Poynting OMNI-280 Manual de usuario

Version: 2.0

OMNI-280

User Guide

South Africa

Unit 4, N1 Industrial Park

Landmarks Ave

Samrand, 0157,

South Africa

Tel: +27 12 657 0050

[email protected]

Europe

Kronstadler Straße 4,

81677 München

Germany

Tel: +49 89 2080 265 38

Mob.: +49 176 529 733 50

[email protected]

www.poynting.tech

2 A-OMNI-0280_PCL

Version: 2.0

Index

1. Packing Check List 4

2. The appearance of each

component 5

3. Tools required 6

4. Pole mounting 7

5. Wall mounting 8

6. Desk mounting 9

7. Antenna mounting 10

precautions

8. Cable routing 10

9. Safety 11

4 A-OMNI-0280_PCL

Packing Check List

Item Description Quantity

1. OMNI-0280

antenna only

2. M4 x 8mm Stainless

Steel screw

3. Wall bracket 1

4. Coaxial cable clip 1

5. Velcro hook 1

6. Velcro loop 1

Version: 2.0

The appearance of each component

Antenna unit

Wall bracket

Coaxial cable clip

M4 x 8mm stainless steel screw

The Appearance of each component

6 A-OMNI-0280_PCL

Tools Required

Tools that may be required:

Safety goggles

Masonry drill bit

Hand drilling machine

Screw driver-Cross slot/Philips

Version: 2.0

Pole Mounting Conguration

Pole Mounting

•Lay the antenna out at the installation site.

•Attach the bracket onto the base of the

antenna using three M4 x 8mm screws.

•Run the cable tie or hose clamp around the

bracket and pole until the bracket is secured

to the pole.

8 A-OMNI-0280_PCL

Wall Mounting Conguration

Select a suitable place for mounting the antenna

•Using the wall mount bracket as a guide,

mark two points to drill on the wall.

Use a 5mm masonry drill bit to drill the

marked points.

•Use a masonry drill bit to drill a cable entry

hole to t the connector.

•Place the bracket over the two holes and

line up the holes in the bracket with the

holes in the wall.

•Insert the two knock-in screws to mount the

bracket to the wall.

5 mm Holes

Drill a cable entry hole to t the connector

Version: 2.0

Desk Mounting Conguration

•Select a suitable position on the desk to

mount the antenna

•Peel the adhesive lm off the Velcro hook

and paste it onto the desk

•Peel the adhesive lm off the Velcro loop

and paste it underneath the base of the

antenna

•Place the antenna with the Velcro loop

onto the Velcro hook.

•Ensure that the antenna is sturdy.

•Once the above has been completed,

peel the double-sided sticker of the coaxial

cable clip and place the clip in a suitable

position on the desk.

•Pass the cable through the cable clip to the

router/machine.

DETAIL B

10 A-OMNI-0280_PCL

Antenna Mounting Precautions

•Place the antenna at the highest point

possible and ensure that there are no

surrounding obstructions to the antenna.

•In order to avoid communication

interference, ensure that the antenna is

placed at least 0.5m away from other

antennas and metal objects.

•Avoid installing the antenna near

a chimney, as the smoke and soot

emitted through the chimney can

obstruct the signal level achieved by

the antenna.

•Install the antenna away from heat

sources and ammable gases.

Cable Routing

• Avoid wrapping the cable around the

pole. Route the antenna cable straight

down the inside of the pole to avoid

using extra equipment such as cable

ties.

• Use the minimum cable length required.

Do not run more cable than needed to

ensure that cable losses are minimised

• Never pull on the cable connectors; pull

only on the cable ensuring the cable is

not under tension.

• The allowable cable bend radius is

30mm; avoid sharp bends.

• Cover connectors with insulation tape

before threading them through a hole.

• Install the cable with a drip-loop where

the cable entry is above the point of

connection. This will prevent water from

running onto the antenna connector

and other equipment which it is

connected to.

Tabla de contenidos

Otros manuales de Antena de Poynting

Poynting

Poynting XPOL-1-5G Manual de usuario

Poynting

Poynting PUCK-5 Manual de usuario

Poynting

Poynting MIMO-3-V2 Manual de usuario

Poynting

Poynting XPOL-2 Manual de usuario

Poynting

Poynting OMNI-704 Manual de usuario

Poynting

Poynting XPOL-1 Manual de usuario

Poynting

Poynting OMNI-703 Manual de funcionamiento

Poynting

Poynting Moray Series Manual de usuario

Poynting

Poynting OMNI 400 Manual de usuario

Poynting

Poynting OMNI-214 Manual de usuario

Poynting

Poynting OMNI-900 Manual de usuario

Poynting

Poynting EPOYNT-4 Manual de usuario

Poynting

Poynting PUCK-V1 Manual de usuario

Poynting

Poynting OMNI-292-V2 Manual de usuario

Poynting

Poynting EPOYNT Manual de usuario

Poynting

Poynting OMNI-297 Manual de usuario

Poynting

Poynting OMNI-121 Manual de usuario

Poynting

Poynting OMNI-600-V1 Manual de usuario

Poynting

Poynting A-PUCK-0002-V1-01 Manual de usuario

Poynting

Poynting OMNI 291 Manual de usuario

Poynting

Poynting PowerfulSignal PUCK-12 Manual de usuario

Poynting

Poynting LPDA-0092-04 Manual de usuario

Poynting

Poynting OMNI-706 Manual de usuario

Poynting

Poynting OMNI-232-02 Manual de usuario

Manuales populares de Antena de otras marcas

Alfa Network

Alfa Network APA-L01 Manual de usuario

Naval

Naval PR-422CA Manual de usuario

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Manual de usuario

TERK Technologies

TERK Technologies TV44 Manual de usuario

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Manual de usuario

HP J8999A Manual de usuario

MobilSat

MobilSat MSP-S Manual de usuario

Steren

Steren ANT-UHF 13 Manual de usuario

Novatel

Novatel 600-G Manual de operación

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Manual de usuario

TRENDnet

TRENDnet TEW-AO12O Manual de usuario

Radio Shack

Radio Shack 15-1837 Manual de usuario

CommScope

CommScope CMAX-OMFX-43M-I53 Manual de usuario

Ramsey Electronics

Ramsey Electronics DAP25 Manual de usuario

COBHAM

COBHAM SAILOR 800 VSAT Manual de uso y cuidado

Trango Systems

Trango Systems AD900-9 Manual de usuario

Steren

Steren ANT-100 Manual de usuario

Proxim

Proxim 5054-PA-23 Manual de usuario