Samlexpower SA-1000K Series Manual de usuario
SA-1000K & SA-3000K Series
Pure Sine Wave Inverter
User’s Manual
Table of Contents
1. Important Safety Information.……………………………………………… 1
1-1 General Safety Precautions…………………………………………… 1
1-2 Battery Precautions………………………..………………………….. 1
2. Features………………………………………………………………………...2
2-1 Application………………………………………………………………. 2
2-2 Electrical Performance…………………………………………………3~4
2-3 Mechanical Drawings………………………………………………….. 5~6
3. Introduction……………………………………………………………………7
3-1 Front Panel operation….……………………………………………... 7~10
3-2 Rear Panel operation.………………………………………………… 11~12
3-3 Protections Features…………………………………………………… 12
3-4 Installation………………………………………………………………. 13
3-5 Making DC Wiring Connections ……………………………………... 14~16
3-6 AC Safety Grounding………………………………………………….. 17
3-7 Inverter Operation……………………………………………………… 18
4. Troubleshooting guide………………………………………………………19
5. Maintenance…………………………………………………………………… 20
6. Warranty……………………………………………………………………….. 20
1. Important Safety Instructions
1-1. General Safety Precautions
1-1-1. Do not expose the Inverter to rain, snow, spray, bilge or dust.
To reduce risk of hazard, do not cover or obstruct the ventilation
openings. Do not install the Inverter in a zero-clearance compartment.
Overheating may result.
1-1-2. To avoid a risk of fire and electronic shock, make sure that existing
wiring is in good electrical condition and not undersized.
Do not operate the Inverter with damaged or substandard Wiring.
1-1-3. There are some components in the inverter can cause arcs and sparks.
To prevent from fire or explosion, do not put batteries, flammable
materials, or anything should be ignition–protected around the inverter.
1-2. Precautions When Working with Batteries
1-2-1. If battery acid contacts skin or clothing, you shall wash it out with soap
and water immediately. If battery acid contacts your eyes, you shall
wash it out with cold running water for at least 20 minutes and get
medical attention immediately.
1-2-2. Never smoke or make a spark or flame in the vicinity of the battery or
the engine.
1-2-3. Do not drop a metal tool on the battery. The resulting spark or
short-circuit on the battery of other electrical part may cause an
explosion.
1-2-4. Remove personal metal items such as rings, bracelets, necklaces,
and watches when operating with a lead-acid batteries.
Doing so may cause short circuit and very high temperature, which can
melt metal items and even burn you.
WARNING!
Before using the Inverter, read and save the safety
instructions.
1
1
2. Features
Pure sine wave output (THD < 3%)
Output frequency：50 / 60Hz switch selections
Input & output fully isolated design
Power Saving Mode to conserve energy
High efficiency 89~94%
Driving highly reactive & capacitive loads at start moment
Tri-Color indicators show input voltage & output load level
Loading controlled cooling fan
Advanced microprocessor
Protection：Input low voltage Overload Short circuit
Low battery alarm Input over voltage Over temperature
2-1. Application
2-1-1. Power tools – circular saws, drills, grinders, sanders, buffers, weed
and hedge trimmers, air compressors, etc.
2-1-2. Office equipment – computers, printers, monitors, facsimile machines,
scanner, etc.
2-1-3. Household appliances – vacuum cleaners, fans, fluorescent and
incandescent lights, shavers, sewing machines.
2-1-4. Kitchen appliances – coffee makers, blenders, ice markers, toasters,
etc.
2-1-5. Industrial equipment – metal halide lamp, high – pressure sodium lamp,
etc.
2-1-6. Home entertainment electronics – television, VCRs, video games,
stereos, musical instruments, satellite equipment, etc.
2
2-2. Electrical Performance
Specification Model No.
Item SA-1000K-112 SA-1000K-124
Continuous Output Power 1000W
Maximum Output Power 1100W
Surge Rating (Max) 2000W
Input voltage 12V 24V
OutputVoltage 100 / 110 / 120V +/- 5%
Frequency
(Switch Selectable) 50 / 60Hz +/-0.05%
OutputWaveform Pure Sine Wave (THD < 3% )
Efficiency (full load) Max. *1 89.0% 92.0%
No Load Current Draw (Max.) 1.43A 0.75A
Stand-By Current Draw (Max.) 0.25A 0.15A
Input Voltage Regulation 10.5-15
VDC
21.0-30
VDC
InputLevel Indicator
Red / Orange / Green LED
Load Level Indicator
Failure Indicator Red LED
Protection Overload, Short Circuit, Reverse Polarity(Fuse),
Over / Under Input Voltage, Over Temperature.
Remote Control Unit S-R8, S-R6-12, S-R6-24 Optional
Safety Certification UL458 EN60950-1
EMC FCC Class A
EN55022: 1997
EN55024: 1997
EN61000-3-2:
1998
EN61000-3-3:
1995
e-mark
e13 022694
Operating Temperature Range 0 - 40 ℃
Storage Temperature Range -30℃to 70℃
CoolingLoading controlled cooling fan
Dimensions 383(L)*182(W)*88(H)mm / 15.08(L)*7.17(W)*3.46(H) Inch
Weight 4 kg / 8.8 Lbs.
Note: The specifications are subject to change without notice.
3
SpecificationModel No.
Item SA-3000K-112 SA-3000K-124
Continuous Output Power 3000W
Maximum Output Power 3300W
Surge Rating (Max) 6000W
Input voltage 12V 24V
OutputVoltage 100 / 110 / 120V +/- 5%
Frequency
(Switch Selectable) 50 / 60Hz +/-0.05%
OutputWaveform Pure Sine Wave (THD < 3% )
Efficiency (full load) Max. *1 88.0% 91.0%
No Load Current Draw (Max) 3.0A 1.6A
Stand-By Current Draw (Max) 0.55A 0.35A
Input Voltage Regulation 10.5-15
VDC
21.0-30
VDC
InputLevel Indicator
Red / Orange / Green LED
Load Level Indicator
Failure Indicator Red LED
Protection Overload, Short Circuit, Reverse Polarity(Fuse),
Over / Under Input Voltage, Over Temperature.
Remote Control Unit S-R8, S-R6-12, S-R6-24 Optional
Safety Cert. Meet UL458 EN60950-1
EMC FCC Class A
EN55022: 1997
EN55024: 1997
EN61000-3-2: 1998
EN61000-3-3: 1995
e-mark
e13 22845
Operating Temperature Range 0 - 40 ℃
Storage Temperature Range -30℃to 70℃
CoolingLoading controlled cooling fan
Dimensions 452(L)*208(W)*166(H)mm / 17.80(L)*8.18(W)*6.53(H) Inch
Weight 9.8 kg / 22 Lbs.
Note: The specifications are subject to change without notice.
*1. This test condition is normal DC input (13.5V) and Temperature 25℃
4
2-3. Mechanical Drawings
5
REMOTE
PORT
CHASSIS
GROUND
SA-1000K 340.00 [13.39]
196.00 [7.72]
SK700 71.50[2.83]
SK1000 88.00[3.46]
SK1500 88.00[3.46]
182.00[7.17]
191.00[7.52]
SA-1000K 154.00 [6.06]
S3
S2
PWR.
SAV.
I
O
S1
LOAD
LEVEL
INPUT
LEVEL
S4
STATUS
FREQ.
1000W
Pure Sine Wave Power Inverter
POS(+) NEG(-)
DC INPUT
REVERSE POLARITY
WILL DAMAGE UNIT
PURE SINE WAVE INVERTER
AC OUTPUT
ONON
REMOTE
OFF
I
0
245.00 [9.65]
SA-3000K 398.00 [15.67]
Pure Sine Wave Power Inverter
165.25 [6.51]
209.00 [8.23]
AC OUTPUT
PURE SINE WAVE INVERTER
S4 FREQ.
S2
S1
S3 PWR.
SAV.
O I
0REMO.
LOAD
LEVEL
STATUS
INPUT
LEVEL
OFF
ON
I
177.00 [6.97]
2000W
3000W
6
3. Introduction
This power inverter series is one of the most advanced line of mobile AC power
systems. To get the most effective power inverter, it must be installed and used
properly.
Please read the instructions of this manual before you install and operate
this model.
3-1. Front Panel Operations：
3-1-1. Front view：
3-1-2. ON / OFF/ REMOTE (Main) switch：
a. Before installing the inverter, you need to ensure the main switch
must be “OFF”.
b. Before using the remote unit, you need to ensure the main switch
must be “REMOTE”.
7
PURE SINE WAVE INVERTER
AC OUTPUT
OFF
REMOTE
I
0
ON
S1
PWR.
SAV.
O I
INPUT
LEVEL
FREQ.
STATUS
S4
LOAD
LEVEL
S2
S3 SA-1000K
0
S4
S3
S1
S2
O
SA-3000K
FREQ.
PWR.
SAV.
LOAD
LEVEL
STATUS
INPUT
LEVEL
I
AC OUTPUT
PURE SINE WAVE INVERTER
REMO.
I
ON
OFF
3-1-3. Input Level：Display Input Voltages
LED Status DC 12V DC 24V
RED Slow Blink 10.3~10.6 20.5~21.2
RED10.6~11.021.2~21.8
ORANGE 11.0~12.1 21.8~24.1
GREEN 12.1~14.2 24.1~28.6
ORANGE Blink 14.2~15.0 28.6~30.0
OVER RED Blink 15.0 30.0
3-1-4. Load Level：Display AC Loads (Watts)
LED status DARK GREEN ORANGE RED RED BLINK
SA-1000K0~ 80W 80 ~ 330W 330 ~ 750W 750 ~ 960W Over 960W
SA-3000K0~ 240W 240 ~ 990W 990 ~ 2250W 2250 ~ 2880W Over 2880W
3-1-5. AC Frequency：Selected by “S4” Dip Switch
Frequency S4
50 HZ OFF
60 HZ ON
8
Este manual sirve para los siguientes modelos
5
Tabla de contenidos
Otros manuales de Inversor de Samlexpower
Samlexpower
Samlexpower Evolution EVO-4248SP Manual de usuario
Samlexpower
Samlexpower PST-300-12 Manual de usuario
Samlexpower
Samlexpower SAM-250-12 Manual de usuario
Samlexpower
Samlexpower PST-100S-12A Manual de usuario
Samlexpower
Samlexpower PST-300S-12E Manual de usuario
Samlexpower
Samlexpower PSE-12125A Manual de usuario
Samlexpower
Samlexpower PST-600-12 Manual de usuario
Samlexpower
Samlexpower PST-60S-24A Manual de usuario
Samlexpower
Samlexpower PST-600-48 Manual de usuario
Samlexpower
Samlexpower PST-120-12 Manual de usuario
Samlexpower
Samlexpower SSW-350-12A Manual de usuario
Samlexpower
Samlexpower SA-1500 Series Manual de usuario
Samlexpower
Samlexpower Evolution EVO-2212 Manual de usuario
Samlexpower
Samlexpower Pure Sine PST-1500-12 Manual de usuario
Samlexpower
Samlexpower PST-60S-48E Manual de usuario
Samlexpower
Samlexpower SSW-350-12A Manual de usuario
Samlexpower
Samlexpower PSE-12125A Manual de usuario
Samlexpower
Samlexpower PST-12S-12A Manual de usuario
Samlexpower
Samlexpower SAM-100-12 Manual de usuario
Samlexpower
Samlexpower SI-A1-VR1500 Manual de usuario
