Prorack K083 Manual de usuario

K083

Fitting Kit

EN Fitting Instructions for Basic Carrier

x 1 x 2 x 2

Revision No: 2C 1

Fitting Kit K083

MAX kgs (lbs)

W/P WHD

Subaru

Legacy , 5dr Estate 94-98 EU 50 kgs (110 lbs) 50 kgs (110 lbs)

Legacy , 5dr Wagon Jun 94-Nov 98 NZ 50 kgs (110 lbs) 50 kgs (110 lbs)

Liberty , 5dr Wagon Jun 94-Jan 99 AU 50 kgs (110 lbs) 50 kgs (110 lbs)

Fitting Kit EN

K083

First Time Installation

●Remove parts from inside the package and

check. Contact your dealer if any parts are

missing or damaged.

●This kit fits type A, B, C and D.

●These instructions show type A crossbar

fitted. They also apply to type B, C and D.

NOTE: Clamp images in these instructions may

not be representative of the clamps in this kit

Fitting Kit EN

K083

●Use keys to remove covers.

●Use hex screwdriver to reverse adjusting

screw 10 turns.

●Press adjusting screw and pull crossbar

legs out. Refer to the crossbar instructions

for crossbar adjustment.

●Ensure each end of the crossbar is

adjusted equally.

Fitting Kit EN

K083

●Remove locking screw.

●Cut protective strip in four equal lengths.

●Apply protective strip as shown.

Trim if required.

●Letters refer to the part numbers stamped

on clamps.

●Clamp Part Number:

A = 283A

B = 284A

Fitting Kit EN

K083

●Attach clamp to each leg. NOTE; clamps

may have labels showing their positions on

the vehicle (For example; "Front Right").

●Refit locking screw so that it goes through

the hole in the clamp. Do not begin to

tighten the locking screw.

●Fit rubber pad (supplied with crossbar) to

foot.

Fitting Kit EN

K083

●Make sure the pad fits into the holes

underneath the foot.

Fitment

●Place crossbar on vehicle. Minimum

recommended spacing between the bars is

700mm (27 1/2") (unless otherwise stated).

●Clamps directly to edge of roof under the

doors

●Adjust the legs on the crossbar so that they

are positioned equally from the ends of the

crossbar, and the clamps engage firmly on

the body work of the vehicle.

Fitting Kit EN

K083

●Tighten adjusting screw to 5 Nm (3.7 ft lb).

●Tighten locking screw on both legs evenly.

●Check crossbar is securely attached to the

vehicle.

Fitting Kit EN

K083

●Use keys to fit and lock covers

CAUTION: Recheck all fasteners immediately after

a load is applied to the crossbars.

Regularly check screws are tight.

Fitting Kit EN

K083

Maintenance

●Clean the car roof and surfaces of the

product that will be in contact with the car

roof.

●Follow the fitting instructions for fitting the

product to your vehicle. Make sure all steps

are carried out in order.

●Set crossbars a minimum distance of

700mm (27 1/2") apart where no other

distance is specified in the fitting

instructions. This is especially important

when carrying long loads.

●Check unit is securely attached whenever

you refit it to the vehicle. If the unit feels

loose, refer to the fitting instructions and

readjust.

●Some glass/panoramic roofs and radio

antennae may not be able to be used when

the product is fitted.

●Do not modify this product.

●Refer to the maximum permitted load

capacity specified in the fitting instructions.

Do not exceed the vehicle manufacturers

roof load rating if it is lower than the

maximum load capacity specified in the

fitting instructions.

●Loads should not overhang the sides of the

product and be evenly distributed with the

lowest possible centre of gravity.

●Long loads should be secured with non-

elastic straps to the front and rear of the

vehicle.

●Objects with pointed ends (e.g. ski poles)

should be carried with the pointed ends to

the rear of the vehicle.

●Remove all loose or removable objects

from the load prior to loading.

●Make sure all loads are securely fastened

with non-elastic straps. Check regularly

during longer journeys.

●A loaded roof rack system can alter the

performance of your vehicle. Be especially

aware of the effects of side winds,

changing of direction, and braking

performance. Avoid rapid acceleration and

deceleration. Drive carefully.

●Note that the total height of the vehicle

increases when upright loads are carried.

●Products should be locked during transport

if they have locks fitted.

Tabla de contenidos

Otros manuales de Accesorios para automóviles de Prorack

Prorack

Prorack K340 Manual de usuario

Prorack

Prorack K188 Manual de usuario

Prorack

Prorack K334 Manual de usuario

Prorack

Prorack K078 Manual de usuario

Prorack

Prorack K877 Manual de operación e instalación

Prorack

Prorack K416 Manual de operación e instalación

Prorack

Prorack K748 Manual de usuario

Prorack

Prorack K328 Manual de usuario

Prorack

Prorack K926 Manual de operación e instalación

Prorack

Prorack K682 Manual de usuario

Prorack

Prorack K646 Manual de usuario

Prorack

Prorack K306 Manual de usuario

Prorack

Prorack K377 Manual de usuario

Prorack

Prorack K587 Manual de usuario

Prorack

Prorack K671 Manual de usuario

Prorack

Prorack K136 Manual de usuario

Prorack

Prorack K105 Manual de usuario

Prorack

Prorack K431 Manual de usuario

Prorack

Prorack K545 Manual de usuario

Prorack

Prorack K186 Manual de usuario

Prorack

Prorack K404 Manual de operación e instalación

Prorack

Prorack K949 Manual de usuario

Prorack

Prorack K501 Manual de usuario

Prorack

Prorack K343 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario