Support Material, cured or uncured, is not hazardous.
To nd out facility disposal requirements, contact an approved waste disposal provider. Your local
environmental regulatory agency should have a list of qualied providers. You will need to give disposal
service provider a copy of the buildmaterial Global Health and Safety sheets, and possibly other forms
included in the Appendix of your VisiJet Post Processing Guide, such as Waste Prole Worksheet and SNUR
(Signicant New Use Regulation - U.S. only). A report will be provided, indicating disposal requirements, as
well as a quotation for regularly scheduled pickups. If assistance is needed locating a waste disposal
provider, or completing a waste disposal form, contact 3D Systems Technical Support Hot line.
3D Systems assumes no liability or responsibility for proper disposal of uncured buildmaterial. Proper
disposal of uncured material is the sole responsibility of the user.
Health Hazard / Irritant
Caution: UncuredVisiJet build material is a sensitizer. Skin or eye irritation could occur when exposed to the
chemical composition of the material. Any chemical may exert harmful effects if it contacts or enters the
body. VisiJet build material is a sensitizer and irritant.
Skin Sensitization: Uncured VisiJet buildmaterial is a sensitizer. Skin or eye irritation could occur when
exposed to the chemical composition of the material
Uncured material is a sensitizer and can cause allergic reactions if it contacts skin without protective gloves and
sleeves. To avoid sensitization, do not allow uncured material to contact skin. Consult the GHS sheets for
specic information about the sensitization potential.
Once sensitized, a severe allergic reaction may occur when subsequently exposed to very low levels.
Ingestion:UncuredVisiJet buildmaterial is toxic if ingested.
Uncured material is toxic if ingested. Uncured material must not be present where food and drink are stored,
prepared, or consumed and must not be ingested. After handling materials, wash hands with soap and cold
water before consuming or preparing food.
Inhalation: Under normal operation, inhalation is not an expected route of entry.
Contact With Uncured Material: Employees should be alerted to clean and rinse off any contacted surface
promptly in order to prevent further contamination. Ensure a convenient washroom location is provided with
access to soap, water, and disposable paper towels.
Handling Finished Parts: Finished (cured) parts can be handled or disposed of the same as standard
household plastic products. VisiJet parts are not recyclable. VisiJet materials are not intended for, and
cannot be used for medical implant or food or drink handling applications.
Exposure Control: The 3D printer system has a variety of built-in engineering controls which are designed to
prevent operator exposure. Do not try to change or disable these controls.
Appropriate hygienic practices should be followed, including washing with soap and cold water before
meals, breaks, smoking, applying cosmetics, using toilet facilities, and after work.
Material Handling
