Prorack J-Cradle Manual de usuario
Page 1 of 6
6100010663 PR3105 - Rev3
J-Cradle Kayak Carrier
Caution
• Tie down long or wide loads at the front and rear of the vehicle with non-elastic straps. If it looks like it can catch
some air, it will. TIE IT DOWN!
• When loading your surf gear or kayak, ensure that it is mounted correctly using the tie downs provided and is
positioned centrally, parallel to the vehicle.
• Check straps periodically during travel and tighten if necessary. Replace any straps that are worn or frayed before
using (see your Prorack dealer).
Important Warning
• It is critical that all Prorack racks and accessories be properly and securely attached to your vehicle. Improper
attachment could result in an automobile accident, and could cause serious bodily injury or death to you or to others.
• You are responsible for securing the racks and accessories to your car, checking the attachments prior to use, and
periodically inspecting the products for adjustment, wear, and damage. Therefore, you must read and understand all of
the instructions and cautions supplied with your Prorack product prior to installation or use.
• If you do not understand all of the instructions and cautions, or if you have no mechanical experience and are not
thoroughly familiar with the installation procedures, you should have the product installed by a professional installer
such as a boat carrier specialist.
Minimum Crossbar
Spread 61 cm
Item Component Qty
1 J-Cradle Kayak Carrier 2
2 Base Pad 2
3 Plug 16
4 Strap 2
5 Knob 4
6 Bracket 2
7 Bail 2
8 Carriage Bolt 2
9 T-Bolt 2
10 Long Carriage Bolt 2
11 Long T-Bolt 2
12 Steel Hook 2
13 Plain Strap 2
14 Plastic Tube 2
15 Buckle 2
Kit Contents
5
PR3105
This product is designed to work
with Prorack Aero, Standard,
Trade and other Round Bars.
2
1
4
3
6
7
8
9
10
11
12
13
14
15
Max Load 36 kg
Page 2 of 6
6100010663 PR3105 - Rev3
1
Attach base pads to bases with plugs
3
2With brackets in place, attach pads onto bases
Attach bails to metal brackets using long bolts
4
Plugs can be used only once.
If you reconfigure the bases, see your Prorack
Dealer for replacement plugs # 8890058.
Insert bolt into round
hole, and T-bolt into
slotted hole.
Attach the Knobs
5
With the T-bolt free, position the
J-Cradles on the factory crossbars
6
Install metal bracket over bases
Page 3 of 6
6100010663 PR3105 - Rev3
Ensure the carriers sit vertically on the bars
7
Tighten the Knobs
8
Secure straps
11
In some cases, the
bracket and the bail
may not be parallel
If the bolts seem
too short, use
the longer bolts
included in this kit
(longer bolts)
BOLTS MUST NOT EXTEND ABOVE THE KNOBS.
If bolts extend above the knob, you
must use the shorter bolts
OK OK
Adjust foam pads to support boat at contact points
9
Note: Some lacquer hull
finishes may stick to pads.
Protect with soft cloth.
Load the boat, and tie it down
10
• Loop strap around hoop of carrier.
• Bring straps up and over boat so that they
hang in front of the boat.
• Slide buckle up so that it hangs at top edge of boat.
• Thread end of strap around tower or crossbar.
• Press open buckle
and insert end of
strap.
• To tighten straps,
hold and pull.
• Secure the loose
ends.
Antenna on the
roof may need
to be removed
to prevent
interference
with long loads
Page 4 of 6
6100010663 PR3105 - Rev3
12 13 14
Attach buckle strap to
bow and stern of boat
Attach strap to grab handle
or rescue bar and pull tight.
Attach hook to
plain strap loop
Slide plastic tube to protect
vehicle at contact point
NOTE: Twisting the strap will
help reduce wind vibration.
Insert end of plain
strap into buckle
(press tab)
Adjust strap tension by
pulling plain end
Hook the strap to a metal
surface on the bumper,
tow loop, or frame hole
using hook
Failure to secure front and rear of long loads to ends of vehicle can result in
property damage, personal injury, or death.
15 17
• Apply even pressure to
front and rear straps.
• Bind up and tie off any
excess strap.
16
Page 5 of 6
6100010663 PR3105 - Rev3
Care and Maintenance
• Use non-water soluble lubricant on screws. Use a soft cloth with water and mild detergent to clean plastic parts.
Safety Checks
• Before Driving Away:
- Ensure all hardware is secured according to instructions.
- Test movement by rocking boat.
- Tighten again if loose.
• Attachment hardware can loosen over time:
- Check straps periodically during travel and tighten if necessary.
- Replace any straps that are worn or frayed before using (see your Prorack dealer).
• Some longer loads may prevent the rear hatch from fully opening.
Always use caution when opening your hatch.
Page 6 of 6
6100010663 PR3105 - Rev3
Prorack
17 Hinkler Court, Brendale
QLD 4500, Australia
Freephone
AU: 1800 143 548 www.prorack.com.au
NZ: 0800 4776 722 www.prorack.co.nz
ALL CONTENT SUBJECT TO YAKIMA AUSTRALIA PTY LTD COPYRIGHT © 2015
Tabla de contenidos
Otros manuales de Accesorios para automóviles de Prorack
Prorack
Prorack K491 Manual de usuario
Prorack
Prorack K455 Manual de usuario
Prorack
Prorack PR3600 Manual de usuario
Prorack
Prorack WHISPBAR S47 Manual de operación e instalación
Prorack
Prorack K312 Manual de usuario
Prorack
Prorack K183 Manual de operación e instalación
Prorack
Prorack K112 Manual de usuario
Prorack
Prorack K742 Manual de usuario
Prorack
Prorack K412 Manual de usuario
Prorack
Prorack PR3075 Manual de usuario
Prorack
Prorack K470 Manual de usuario
Prorack
Prorack K485 Manual de usuario
Prorack
Prorack K182 Manual de operación e instalación
Prorack
Prorack K879 Manual de usuario
Prorack
Prorack K108 Manual de usuario
Prorack
Prorack K443 Manual de usuario
Prorack
Prorack K525 Manual de operación e instalación
Prorack
Prorack K349 Manual de usuario
Prorack
Prorack K507 Manual de usuario
Prorack
Prorack K365 Manual de usuario
