Phocos CIS Manual de usuario

Otros manuales para CIS

1

Tabla de contenidos

Otros manuales de Controladores de Phocos

Phocos

Phocos CIS-N-LED Series Manual de usuario

Phocos

Phocos CIS05 Manual de usuario

Phocos

Phocos CMLsolid 30 Manual de usuario

Phocos

Phocos CXup Series Guía de instalación

Phocos

Phocos CX20 Manual de usuario

Phocos

Phocos CMLmppt Manual de usuario

Phocos

Phocos ECO-N-T Manual de usuario

Phocos

Phocos CML05-2 Manual de usuario

Phocos

Phocos CIS-N Manual de usuario

Phocos

Phocos ECO-N-T Manual de usuario

Phocos

Phocos CIS05 Manual de usuario

Phocos

Phocos eCO Manual de usuario

Phocos

Phocos 321666 Manual de usuario

Phocos

Phocos Any-Grid Series Manual de funcionamiento

Phocos

Phocos CXNup 2B Manual de usuario

Phocos

Phocos CMLup Manual de usuario

Phocos

Phocos ECO-N Manual de usuario

Phocos

Phocos ECO-N Manual de usuario

Phocos

Phocos CMLmppt Manual de usuario

Phocos

Phocos ECO-N-T Series Manual de usuario

Phocos

Phocos CIS Manual de usuario

Phocos

Phocos CIS-MPPT-LED 85/15 Manual de usuario

Phocos

Phocos MPPTsolid Manual de usuario

Phocos

Phocos CIS-N-MPPT 100/30 Manual de usuario

Manuales populares de Controladores de otras marcas

Digiplex

Digiplex DGP-848 Instrucciones de funcionamiento

YASKAWA

YASKAWA SGM series Manual de usuario

Sinope

Sinope Calypso RM3500ZB Manual de usuario

Isimet

Isimet DLA Series Style 2 Manual de instalación

LSIS

LSIS sv-ip5a Manual de usuario

Rockwell Automation

Rockwell Automation 1769-L31 Manual de usuario

Airflow

Airflow Uno hab Manual de usuario

ABB

ABB ACS580-01 drives Manual de usuario

Panasonic

Panasonic GM1 Series Manual de usuario

Emerson

Emerson SW93 Manual de usuario

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manual de usuario

Panasonic

Panasonic FP? Positioning Unit RTEX Manual de usuario

Samson

Samson Type 5824 Manual de servicio

Alpha IP

Alpha IP MIOB 21001 Manual de usuario

Siemens

Siemens OpenAir GMA 1 Series Manual de usuario

Surecom

Surecom SR-629 Manual de usuario

Fishman

Fishman TriplePlay Manual de usuario

Regulus

Regulus SRS1 T Manual de usuario

Quick start CIS charge controller (positive grounded)

Installation recommendations valid for both versions (CIS Dimming and CIS Dual Load):

1. Detailed installation wiring

IMPORTANT: Connect wires in the order indicated 1 2 3 4 5 6 7 to avoid installation faults!

VERY IMPORTANT: When disconnecting the charge controller, the reverse order (7 6 5 4 3 2 1)

must be observed or permanent damage to the controller may result!

* Note 1: The COMMON + is consists of one single conductor exiting from the charge controller:

This conductor is used to connect to multiple external system components like PV panel,

battery and load. Please use a high quality connector rated for this purpose.

Note 2: Previous versions of the CIS controller presented all wires in black color.

From the charge controller: this conductor is connected to multiple devices like PV panel,

battery and load. Please use a high quality connector for these interconnections.

Step Function Cable marker Wire size (cross section) Color

1

2

Positive battery wire COMMON* + 2.5 mm2(AWG 13) Red

Negative battery wire BATTERY - 2.5 mm2(AWG 13) Black

3

4

Positive panel wire COMMON* + 2.5 mm2(AWG 13) Red

Negative panel wire SOLAR - 2.5 mm2(AWG 13) Blue

5

6

Positive load wire COMMON* + 2.5 mm2(AWG 13) Red

Negative load wire LOAD - 2.5 mm2(AWG 13) Green

7 DIM Dimming signal wire -- 0.6 mm2(AWG 19) Black

Quick Start CIS_1/2_e_2013-06-27_Subject to change without notice

Fuse

To dimming terminal of

LED driver electronics 7

5 3 416 2

Quick start CIS charge controller (follow up)

2. Please always observe the connection sequence of the wires whenever installing (1 2 3 4 5 6 7) or

removing (7 6 5 4 3 2 1) this charge controller from a PV circuit.

3. When performing any maintenance or substitution of the battery in a given circuit where this

charge controller is in use, make sure that FIRST the connection to the PV panel and to the charge

controller is opened (interrupt the electric circuit) for safety reasons and also for protecting the

controller. Not observing this procedure may permanently damage the charge controller.

4. This charge controller has been designed to meet all the IP68 requirements and fulfills those in its

entirety.

5. We do not recommend mounting the charge controller so that it will be exposed to direct sun light.

This will unnecessarily heat up the controller and also produce accelerated and (undesired) aging

for which Phocos cannot take responsibility. Symptoms of excessive exposure to direct sunlight are:

Brittleness of the wires insulating material and bleaching of the black color anodized charge con-

troller housing finishing.

Quick Start CIS_2/2_e_2013-06-27_Subject to change without notice