Plantronics Savi W720A-M Manual de usuario
Savi®W710A-M/W720A-M
Multi Device Wireless Headset System
User guide
TM
Contents
Welcome 4
System requirements 4
What's in the box 5
Base and headset basics 6
Accessories 7
Customise your headset 8
Adjust the headband 8
Adjust the mouthpiece 8
Charge your headset 10
Desk Phone: Connect and Call 11
Choose desk phone setup 11
Make a desk phone call 12
Mobile: connect and call 13
Computer: connect and call 14
Connect your computer 14
Place a softphone call 14
Position your base 14
Headset features 15
Headset controls 15
Headset power 15
Headset battery level 16
Mute your headset during a call 16
Adjust your headset volume 16
Turn on/off headset LED 17
Out of range warning tones 17
Base features 18
Base buttons 18
Base subscription button 18
Set the range 19
Bluetooth pairing button 19
Daily use 21
Incoming calls 21
Outgoing calls 21
Multi-Phone Status 23
Mobile phone and headset audio 23
Combine audio from any two lines or channels 23
Conference up to three additional headsets 23
Advanced use 25
Install Plantronics software 25
Plantronics Control Panel 25
Devices tab 25
Device settings > Base tab 26
Device settings > Headset tab 28
Device settings > Security tab 29
Applications tab 29
Preferences 29
2
About tab 30
Plantronics Update Manager 30
Troubleshooting 32
Headset 32
Desk phone 33
Mobile 33
Softphone 33
3
Congratulations on purchasing your new Plantronics product. This guide contains instructions
for setting up and using your Savi W710-M/W720-M
Please refer to the safety instructions in the quick start guide for important product safety
information prior to installation or use of the product.
Computer
• Supported operating systems: Windows®7, Windows®8, Windows XP®, Windows Vista®
• Processor: 400 MHz Pentium®processor or equivalent (Minimum); 1 GHz Pentium processor or
equivalent (Recommended)
• RAM: 96 MB (Minimum); 256 MB (Recommended)
• Hard disk: 280 MB (Minimum); 500 MB or more (Recommended)
• Microsoft Windows XP - Service Pack 3 (SP3) or later (Recommended) Microsoft Windows
Vista - Service Pack 1 (SP1) or later (Recommended)
Display
• At least 800 x 600, 256 colours
• 1024 x 768 high colour, 32-bit (Recommended)
Browser
• Internet Explorer®V6 or better must be on the user’s system (Required)
Welcome
System requirements
4
WH300 headset (monaural) WH350 headset (binaural)
Base and charging cradle
USB cable Telephone interface cable Power supply
What's in the box
5
Base
1Power jack 8Computer button
2Handset lifter jack 9Mobile phone button
3Telephone interface cable jack 10 Desk phone button
4USB port 11 Bluetooth pairing button/LED
5Desk phone speaking volume 12 Subscription button/LED
6Desk phone configuration switch 13 Charging LED
7Desk phone listening volume
Headset
1Headset LED 4Mute button
2Volume up button 5Volume down button
3Call control button 6Microphone
Base and headset basics
6
1Electronic hookswitch cable (EHS cable) Electronically and automatically takes your desk
phone handset off the hook. Enables remote call control with your headset.
2HL10 lifter Automatically lifts handset and returns it to the cradle. Enables remote call
control with your headset.
Accessories
7
Optimise the comfort and fit of your headset.
1To adjust the headband, lengthen or shorten the band until it fits comfortably. Position the
headset receivers so that the foam cushions sit comfortably over the centre of your ears.
2On the WH300, position the stabiliser T-bar above your ear.
3For a tighter fit, gently pull the opposite ends of the headset inward as shown.
1Carefully bend and shape the boom with both hands as shown. Avoid bending or twisting the
boom near the microphone or earpiece.
2Position the click-stop turret and boom so that the microphone is two finger widths from the
corner of your mouth.
Customise your headset
Adjust the headband
Adjust the mouthpiece
8
3Make sure the front of the microphone faces your mouth. If necessary, twist the microphone
slightly so it’s in the proper position. Do not use forceful twisting motions or try to turn the
microphone completely around.
9
1Align the charging cradle pins with the base and press firmly until the cradle rests evenly on the
base.
2Plug one end of power supply into power jack on back of the base and other end into working
power outlet.
3Place the headset in the charging cradle. The charging LED will flash green when charging the
headset and turn solid green when the headset is fully charged. Charge for at least 20 minutes
prior to the first use. A full charge takes 3 hours.
NOTE This product has a replaceable battery. Only use the battery type supplied by Plantronics.
Charge your headset
10
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Otros manuales de Auriculares de Plantronics
Plantronics
Plantronics Savi 430 Manual de usuario
Plantronics
Plantronics Blackwire 710 Manual de usuario
Plantronics
Plantronics RIG 800HS Manual de usuario
Plantronics
Plantronics Marque M155 Manual de usuario
Plantronics
Plantronics M50 Manual de usuario
Plantronics
Plantronics DISCOVER 610 Manual de usuario
Plantronics
Plantronics RIG 400 Series Manual de usuario
Plantronics
Plantronics Pulsar 590 series Manual de usuario
Plantronics
Plantronics CS55 Manual de usuario
Plantronics
Plantronics S12 Guía de configuración
Plantronics
Plantronics EXPLORER 300 SERIES Manual de usuario
Plantronics
Plantronics VOYAGER 835 Guía de referencia
Plantronics
Plantronics MX100 Manual de usuario
Plantronics
Plantronics H41 Manual de usuario
Plantronics
Plantronics Voyager Manual de usuario
Plantronics
Plantronics Discovery 610 Manual de usuario
Plantronics
Plantronics Blackwire C435-M Manual de usuario
Plantronics
Plantronics RIG Manual de usuario
Plantronics
Plantronics Discovery 655 Manual de usuario
Plantronics
Plantronics Discovery 640E Manual de usuario
