Prorack K391 Manual de usuario
K391
Fitting Kit
EN Fitting Instructions for Basic Carrier
CZ Pokyny pro montáž základních nosičů
HU Felszerelési útmutató a
tetőcsomagtartóhoz
SK Pokyny pre montáž základných nosičov
x 2 x 2 x 2 x 2
x 4
Revision No: 7G 1
Fitting Kit K391
MAX kgs (lbs)
W/P WHD
Volkswagen
Passat Mk6, 4dr Sedan 05-09 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat Mk6, 4dr Sedan 05-10 US 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat Mk6, 4dr Sedan 05-10 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat Mk6, 4dr Sedan 05-10 CN 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat Mk6, 4dr Sedan Dec 05-10 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat Mk6, 4dr Sedan Mar 06-10 AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat, 4dr Sedan 10-10 US 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat, 4dr Sedan 10-Oct 14 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat, 4dr Sedan 10-Sep 15 AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat, 4dr Sedan 10-Sep 15 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat, 4dr Sedan 10-Sep 15 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat, 4dr Sedan 10-Sep 15 CN 75 kgs (165 lbs) 75 kgs (165 lbs)
2
Fitting Kit K391
X
A B C 1 2 3
Passat Mk6, 4dr Sedan 05-09 (ZA) -280mm 470mm - 894mm 884mm -
-11" 18 1/2ths" - 35 3/16ths" 34 13/16ths" -
Passat Mk6, 4dr Sedan 05-10 (US) -280mm 470mm - 894mm 884mm -
-11" 18 1/2ths" - 35 3/16ths" 34 13/16ths" -
Passat Mk6, 4dr Sedan 05-10 (EU) -280mm 470mm - 894mm 884mm -
-11" 18 1/2ths" - 35 3/16ths" 34 13/16ths" -
Passat Mk6, 4dr Sedan 05-10 (CN) -280mm 470mm - 894mm 884mm -
-11" 18 1/2ths" - 35 3/16ths" 34 13/16ths" -
Passat Mk6, 4dr Sedan Dec 05-10 (NZ) -280mm 470mm - 894mm 884mm -
-11" 18 1/2ths" - 35 3/16ths" 34 13/16ths" -
Passat Mk6, 4dr Sedan Mar 06-10 (AU) -280mm 470mm - 894mm 884mm -
-11" 18 1/2ths" - 35 3/16ths" 34 13/16ths" -
Passat, 4dr Sedan 10-10 (US) -275mm 475mm - 895mm 885mm -
-10 -13/16ths" 18 11/16ths" - 35 1/4ths" 34 13/16ths" -
Passat, 4dr Sedan 10-Oct 14 (EU) -275mm 475mm - 895mm 885mm -
-10 -13/16ths" 18 11/16ths" - 35 1/4ths" 34 13/16ths" -
Passat, 4dr Sedan 10-Sep 15 (AU) -275mm 475mm - 895mm 885mm -
-10 -13/16ths" 18 11/16ths" - 35 1/4ths" 34 13/16ths" -
Passat, 4dr Sedan 10-Sep 15 (ZA) -275mm 475mm - 895mm 885mm -
-10 -13/16ths" 18 11/16ths" - 35 1/4ths" 34 13/16ths" -
Passat, 4dr Sedan 10-Sep 15 (NZ) -275mm 475mm - 895mm 885mm -
-10 -13/16ths" 18 11/16ths" - 35 1/4ths" 34 13/16ths" -
Passat, 4dr Sedan 10-Sep 15 (CN) -275mm 475mm - 895mm 885mm -
-10 -13/16ths" 18 11/16ths" - 35 1/4ths" 34 13/16ths" -
3
Fitting Kit EN
K391
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
NOTE: Clamp images in these instructions may
not be representative of the clamps in this kit
4
Fitting Kit EN
K391
●Use keys to remove covers.
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
5
Fitting Kit EN
K391
●Remove locking screw.
●Apply protective strip as shown.
Trim if required.
●It is important to put the clamps in the
correct position on the vehicle.
●Letters refer to the part numbers stamped
on clamps.
●Clamp Part Number:
A = 504A
B = 505A
6
Fitting Kit EN
K391
●Attach clamp to each leg. NOTE; clamps
may have labels showing their positions on
the vehicle (For example; "Front Right").
●Refit locking screw so that it goes through
the hole in the clamp. Do not begin to
tighten the locking screw.
●It is important to put the pads in the correct
position on the vehicle.
●Letters refer to the pad part numbers and
position.
●Pad Part Number:
A = 11-04-250
B = 11-04-251
7
Fitting Kit EN
K391
●Refer to the underside of the pad for the
part number.
●Fit rubber pads (supplied with fitting kit) to
foot. Pad may vary in shape to that shown.
●Make sure the pad fits into the holes
underneath the foot.
8
Fitting Kit EN
K391
Fitment
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●Clamps directly to edge of roof under the
doors, pin locates in hole on vehicle
●Please check the front of this manual for
information relating specifically to your
vehicle.
●Locate vehicle's fixed points.
●Clamps directly to edge of roof under the
doors, pin locates in hole on vehicle
●Adjust the legs on the crossbar so that they
are positioned equally from the ends of the
crossbar, and the clamps engage firmly on
the body work of the vehicle.
●Tighten adjusting screw to 5 Nm (3.7 ft lb)
hand tight.
9
Fitting Kit EN
K391
●Tighten locking screw on both legs evenly.
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
10
Tabla de contenidos
Idiomas:
Otros manuales de Accesorios para automóviles de Prorack
Prorack
Prorack K702 Manual de usuario
Prorack
Prorack K186 Manual de usuario
Prorack
Prorack K311 Manual de usuario
Prorack
Prorack K334 Manual de usuario
Prorack
Prorack K514 Manual de usuario
Prorack
Prorack K540 Manual de usuario
Prorack
Prorack K199 Manual de usuario
Prorack
Prorack K452 Manual de usuario
Prorack
Prorack K1041 Manual de usuario
Prorack
Prorack K820 Manual de usuario
Prorack
Prorack K130 Manual de usuario
Prorack
Prorack K985 Manual de usuario
Prorack
Prorack K473 Manual de usuario
Prorack
Prorack K407 Manual de usuario
Prorack
Prorack PR3075 Guía de instalación
Prorack
Prorack J-Cradle Manual de usuario
Prorack
Prorack K387 Manual de usuario
Prorack
Prorack PR3715 Manual de usuario
Prorack
Prorack Fitting Kit K722 Manual de operación e instalación
Prorack
Prorack WHISPBAR S53 Manual de operación e instalación
