Sintratec S2 Manual de uso y cuidado
Sintratec S2
Cell filter replacement
Sintratec S2 1 / 6
Version
We reserve the right to make technical changes necessary for improving the device properties which
may result in deviations from the illustrations and information contained in this manual.
All copyrights and intellectual property rights covering this device as well as all relevant
documentation remain the property of Sintratec AG.
All rights reserved.
Copyright 2019 Sintratec AG
Sintratec S2 2 / 6
Revision:
1.0 - 2020/07
Publisher:
Sintratec AG
Badenerstrasse 13
CH-5200 Brugg
Switzerland
www.sintratec.com
Contact
Tel.: +41 (0)56 552 00 22
E-mail: [email protected]
Safety
This manual is intended for the owner and skilled persons. It contains important instructions
for the operation and safety instructions additional to the associated Sintratec S2 Operating
Manual.
Required Tools
Sintratec Replacement Kit
Sintratec S2 3 / 6
description
picture
quantity
Screwdriver T20
1 pcs
Screwdriver Hex3
1 pcs
description
picture
quantity
Cell filter
ISO ePM10 50%
597x295x40 [mm]
(Product number:
PRO1356)
1 pcs
Screw
BN3803 M4x6
(or any similar
countersunk M4x6
screw)
3 pcs
Instructions
Sintratec S2 4 / 6
figure
procedure
1. Turn off the S2-MHS system.
2. Remove the filter cover by loosening
the M5x8 screws (3x) with screwdriver
Hex 3.
3. Remove both filter matts
4. Replace the hinge screws with the
delivered M4x6 screws (3x) by using
the screwdriver T20.
Sintratec S2 5 / 6
5. Fasten the filter cover by tightening the
M5x8 screws (3x) with screwdriver Hex
3.
6. Insert the cell filter in flow direction
NOTE
Direction of flow
Make sure that the filter is
inserted correctly in the
direction of flow.
Sintratec S2 6 / 6
7. Close the filter cover
8. The Material Handling Station (MHS)
is now ready to use again.
✔
Tabla de contenidos
Otros manuales de Impresora 3D de Sintratec
