Samsung MWR-SH11N Manual de usuario

Air conditioner

Installation manual

Wired remote controller MWR-SH11N

• Thank you for purchasing this Samsung Product.

• Before operating this unit, please read this installation manual carefully and retain it for future

reference.

DB68-08073A-00

SOL 터치간단유선 유럽향 IM_EN_DB68-08073A-00.indd 1 2018-10-11 오후 3:35:04

ENGLISH-2

The lowest set temperature is limited to 20 degree in the UAE according to UAE.S 5010-5:2016.

Contents

Preparation

Safety precautions ....................................................................................................... 3

Before installation ....................................................................................................... 5

Installation

Wired remote controller installation ...................................................................................... 6

Others

Wired remote controller installation/service mode ...................................................................... 15

SOL 터치간단유선 유럽향 IM_EN_DB68-08073A-00.indd 2 2018-10-11 오후 3:35:04

ENGLISH-3

01 PREPARATION

Safety precautions

This installation manual explains how to install a wired remote controller connected to the indoor unit of your Samsung

system air conditioner. Please read this manual thoroughly before installing the product.

(Please refer to appropriate installation for any optional product installation.)

WARNING Hazards or unsafe practices that may result in severe personal injury or death.

CAUTION Hazards or unsafe practices that may result in minor personal injury or property

damage.

WARNING

Contact a service center for installation.

 Potential risk of malfunction, water leak, electric shock and re.

Install the product with proper power supply.

 Potential risk of re or product damage.

Consult the place of purchase or a contact center to disassemble or repair the product.

 Potential risk of malfunction, electric shock, or re.

The electric work must be done by qualied person according to national wiring regulations and installation guide.

 If an unauthorized person performs the installation, any resulting defects can cause malfunctions, electrical shocks, or re

accidents.

Install the product on a hard and even place that can support its weight.

 If the place cannot support its weight, the product may fall down and it may cause product damage.

Do not move or reinstall the product on your discretion.

 Potential risk of electric shock or re.

Check if the installation work is done correctly according to the installation manual.

 Incorrect installation may cause electric shock or re.

When you want to dispose your wired remote controller, ask the service center.

Preparation

SOL 터치간단유선 유럽향 IM_EN_DB68-08073A-00.indd 3 2018-10-11 오후 3:35:04

ENGLISH-4

Safety precautions

CAUTION

Do not install the product where there’s combustible gas.

 Potential risk of re and explosion.

Ensure no water gets into the wired remote controller.

 Potential risk of electric shock or re.

Install the air conditioner away from direct exposure to sunlight, in room temperature range of

0 °C(32 °F) ~ 39 °C(102 °F).

 Potential risk of electric shock or malfunction.

Do not handle the product with sharp objects.

 Potential risk of electric shock or product damage.

Do not install the product in areas exposed to oil or vapor.

 Potential risk of product damage or malfunction.

Do not put undue stress on the power cable.

 Potential risk of broken cable and re.

Do not install the product in areas with frequent use of acid or alkali spray.

 Potential risk of electric shock or product malfunction

Do not connect power cable to a communication terminal.

 Potential risk of re.

Be cautious not to interfere any other electrical devices if the product is installed in a place such as hospital.

 Potential risk of product malfunction.

Please take the product gently after unpacking the package.

 Drop or throwing can lead to the potential risk of product damage.

SOL 터치간단유선 유럽향 IM_EN_DB68-08073A-00.indd 4 2018-10-11 오후 3:35:04

ENGLISH-5

01 PREPARATION

Before installation

Optional accessories

Wired remote

controller (1) M4x16 screw (4) User manual (1) Installation manual (1)

• The wired remote controller should be installed by an installation expert.

• Check and conrm the power is o before installing your wired remote controller.

• Install the wired remote controller cables in accordance with the electrical wiring rules, and allow it to pass

through the inner area of the wall so that other people can’t reach it.

CAUTION

External dimensions

119.9 (4.722)

93.5 (3.682)

19.7

(0.776)

[Unit : mm(inch)]

SOL 터치간단유선 유럽향 IM_EN_DB68-08073A-00.indd 5 2018-10-11 오후 3:35:05

ENGLISH-6

Wired remote controller installation

1. Insert a small at head screwdriver into the square groove in the bottom of your wired

remote controller, and then pull up the front cover to separate it from the rear cover.

2. Arrange the communication cable so that they t in the housing along the edges of the rear cover.

Remove it

< When the cable is not concealed > < When the cable is concealed >

5 cm (2 inch) 5 cm

(2 inch)

Installation

SOL 터치간단유선 유럽향 IM_EN_DB68-08073A-00.indd 6 2018-10-11 오후 3:35:05

ENGLISH-7

02 INSTALLATION

4. Reassemble your wired remote controller.

•

lign the controller with the upper groove rst, and insert it by turning it downward as

shown in the gure.

After assembly, check and conrm that no wires are stuck in the gap between the rear and

front cover.

•

When installing a wired remote controller by using a cable longer than 10 m(32.80 ft), you must install the communication cable

and the power cable separately. (Electrical interference can cause your wired remote controller to malfunction.)

• When installing your wired remote controller on the wall, consider the size of the wire hole, and select a wire with a proper

thickness.

• If you install the wired remote controller by using two pieces of PVC wire, remove the 30 cm (12 inch) of the

sheath of the cable and install it only with the two pieces of wires. (Recommended specication: AWG20)

• Maximum distance for connecting communication and power cable : 100 m (328 ft).

•

Screws on the PCB terminal must be tightened with less than 6N-cm tightening torque. If the tightening torque is

greater, it may damage the screw thread.

3. Using more than two screws, rmly ax the rear cover of the remote controller to the wall, and then connect the

communication and power cable [(F3,F4) or (3, 4)], making sure these cables have reasonable length, to the terminal at

the back of the cover.

F1 F2 V1 V2 F3 F4

F3 F4

10 mm(0.4 inch) or more

10 mm(0.4 inch)

or more

10 mm(0.4 inch) or more

Screw hole

Rear cover

Front cover

PCB terminal

Wire (not supplied)

Before fixing the rear cover, secure at least

10 mm (0.4 inch) space of upper side, left

side, right side, and bottom side.

You must fit the screws into

the screw holes.

Indoor unit

Wired remote

controller

Do not tighten the screws on the

PCB terminal with excessive force.

CAUTION

SOL 터치간단유선 유럽향 IM_EN_DB68-08073A-00.indd 7 2018-10-11 오후 3:35:05

ENGLISH-8

Wired remote controller installation

Tracking your indoor unit from the wired remote controller

Displays the total number of indoor units searched

Indicates tracking in progress

1. Tracking of your wired remote controller will automatically start when you turn on the power after installation.

2. If you want to perform tracking again after installation, then press the top right corner (hidden button) of the display for

more than 7 seconds.

- The system will reset, and tracking will start again.

3. During tracking, the total number of currently searched indoor units will be displayed.

4. It may take about 3 minutes at initial installation or when you re-set the power master setting.

• If you want to reset the system of your wired remote controller, then press the top right corner (hidden button) of

the display for more than 7 seconds.

CAUTION

SOL 터치간단유선 유럽향 IM_EN_DB68-08073A-00.indd 8 2018-10-11 오후 3:35:05

ENGLISH-9

02 INSTALLATION

Individual control with your wired remote controller

Individual control means that you are using one remote controller to control one indoor unit.

Outdoor unit

Indoor unit

COM1(F1, F2)

COM2(F3, F4)

COM1(F1, F2)

COM2(F3, F4) COM2(F3, F4)

Wired remote

controller

Wired remote

controller

Wired remote

controller

Indoor unit Indoor unit

• Regardless of the indoor group address (RMC address) only the indoor unit connected to COM2 is individually

controlled.

CAUTION

SOL 터치간단유선 유럽향 IM_EN_DB68-08073A-00.indd 9 2018-10-11 오후 3:35:05

ENGLISH-10

Wired remote controller installation

Group control with your wired remote controller

Group control means that you are using one wired remote controller to control two or more indoor units at the same time.

1. Using one wired remote controller to control three indoor Units

Outdoor unit

COM1(F1, F2) COM1(F1, F2)

Wired remote

controller

COM2(F3, F4) COM2(F3, F4)

COM1(F1, F2)

Indoor unit Indoor unit Indoor unit

2. Using one wired remote controller to control indoor units connected to dierent outdoor unit

Outdoor unit

Indoor unit

Wired remote

controller

Outdoor unit

COM1(F1, F2)

COM2(F3, F4)

COM1(F1, F2)

COM2(F3, F4)

• Regardless of the indoor unit’s group address (RMC address), only the indoor units connected to COM2 are

controlled in group.

• Regardless of your outdoor units, you can control a maximum of 16 indoor units as a group.

• When controlling group of indoor units connected to dierent outdoor unit, address of the each outdoor unit

must be set dierently.

CAUTION

SOL 터치간단유선 유럽향 IM_EN_DB68-08073A-00.indd 10 2018-10-11 오후 3:35:06

Otros manuales para MWR-SH11N

Tabla de contenidos

Otros manuales de Mando a distancia de Samsung

Samsung

Samsung MWR-BS00 Manual de usuario

Samsung

Samsung SolarCell Remote Manual de usuario

Samsung

Samsung SRF1 Guía de instalación

Samsung

Samsung MWR-SH00 Manual de usuario

Samsung

Samsung CU7172 Manual de usuario

Samsung

Samsung SMART TV Manual de usuario

Samsung

Samsung RMCSPA1EP1 Manual de usuario

Samsung

Samsung MR-BH01 Manual de usuario

Samsung

Samsung MR-AH01C Manual de usuario

Samsung

Samsung SolarCell Remote Manual de usuario

Samsung

Samsung SolarCell Remote Manual de usuario

Samsung

Samsung LED-C9000 RMC30C1 Manual de usuario

Samsung

Samsung MWR-TH00 Manual de usuario

Samsung

Samsung MWR-WE10N Manual de usuario

Samsung

Samsung MWR-WE13N Manual de usuario

Samsung

Samsung BN68-03092A-02 Manual de usuario

Samsung

Samsung MWR-WE10N Manual de usuario

Samsung

Samsung MWR-SH10N Manual de usuario

Samsung

Samsung MWR-WE11N Manual de usuario

Samsung

Samsung SolarCell Remote Manual de usuario

Samsung

Samsung MWR-SH00 Manual de usuario

Samsung

Samsung UE43MU6179UXZG Manual de usuario

Samsung

Samsung NS052LHXEA Manual de usuario

Samsung

Samsung MWR-WE10 Manual de usuario

Manuales populares de Mando a distancia de otras marcas

Panasonic

Panasonic EUR7622KB0 Manual de usuario

Bang & Olufsen

Bang & Olufsen Beo4 Manual de usuario

Sunwave Tech.

Sunwave Tech. RemoteComm SRC-7000 Manual de usuario

Multiplex

Multiplex PROFI TX 9 Manual de usuario

One Remote

One Remote RMB4 Manual de usuario

FUTABA

FUTABA 9ZAP - PART2 Manual de usuario

HR Matic

HR Matic HR MULTI 3 Manual de usuario

Yamaha

Yamaha ACC-GNRST-30-20 Manual de usuario

EisSound

EisSound KBSOUND Manual de usuario

Marantz

Marantz RC101 Manual de usuario

Conrad

Conrad FS20 TC6 Manual de usuario

Anritsu

Anritsu MP1777A Manual de usuario

Niles

Niles WVC100 Guía de solución de problemas

RCA

RCA RCU1300 Manual de usuario

Bang & Olufsen

Bang & Olufsen BEO6 Manual de usuario

GE 94901 Manual de usuario

Onbon

Onbon YQ1-75 Manual de usuario

FUTABA

FUTABA R7108SB Instrucciones de instalación