Samsung MWR-WW00 Manual de usuario

DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 26 2013-01-09 오후 2:48:45

Wired Remote Control

MWR-WW00

Air Conditioner

installation manual

imagine the possibilities

Thank you for purchasing this Samsung product.

To receive more complete service, please

www.samsung.com/register

DB68-03647A(1)

AREN ES

PT DE

DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 27 2013-01-09 오후 2:48:45

Safety Information

This installation manual explains how to install a wired remote controller connected to a Hydro Unit. Please read this manual

thoroughly before installing the remote controller.

(Please refer to the corresponding installation manual for product and other optional installation.)

WARNING Hazards or unsafe practices that may result in severe personal injury or death.

CAUTION Hazards or unsafe practices that may result in minor personal injury or property damage.

WARNING

Contact a service center for installation.

fFailure to do so may result in product malfunction, water leak, electric shock and ﬁre.

Install the product with rated power supply.

fFailure to do so may result in ﬁre or damage to a wired remote controller.

Do not modify or repair the wired remote controller yourself.

fFailure to do so may result in product malfunction, electric shock, and ﬁre.When you need to repair the product, you

should contact a service center.

All the electric work should be performed in accordance with local regulation and installation manual by a certiﬁed

technician.

fFailure to do so may result in product malfunction, electric shock and ﬁre due to defect.

Install the product on a hard and even surface that can support its weight.

fIf the surface cannot support its weight, the wired remote controller may fall down and it may cause product damage.

Do not move or reinstall the connected wired remote controller yourself.

fFailure to do so may result in electric shock and ﬁre.

Check whether the installation work is correctly performed in accordance with installation manual.

fWhen the wired remote controller is incorrectly installed, electric shock and ﬁre may occur.

When disposing of the wired remote controller, please contact a service center.

DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 2 2013-01-09 오후 2:48:39

ENGLISH

CAUTION

Do not install the product where inﬂammable content may leak.

fFailure to do so may result in ﬁre and explosion.

Ensure no water gets into the wired remote controller.

fFailure to do so may result in electric shock and ﬁre.

Install the air conditioner away from direct exposure to sunlight, in room temperature range of 0°C(32°F)~39°C(102°F).

fFailure to do so may result in electric shock or abnormal operation.

Do not handle the product with sharp objects.

fFailure to do so may result in electric shock or part damage.

Do not install the product in speciﬁc areas exposed to oil or vapor.

fFailure to do so may result in part damage or abnormal operation.

Do not put undue stress on the power cable.

fFailure to do so may result in broken cable and ﬁre.

Do not install the product in areas where acid or alkali liquid or special spray are used.

fFailure to do so may result in electric shock or abnormal operation.

Do not connect power cable to a communication terminal.

fFailure to do so may result in ﬁre.

Be cautious not to interfere with any other electrical devices if the product is installed in a place such as hospital.

fFailure to do so may result in abnormal operation.

DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 3 2013-01-09 오후 2:48:39

Wired Remote Controller Installation

Accessories

Name Wired remote

controller Cable tie Cable clamp M4X16 Screw User Manual Installation

Manual U-Terminal

Quantity 1235116

Shape

• The wired remote controller should be installed by a certiﬁed technician.

• Check and conﬁrm the power is oﬀ before installing your wired remote controller.

• Install the wired remote controller cables in accordance with the electrical wiring regulation, and allow it to pass

through the inner area of the wall so that other people can’t reach it.

CAUTION

External Dimensions

120(4.72)

124(4.88)

63.8(2.51)

19.5(0.76)

Unit : mm(inch)

DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 4 2013-01-09 오후 2:48:40

ENGLISH

1. Push the two hooks at the bottom of your Wired Remote Controller at the same time, and then pull up the front cover to

separate it from the rear cover.

❋ Push the two hooks at the same time.

• Insert a ﬂat head screwdriver into the square groove in the upper area of the hook

to disassemble it easily.

NOTE

2. Arrange the power cable and the communication cable so that they ﬁt in the housing along the edges of the rear cover.

If you need more space for the wiring

work, you can take it oﬀ.

15cm(5.90)

10cm(3.93)

DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 5 2013-01-09 오후 2:48:40

Wired Remote Controller Installation

3. Using more than two screws, ﬁrmly aﬃx the rear cover of the remote controller to the wall, and then connect the

power(V1,V2) and communication cables(F3, F4), making sure these cables have reasonable length, to the terminal at

the back of the cover.

10mm (0.4 inch) or more

10mm (0.4 inch)

or more

50mm (2 inch) or more

10mm (0.4 inch) or more

Rear cover

Screw hole

Wire (not supplied)

PCB terminal

Front cover

Wired remote

controller

Hydro Unit

PCB

❋ Before ﬁxing the rear cover, allow

at least 10mm(0.4 inch) space of

upper side, left side, right side, and

50mm(2inch) space of bottom side.

❋ You must ﬁt the screws into the

screw holes.

❋ Do not tighten the screws on the

PCB terminal with excessive force.

4. Reassemble your wired remote controller.

• Align the controller with the upper groove ﬁrst, and insert it by turning it downward as shown in the

ﬁgure. After assembly, check and conﬁrm that no wires are stuck in the gap between the rear and

front cover.

NOTE

DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 6 2013-01-09 오후 2:48:40

ENGLISH

• When installing a wired remote controller by using a cable longer than 10m, you must install the

communication cable and the power cable separately. (Electrical interference can cause your wired remote

controller to malfunction.)

• When installing your wired remote controller on the wall, consider the size of the wire hole, and select a wire

with a proper thickness.

• Wire that is connectable to wired remote controller PCB.

- If you install the wired remote controller by reclaiming, install it according to U-terminal cable speciﬁcation.

- If you install the wired remote controller by using four pieces of PVC wire, remove the 30cm(12inch) of the

sheath of the cable and install it only with the four pieces of wires. (Recommended speciﬁcation: AWG21)

- The followings are the specs of the compressed ring terminal connectable to your wired remote controller PCB

Range of Permitted

Wires Rated Size Stud Size Basic Size (mm)

AWG mm2mm2mm t øD G E F W L

22~16 0.25 ~ 1.65 1.5 3 0.7 3.8 10.0 4.5 6.5 6.0 21.2

❋ Maximum distance for connection between communication cable and power

cable: 100m

Stud D

- ScrewsonthePCBterminalmustbetightenedwithlessthan6N•mtighteningtorque.Ifthetighteningtorque

is greater, it may damage the screw thread.

CAUTION

Model name Work pressure Work temperature Water pipe

connection part Mesh Size Material (Strainer/Mesh)

RD080D✴✴✴✴

RD100D✴✴✴✴ 1.96 MPa -5~45°C ø44.45 (Internal

thread) 50 Mesh AISI316/SUS304

DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 7 2013-01-09 오후 2:48:40

Wired remote controller installation

Tracking Hydro Unit from a wired remote controller

The number of Hydro Unit currently detected

Display tracking is

being performed.

1. Tracking of your wired remote controller will automatically start when you turn on the power after installation.

2. If you want to perform tracking again after installation, press the Esc and Delete buttons at the same time for more

than 5 seconds.

fThe system will reset, and tracking will start again.

3. During the tracking, the total number of currently searched Hydro Unit will be displayed.

• If you want to do system reset for your wired remote controller, press the Esc and Delete buttons at the same

time for more than 5 seconds.

• Only the master wired remote controller can display the total number of Hydro Units.

- Slave wired remote controllers do not display the total number of Hydro Units.

CAUTION

DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 8 2013-01-09 오후 2:48:40

ENGLISH

Individual control with your wired remote controller

fIndividual control means that you are using one remote controller to control one indoor unit or one Hydro Unit.

When connecting the Hydro Unit only

Outdoor unit

COM1(F1, F2)

COM2(F3, F4) COM2(F3, F4)COM2(F3, F4)

COM1(F1, F2)

Hydro

Unit

Wired remote

controller

Wired remote

controller

Wired remote

controller

Hydro

Unit

Hydro

Unit

• Regardless of the Hydro Unit group address (RMC address) setting, only the Hydro Unit connected to COM2 is

individually controlled.

• The power cable (V1, V2) is not connected between Hydro Units.

CAUTION

DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 9 2013-01-09 오후 2:48:41

Otros manuales para MWR-WW00

Tabla de contenidos

Otros manuales de Mando a distancia de Samsung

Samsung

Samsung MWR-WE10N Manual de usuario

Samsung

Samsung MWR-WH01 Manual de usuario

Samsung

Samsung MWR-SH00 Manual de usuario

Samsung

Samsung MWR-WH00 Manual de usuario

Samsung

Samsung RMCSPA1EP1 Manual de usuario

Samsung

Samsung RMC30C2 Manual de usuario

Samsung

Samsung MWR-WE10 Manual de usuario

Samsung

Samsung SolarCell Remote Manual de usuario

Samsung

Samsung ERV Guía

Samsung

Samsung MWR-AH01 Manual de usuario

Samsung

Samsung SMART TV Manual de usuario

Samsung

Samsung MWR-WG00RN Manual de usuario

Samsung

Samsung MWR-TH00 Manual de usuario

Samsung

Samsung MWR-WE10N Manual de usuario

Samsung

Samsung UE43MU6179UXZG Manual de usuario

Samsung

Samsung MWR-SC00T Manual de usuario

Samsung

Samsung SolarCell Remote Manual de usuario

Samsung

Samsung RMC-QTD1 Manual de usuario

Samsung

Samsung MWR-WE10N Manual de usuario

Samsung

Samsung MWR-BS00 Manual de usuario

Samsung

Samsung HW-S40T Manual de usuario

Samsung

Samsung MR-BH01 Manual de usuario

Samsung

Samsung SolarCell Remote Manual de usuario

Samsung

Samsung MWR-SH11N Manual de usuario

Manuales populares de Mando a distancia de otras marcas

Panasonic

Panasonic EUR7622KB0 Manual de usuario

Bang & Olufsen

Bang & Olufsen Beo4 Manual de usuario

Sunwave Tech.

Sunwave Tech. RemoteComm SRC-7000 Manual de usuario

Multiplex

Multiplex PROFI TX 9 Manual de usuario

One Remote

One Remote RMB4 Manual de usuario

FUTABA

FUTABA 9ZAP - PART2 Manual de usuario

HR Matic

HR Matic HR MULTI 3 Manual de usuario

Yamaha

Yamaha ACC-GNRST-30-20 Manual de usuario

EisSound

EisSound KBSOUND Manual de usuario

Marantz

Marantz RC101 Manual de usuario

Conrad

Conrad FS20 TC6 Manual de usuario

Anritsu

Anritsu MP1777A Manual de usuario

Niles

Niles WVC100 Guía de solución de problemas

RCA

RCA RCU1300 Manual de usuario

Bang & Olufsen

Bang & Olufsen BEO6 Manual de usuario

GE 94901 Manual de usuario

Onbon

Onbon YQ1-75 Manual de usuario

FUTABA

FUTABA R7108SB Instrucciones de instalación