Prorack K868 Manual de usuario
K868
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 4 x 4 x 4 x 4
x 1
Revision No: 2B 1
Fitting Kit K868
MAX kgs (lbs)
W/P WHD
Mercedes-Benz
Tourer, 5dr Van 14-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Tourer, 5dr Van 15-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
Valente, 5dr Van 15-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Valente, 5dr Van 15-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
Vito 2 Bar, 4dr Van 14-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Vito 2 Bar, 4dr Van 14-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
Vito 2 Bar, 4dr Van 14-+ CN 75 kgs (165 lbs) 75 kgs (165 lbs)
Vito 2 Bar, 4dr Van 15-+ US 75 kgs (165 lbs) 75 kgs (165 lbs)
Vito 2 Bar, 4dr Van Aug 15-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
Vito 2 Bar, 4dr Van Jul 15-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Vito, 4dr Van 04-14 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
2
Fitting Kit K868
X
A B C 1 2 3
Tourer, 5dr Van 14-+ (EU) 245mm 1085mm - 1105mm 1125mm -
9 5/8ths" 42 11/16ths" - 43 1/2ths" 44 5/16ths" -
Tourer, 5dr Van 15-+ (ZA) 245mm 1085mm - 1105mm 1125mm -
9 5/8ths" 42 11/16ths" - 43 1/2ths" 44 5/16ths" -
Valente, 5dr Van 15-+ (AU) 245mm 1085mm - 1105mm 1125mm -
9 5/8ths" 42 11/16ths" - 43 1/2ths" 44 5/16ths" -
Valente, 5dr Van 15-+ (NZ) 245mm 1085mm - 1105mm 1125mm -
9 5/8ths" 42 11/16ths" - 43 1/2ths" 44 5/16ths" -
Vito 2 Bar, 4dr Van 14-+ (EU) 330mm 1080mm - 1115mm 1135mm -
13" 42 1/2ths" - 43 7/8ths" 44 11/16ths" -
Vito 2 Bar, 4dr Van 14-+ (ZA) 330mm 1080mm - 1115mm 1135mm -
13" 42 1/2ths" - 43 7/8ths" 44 11/16ths" -
Vito 2 Bar, 4dr Van 14-+ (CN) 330mm 1080mm - 1115mm 1135mm -
13" 42 1/2ths" - 43 7/8ths" 44 11/16ths" -
Vito 2 Bar, 4dr Van 15-+ (US) 330mm 1080mm - 1115mm 1135mm -
13" 42 1/2ths" - 43 7/8ths" 44 11/16ths" -
Vito 2 Bar, 4dr Van Aug 15-+ (NZ) 330mm 1080mm - 1115mm 1135mm -
13" 42 1/2ths" - 43 7/8ths" 44 11/16ths" -
Vito 2 Bar, 4dr Van Jul 15-+ (AU) 330mm 1080mm - 1115mm 1135mm -
13" 42 1/2ths" - 43 7/8ths" 44 11/16ths" -
Vito, 4dr Van 04-14 (EU) 250mm 1090mm 2120mm 1120mm 1140mm 1145mm
9 13/16ths" 42 15/16ths" 83 7/16ths" 44 1/8ths" 44 7/8ths" 45 1/16ths"
3
Fitting Kit EN
K868
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
●Use keys to remove covers.
4
Fitting Kit EN
K868
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Adjust crossbar in or out to suit vehicle.
Refer to the crossbar instructions for
crossbar adjustment.
●Please check the front of this manual for
information relating specifically to your
vehicle.
5
Fitting Kit EN
K868
●Tighten adjusting screw to 3 Nm (2.2 ft lb)
hand tight.
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Select plastic internal block (from fitting kit)
and insert into foot.
●Repeat for all legs.
6
Fitting Kit EN
K868
●Refer to the underside of the pad for the
part number.
●It is important to put the pads in the correct
position on the vehicle.
●Letters refer to the pad part numbers and
position.
●Pad Part Number:
A = 292A
●Fit rubber pads (supplied with fitting kit) to
foot. Pad may vary in shape to that shown.
●Make sure the pad fits into the holes
underneath the foot.
7
Fitting Kit EN
K868
Fitment
●Open or remove fixed-point covers.
●Attaches to factory-fitted mounting points.
Do not use mounting points with "X".
●Remove fixed-point covers by turning the
plastic screw with flat-head screw driver.
●Select grubscrews and screw into the
vehicle's fixed points.
●Do not over tighten.
●Repeat for all four positions.
8
Fitting Kit EN
K868
●Place crossbar foot over grubscrews.
●Tighten the plastic knob. The side with the
nut showing should be facing up.
●In the fully tightened position, the knobs
should be parallel with the vehicle.
●Repeat for all four positions.
9
Fitting Kit EN
K868
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
10
Tabla de contenidos
Otros manuales de Accesorios para automóviles de Prorack
Prorack
Prorack K919 Manual de usuario
Prorack
Prorack K1012 Manual de usuario
Prorack
Prorack K083 Manual de usuario
Prorack
Prorack K827 Manual de usuario
Prorack
Prorack K707 Manual de usuario
Prorack
Prorack K869 Manual de usuario
Prorack
Prorack K676 Manual de operación e instalación
Prorack
Prorack K443 Manual de usuario
Prorack
Prorack PR3206 Manual de usuario
Prorack
Prorack PR3097 Manual de usuario
Prorack
Prorack K337 Manual de usuario
Prorack
Prorack K991 Manual de usuario
Prorack
Prorack K618 Manual de usuario
Prorack
Prorack K988 Manual de usuario
Prorack
Prorack K174 Manual de usuario
Prorack
Prorack K820 Manual de usuario
Prorack
Prorack K1187 Manual de usuario
Prorack
Prorack K1228 Manual de usuario
Prorack
Prorack K144W Manual de operación e instalación
Prorack
Prorack K567 Manual de usuario
