Siemens Modem Block Manual de usuario

INTRODUCTION The SIEMENS Modem Block module is a component of the HUB-4 assembly. Each

Modem Block module provides 1 independent data channel.The HUB-4 can support

up to 4 independent data channels.The Modem Block module mounts on the HUB-4,

COM-2 board, which in turn mounts on the HUB -4 Main-2 board. Refer to the table

below to determine the required modules for the desired configuration.

TABLE 1

HUB-4 CONFIGURATION

Number of

Channels Required Modules

1 1 HUB-4 Main-2, 1 HUB-4 COM-2, 1 Modem Block

2 1 HUB-4 Main-2, 1 HUB-4 COM-2, 2 Modem Blocks

3 1 HUB-4 Main-2, 2 HUB-4 COM-2, 3 Modem Blocks

4 1 HUB-4 Main-2, 2 HUB-4 COM-2, 4 Modem Blocks

PRE-INSTALLATION The Modem Block module has three configuration jumpers: JP1, JP2, and JP3. Refer

to Figure 1 for the location of the jumpers. Set the jumpers to the configuration

shown in Table 2.

NOTE:

"ON" IS WHEN THE JUMPER

IS IN THE PROPER POSITION

OVER PLUGS JP1, JP2, OR JP3.

JP2 JP3

JP1

MODEM BLOCK

Figure 1

Module Block Module

Installation Instructions

Model Modem Block

Modem Block Module For HUB-4

Siemens Building Technologies

Fire Safety

P/N 315-099356-2

TABLE 2

MODEM BLOCK

JUMPER SETTINGS

JP1 ON

JP2 OFF

JP3 OFF

INSTALLATION

Disconnect BATTERY and AC prior to working on equipment.

Mounting Each Modem Block module mounts to a HUB-4, COM-2 with the 3 nylon spacers, 3

nylon screws, and 3 nylon washers provided. One HUB-4, COM-2 board can accom-

modate up to 2 Modem Block modules.

1. To begin mounting a Modem Block module on a HUB-4, COM-2 board,

place the screw end of the 3 spacers through the holes in the top of the

COM-2 board. (Refer to Figure 2.)

2. Secure the spacers in place on the underside of the HUB-4, COM-2 with

the 3 nylon nuts.

3. DO NOT place the Modem Block module on the HUB-4, COM-2 board at

this time. Reserve the 3 nylon screws provided.

4. Refer to the HUB -4 Installation Instructions, P/N 315-099458, to complete

the installation.

HOLES FOR

MOUNTING

NYLON SPACERS

HOLES FOR

MOUNTING

NYLON SPACERS

PLACE SCREW

END OF SPACER

THROUGH HOLE

IN HUB-4, COM-2

2X10PIN

RECEPTACLE

2X10PIN

RECEPTACLE

MOUNTS ONE

MODEM BLOCK

MODULE

MOUNTS ONE

MODEM BLOCK

MODULE

HUB-4,

COM-2

Figure 2

Placing Nylon Spacers For Modem Block Module On HUB-4, COM-2 Board

Siemens Building Technologies, Inc.

8 Fernwood Road

Florham Park, New Jersey 07932

Siemens Building Technologies, Ltd.

2 Kenview Boulevard

Brampton, Ontario L6T 5E4 CN P/N 315-099356-2

Tabla de contenidos

Otros manuales de Unidad de control de Siemens

Siemens

Siemens MVS661 N Series Manual de usuario

Siemens

Siemens FM 458-1 DP Manual de usuario

Siemens

Siemens SINUMERIK Series Manual de lista de piezas

Siemens

Siemens SINUMERIK 840Di sl Guía de inicio rápido

Siemens

Siemens Simatic S7-1500/ET 200MP Manual de usuario

Siemens

Siemens RCC-2/R Manual de usuario

Siemens

Siemens SIMATIC S7-1200 Manual de lista de piezas

Siemens

Siemens SINUMERIK 840D Instrucciones de funcionamiento

Siemens

Siemens SIMATIC TDC Guía del usuario

Siemens

Siemens SINORIX CPY-35 Manual de usuario

Siemens

Siemens SINAMICS S120 Documento técnico

Siemens

Siemens SIMATIC EP200SP Manual de usuario

Siemens

Siemens SIMOTION D4 Series Documento técnico

Siemens

Siemens PXC-16 Compact Manual del producto

Siemens

Siemens VKF46 Series Manual de usuario

Siemens

Siemens SINUMERIK 840D sl Manual del propietario

Siemens

Siemens SIRIUS 3RA2711 C Series Manual de usuario

Siemens

Siemens TM Timer DIDQ Guía de inicio rápido

Siemens

Siemens SIM-16RC Manual de usuario

Siemens

Siemens Synco RMZ792 Manual del operador

Siemens

Siemens SIRIUS ACT 3SU1 Guía del usuario

Siemens

Siemens SIRIUS 3RA2712 Documento técnico

Siemens

Siemens SIMATIC ET 200S IM151-1 FO STANDARD Manual de usuario

Siemens

Siemens SIMADYN D SS52 Manual de usuario

Manuales populares de Unidad de control de otras marcas

Festo

Festo Compact Performance CP-FB6-E Manual de lista de piezas

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manual de usuario

JS Automation

JS Automation MPC3034A Manual de usuario

JAUDT

JAUDT SW GII 6406 Series Guía rápida

Spektrum

Spektrum Air Module System Manual de usuario

BOC Edwards

BOC Edwards Q Series Manual de usuario

KHADAS

KHADAS BT Magic Manual de usuario

Etherma

Etherma eNEXHO-IL Manual de usuario

PMFoundations

PMFoundations Attenuverter Manual de usuario

GEA

GEA VARIVENT Manual de usuario

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manual de usuario

Altronix

Altronix LINQ8PD Instrucciones de montaje

Eaton

Eaton Powerware Series Manual de usuario

WAGO

WAGO 750-407/040-000 Manual de usuario

Sony

Sony CCU-590 Manual de usuario

Graco

Graco 25D614 Manual de usuario

Task Force Tips

Task Force Tips YE-RF-900 Manual de programación

Shini

Shini SPV-U Series Manual de usuario