INFORMATION! For some types of plants, the sequences depend on the Software and Hardware
configuration of the plant during the installation activity.
•AUTO The controller automatically manages the gensets operation, so they will be started if required by the
operating conditions.
By pressing the START button it is possible to activate/deactivate the TEST mode. If not otherwise configured, it
does not close the MGCB circuit breaker.
WARNING! The STOP button, causes the stop of the Generators (if running) and the activation
of an alarm unless configured otherwise.
PARAMETERS CONFIGURATION
WARNING! Assigning an incorrect value to one or more parameters can cause malfunctioning or
damage to things and/or people. The parameters changes must be carried out only by skilled personal.
Parameters may be password protected
In order to adjust the parameters, it is necessary to enter the PROGRAMMING menu (page P.XX).
The access to the parameters programming mode can be protected by 4different PASSWORD levels, which are
listed in order of priority.
1. SICES Password
2. Maker Password
3. System Password
4. User Password
If the password is lost, you can reconfigure it using a higher level password. Contact the technical support if
the “MAKER” password is lost.
Enter the authentication password on page 1.1.1.Authentication. To access, enter the various menus and
submenus following the path: PROGRAMMING, 1. SYSTEM, 1.1 Safety , 1.1.1. Authentication The 000-Access
Code item of the Safety menu requires the setting of the access code if one or more passwords have been
assigned. The password is not assigned if equal to 0.The set access code remains in the memory for about 10
minutes after programming has been completed. After that it must be entered again to access the programming
mode.
Parameters settings
In the PROGRAMMING page, enter the submenus with the ACK/ENTER button. Use the UP and DOWN buttons to
select the submenu required and the ACK/ENTER button to access it. Select the submenu or the parameter required
with the UP and DOWN buttons. By pressing ACK/ENTER, you enable the adjustment of the parameter value that is
signalled by the square brackets [..] flashing. Use the UP and DOWN buttons to change the value and press
ACK/ENTER to confirm or ESC/SHIFT to cancel the change. If the square brackets are replaced by the symbols < >,
it means that the change of the parameter value is not allowed. This can happen for lack of Password authorizations
or in case you are trying to change a parameter in a mode that is not allowed: some parameters can be changed only
in PROGRAM –OFF/RESET mode.Press ESC/SHIFT to exit the programming menu.
Language selection
To select a different language from the one set, view the screen S.03 (BOARD STATUS) using the navigation buttons.
To change the LANGUAGE press ACK/ENTER: the square brackets [..] will flash. Use the UP and DOWN buttons to
check the languages available, then press ACK/ENTER to confirm. ESC/SHIFT cancels the change.
Parameters for protections and alarms
The protections and the alarms usually are adjustable by means of proper variables. Usually, the intervention time
related to the protection can be configured too.
By setting the acquisition time at 0 (zero), the protection is deactivated.
