devices (including
120MB IDE floppy);
3. Provides PCI IDE Bus Master function;
4. One floppy port (including 3.5", 1.2MB Mode 3
function);
5. Two high speed 16550 FIFO UART ports;
6. One parallel port with EPP/ECP/SPP capabilities;
7. PS/2 mouse connector;
8. Infrared module connector.
Other Functions
1. ATX Form Factor with 19cm x 30.5cm;
2. 4 PCI Master slots, 3 ISA slots, and 1 AGP slot;
3. Supports SCSI/CD-ROM Boot function.
Note: 1. Make sure that the SDRAM module not only has
to be 168 pin DIMM but designed for 3.3V
unbuffered SDRAM as well. Double check with
the SDRAM supplier before install any SDRAMs.
The mainboard manufacturer has no obligation to
any damage of the board by using the incorrect
specification of SDRAM.
2. Do not mix EDO and SDRAM together for the
system stability.
Introduction 3
Mainboard Setting for Pentium MMX-166
The default settings of the following figure is for the INTEL
Pentium MMX-166 with the 512K (or 256K) cache.
+
Intel
MMX
CPU
W83877F
ISA3
ISA2
ISA1
PCI4
PCI3
PCI2
PCI1
VT82C586B
FLASH BIOS
FDC
JP2
1
J1
HD/LED IR PWR/SW
J2
T/LEDKEYLOCKRESETSPK
AGP
IDE2
IDE1
VIA
VP3
Clock
Gen
Pipelined
SRAM
Pipelined
SRAM
CPU Fan
1
JP1
7
8
2
1
On
1
Off
2
Off
3
On
4
Off
5
Off
6
ON
TAG
ATX Power
SIMM1
SIMM2
DIMM1 (Bank 0)
DIMM2 (Bank 1)
DIMM3 (Bank 2)
PRT1
COM2 COM1
USB0
USB1
PS/2
K/B
Upper
Lower
Note: DIMM3 and SIMM1/2 can’t be installed simultaneously.
(Bank 2)
Figure 1–1. SL–55B5 Motherboard Layout
4
Chapter 2
Hardware Setup
CPU V
CORE
Voltage Setting
JP1: CPU V
Core
Voltage Setting
3.1V*
3.5V
Pentium (P54C)
6x86
K5
VCore
Voltage
3.0V* 3.4V
2.9V
K6Ð166/200
6x86MX (M2)
3.3V
IDT C6
2.8V
MMX, 6x86L
3.2V*
K6Ð233
(or higher)
VCore
Voltage
2.4V2.0V
VCore
Voltage
2.5V
2.6V
2.7V
2.1V*
2.2V
K6Ð266
(or higher)
2.3V
VCore
Voltage
JP1 JP13 JP1 JP1
12
78
12
78
12
78
12
78
12
78
12
78
12
78
12
78
12
78
12
78
12
78
12
78
12
78
12
78
12
78
12
78
CPU Type VCore
Pentium (P54C), 6x86, K5 3.52V
IDT C6 3.3V
MMX (P55C) 2.8V
6x86L 2.8V
K6-166/200, 6x86MX (M2) 2.9V
K6-266 (or higher) 2.2V
Hardware Installation 5
Note: 1. Refer to the table above to choose the correct
voltage for the CPU everytime that you install a
CPU.
2. Make sure that your JP1 is matched with the
CPU voltage, otherwise will damage the CPU or
make the system unstable.
3. When the new CPU is announced and is not
listed on this manual, please refer to the above
table, select the correct voltage setting for it.
AGP Driver for Win95 Installation
Requirement
¥ Microsoft Windows95OSR2.1 (OSR2.0 with USB upgrade)
¥ Apollo VP3 AGP VxD Driver
¥ AGP VGA Card with Driver
¥ DirectX 5.0 DDK or SDK
Installation Procedure
Step1 Go to the next step if you are running
Win95OSR2.0/2.1, and if not, install Windows95
4.00.950B or later version
Step2 Install USBSUBB.EXE program (USB upgrade)
Step3 Install Apollo VP3 AGP VxD Driver, run
ÒSETUP.EXEÓ program
Step4 Install AGP driver for Windows95
Step5 Install Microsoft DirectX 5.0 DDK or SDK
To make sure if the Apollo VP3 AGP driver is properly
installed, boot up the system and run the ÒRegeditÓ to check
if the following path with VIAGARTD exists:
ÒHKEY_LOCAL_MACHINES\System\CurrentControlSet\
Services\VxDÓ.
Tabla de contenidos
Otros manuales de Placa madre de SOLTEK
SOLTEK
SOLTEK SL-B8D-F Manual de usuario
SOLTEK
SOLTEK SL-85SID Manual de usuario
SOLTEK
SOLTEK KT400-C Manual de usuario
SOLTEK
SOLTEK SL-65MIV Manual de usuario
SOLTEK
SOLTEK SL-67G60 Manual de uso y cuidado
SOLTEK
SOLTEK SL-65DRV Manual de usuario
SOLTEK
SOLTEK 75DRV Manual de usuario
SOLTEK
SOLTEK SL-85DRV+ Manual de usuario
SOLTEK
SOLTEK SL-67FV1 Manual de usuario
SOLTEK
SOLTEK 82440FX Manual de usuario
SOLTEK
SOLTEK SL-85DIR3 Manual de usuario
SOLTEK
SOLTEK SL-61A Manual de uso y cuidado
SOLTEK
SOLTEK SL-65DVB Manual de usuario
SOLTEK
SOLTEK SL-53D2 Manual de uso y cuidado
SOLTEK
SOLTEK SL-85DR-C Manual de usuario
SOLTEK
SOLTEK SL-65EB Manual de usuario
SOLTEK
SOLTEK 85ERV Manual de usuario
SOLTEK
SOLTEK SL-845GLI Manual de usuario
SOLTEK
SOLTEK SL-55F5 Manual de usuario
SOLTEK
SOLTEK 85ERV2 Manual de usuario
Manuales populares de Placa madre de otras marcas
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Manual de usuario
Gigabyte
Gigabyte GA-9IVDT Manual de usuario
Texas Instruments
Texas Instruments ADS8372EVM Manual de usuario
Commell
Commell MS-C73 Manual de usuario
IBT Technologies
IBT Technologies MB860 Manual de usuario
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manual de usuario
