Parrot ANAFI Manual de usuario

How to assemble and

disassemble Anafi

ANAFI assembly and disassembly processes 2

Prerequisites

The best way to repair ANAFI is to use Parrot official drones repair kit. You will need the cruciform as

well as the Torx 5 (T5) in order to carry out this procedure.

Parrot repair kit

Anafi disassembly process

-Remove the battery from the drone.

-Gently unstick the sticker from the body of the drone.

ANAFI assembly and disassembly processes 3

-Remove both screws under the sticker and then quickly put the sticker back in position to

stop the glue from drying.

-Remove both screws from the bottom of the drone at the arms junction.

-Lift the bottom cover from the front of the drone, then push it toward the rear to remove it.

ANAFI assembly and disassembly processes 4

-Pull the ventilator to remove it from its slot and remove the LED connector, near the

ventilator.

-Remove antennas from the motherboard. Antennas on the middle of the motherboard are

linked to the rear feet; the side antennas are plugged to the front feet.

ANAFI assembly and disassembly processes 5

-Remove the plastic holder from the motherboard by pulling on the plastic stamp, then slide

the holder.

-Remove the gimbal connector from the motherboard.

-Unplug the micro coaxial wire from the motherboard.

ANAFI assembly and disassembly processes 6

-Remove the four rubbers gently: Parrot recommends you hold the motherboard during the

process, to stop rubbers from falling from their support. Once rubbers are removed, unplug

the GPS antenna which can be found on hidden face of the motherboard.

-Unstick the SD slot, then remove it by pulling it through the plastic structure’s hole.

ANAFI assembly and disassembly processes 7

-Remove the vertical camera from the support by pushing gently on it.

-Remove the three screws under each arm of the drone.

ANAFI assembly and disassembly processes 8

-Pull on the bottom cover of each arm to remove them.

-Remove the two screws from the GPS cover (orange circle) then push on the button above

located the gimbal to remove the cover (red circle).

ANAFI assembly and disassembly processes 9

-Remove the screws closest to the center of the GPS card.

-Remove the screws holding the hinges: a screw can be found at each extremity of the GPS

card. Do not forget to remove screws from the bottom of the drone as well.

-Retract the arms towards the body of the drone before removing the black plastic holder of

each hinge.

-Push the lower side of each hinge to remove them.

-Caution: a washer will fall off from each hinge when removed, make sure that you do not

lose them.

ANAFI assembly and disassembly processes 10

-Remove the plastic part which holds antennas by pulling the clips on each side of the part.

-Unplug motors by pulling the connectors out of their sockets.

-Caution: Do not pull on the wires.

-Remove the arms carefully, one after the other: make sure that antenna cables do not get

stuck with other cables.

Otros manuales para ANAFI

5

Otros manuales de Zumbido de Parrot

Parrot

Parrot ANAFI Ai Manual de usuario

Parrot

Parrot BEBOP 2.0 Manual de usuario

Parrot

Parrot BEBOP 2 FPV Pack Manual de usuario

Parrot

Parrot NEWZ Manual de usuario

Parrot

Parrot wellbotts Manual de usuario

Parrot

Parrot ANAFI Ai Manual de usuario

Parrot

Parrot bebop 2 Manual de usuario

Parrot

Parrot Bluegrass Fields Manual de usuario

Parrot

Parrot DISCO-PRO AG Manual de usuario

Parrot

Parrot Disco FPV Manual de usuario

Parrot

Parrot BLAZE Manual de usuario

Parrot

Parrot Bluegrass Manual de usuario

Parrot

Parrot Disco Manual de usuario

Parrot

Parrot ANAFI Ai Manual de usuario

Parrot

Parrot BEBOP 2 FPV Pack Manual de usuario

Parrot

Parrot ANAFI USA Manual de usuario

Parrot

Parrot Bepor Manual de usuario

Parrot

Parrot bebop 2 Manual de usuario

Parrot

Parrot ANAFI Ai Manual de usuario

Parrot

Parrot bebop 2 Manual de usuario

Parrot

Parrot ANAFI Ai Manual de usuario

Parrot

Parrot ANAFI USA Manual de usuario

Parrot

Parrot MAMBO MISSION Manual de usuario

Parrot

Parrot Bebop Manual de usuario

Manuales populares de Zumbido de otras marcas

Ryze

Ryze Tello Manual de usuario

PowerVision

PowerVision PowerRay Manual de usuario

Force1

Force1 rogue F72 Manual de usuario

Zerotech

Zerotech DOBBY Manual de usuario

Protocol

Protocol VIDEODRONE AP Manual de usuario

dji

dji Matrice M210 Manual de usuario

MAKE

MAKE Terry Kilby Manual de usuario

SYMA

SYMA X440 Manual de usuario

RUKO

RUKO F11 Manual de usuario

SYMA

SYMA X5UW(720P) Manual de usuario

Dynali

Dynali 25 H Guía

dji

dji PHANTOM 4 Manual de usuario

Atlas

Atlas AtlasPRO Manual de usuario

Twodots

Twodots TVVIN BOARD Manual de usuario

GDU

GDU SAGA Manual de usuario

Ares

Ares ETHOS QX 130 Manual de usuario

Walkera

Walkera ZHUN Manual de usuario

dji

dji WIND-4 Manual de usuario