ParaBody 807 BODY SYSTEM Manual de usuario

807 BODY SYSTEM

WORKOUT CENTER

CLASSH

PART # 7346601

REV.C Revision: 2/10/03

USER’S GUIDE

WARNING:

Read and follow all directions

for each step to insure proper

assembly of this product.

Version: 807109

THERE IS A RISK ASSUMED BY INDIVIDUALS WHO USE THIS TYPE OF

EQUIPMENT. TO MINIMIZE RISK FOLLOW THESE RULES!

1. Before using, read all the warnings and instructions

on the use of this machine. Use only for intended

exercise. DO NOT modify the machine.

2. Obtain a medical exam before beginning any

exercise program.

3. Keep body and clothing free of all moving objects.

4. Inspect the machine before use. DO NOT use it if it

appears damaged. DO NOT attempt to fix a broken or

ammed machine. Notify your authorized ParaBody

dealer before use and have repairs made by an

authorized service technician.

5. Be certain that weight pin is completely inserted.

Use only the pin provided by the manufacturer. If

unsure, call your authorized ParaBody dealer.

6. Never pin the weights or prop plate into an elevated

position. DO NOT use the machine if found in this

condition. DO NOT attempt to fix. Notify your

authorized ParaBody dealer.

7. Inspect cables and their connections before using

machine. Pay particular attention to the cable ends.

DO NOT attempt to fix. Notify your authorized

ParaBody dealer before use and have repairs made by

an authorized service technician.

8. Make sure all spring loaded pull pins are fully

engaged in the adjustment position and fully tighten

thumbscrew before use.

9. Children must not be allowed near this machine.

Supervise teenagers.

IMPORTANT SAFETY INFORMATION

TABLE OF CONTENTS

Safety Statement.............2

General Notes..................3

Tools Required................3

Gym Layout.....................4

NOTE: In a continual effort to improve our products, specifications are subject to change

ParaBody is a trademark of Brunswick Corporation

www.parabody.com

Parts list..........................5

Assembly Instructions.....6-15

General Maintenance.......16

Warranty Statement..........17

Product Services..............18

Insert-Registration Card

IMPORTANT NOTES

Please note:

Tools Required forAssembly

* Thank you for purchasing the ParaBody 807 Gym System. Please read these

instructions thoroughly and keep them for future reference. This product must be assembled

on a flat, level surface to assure its proper function.

NOTE:BOLTLENGTHIS MEASURED FROMTHE UNDERSIDEOFTHEHEADOFTHE BOLT.

BOLT LENGTH RULER:

* This product must be assembled on a flat, level surface to assure its proper function. DO NOT

securely tighten any frame connections until the entire frame has been assembled, unless

otherwise stated.

Bolt Length Ruler

0123456

1/2 1/2 1/2 1/2 1/2 1/2

BOLT LENGTH

* 3/4” wrench

* 9/16” wrench

* Ratchet with 3/4” and 9/16” sockets

* Adjustable wrench

* Tape measure

1 Square = 1’ X 1’

1’ 2’ 3’ 4’ 5’ 6’ 7’

1’

5’

4’

3’

2’

PARTS LIST

KEY

37 5

PART #

7339309

7338609

6111010

7338910

6407810

6407310

6407210

6024710

6406401

7339801

6125101

6194601

6654521

6654421

3235204

3235211

3235212

3235312

3114403

3114502

3114702

3114401

6236701

3235501

6412001

6020601

3105401

3221705

6145801

3103101

6416601

3104301

6405201

7337110

3235436

3235208

3102416

QTY

DESCRIPTION

UPRIGHT FRAME

BENCH FRAME

HEIGHT ADJUSTMENT BAR

SEAT ADJUST

BASE LEG

SADDLE

LEG EXTENSION NECK

LEG EXTENSION

HINGE TAB

U-PIN

ROLLER PAD SHAFT

ROLLER PAD

SEAT PAD

BACK PAD

3/8 X 1” BOLT

3/8 X 2-3/4” BOLT

3/8 X 3” BOLT

1/2 X 3” BOLT

3/8” WASHER

3/8” LOCK WASHER

3/8” LOCK NUT

1/2” WASHER

1-3/4” SQ. END CAP

1/2” LOW HEIGHT LOCK NUT

3/8” SPRING PIN ASSEMBLY

1/2” FLANGE BEARING

3/4” STARLOCK COLLAR

E-RING

THUMBSCREW

1-1/4 X 5” GRIP

PARAGLIDE STRIP (8 ct.)

3/4” SQ. RUBBER BUMPER

2” SQ. END CAP

BACK PAD SUPPORT

1/2”X 9” BOLT

3/8” X 2” BOLT

1 X 2” END CAP

LEA

0123456

1/2 1/2 1/2 1/2 1/2 1/2

FIGURE 1

STEP 1:

10 31

• Attach eight PARAGLIDE STRIPS (31) to the SEATADJUST(4) (FOUR ON EACH END) as shown in FIGURE 1 using the

following steps:

• Thoroughly clean all surfaces where the PARAGLIDE STRIPS are to be attached.

• Remove the PARAGLIDE STRIPS from the paper backing and firmly apply them to all shown surfaces.

• Insert one U-PIN (10) through the BUSHING of the SEAT ADJUST (4) and attach one E-RING (28) to the end of the U-PIN (10)

as shown in FIGURE 1.

• SECURELY assemble one 3/8” SPRING PIN ASSEMBLY (25) to the SPRING PIN HOUSING on the SEATADJUST (4) as

shown in FIGURE 1. (!!! IMPORTANT !!! TIGHTEN THE NUTOFTHE SPRINGPINASSEMBLY SECURELY)

0123456

1/2 1/2 1/2 1/2 1/2 1/2

FIGURE 2

STEP 2:

10 5

• Pull back the SPRING PIN on the SEATADJUST (4) and slide it over the end of the BENCH FRAME (2) as shown in FIGURE 2.

Engage the SPRING PIN into one of the adjustment holes.

• Insert two 2” SQ. END CAPS (33) into both ends of the BASE LEG (5) as shown in FIGURE 2.

• Insert one U-PIN (10) through the BUSHING on the bottom of BENCH FRAME (2) and attach one E-RING (28) to the end of the

U-PIN (10) as shown in FIGURE 2.

• Insert the BASE LEG (5) into the front of the BENCH FRAME (2) as shown in FIGURE 2. (MAKE SURE THAT THE TAB

ON THE BASE LEG IS UNDER THE BENCH FRAME)

TAB

FIGURE 3

STEP 3:

• Secure the SEATADJUST (4) in place with one THUMBSCREW (29).

• Insert four 2” SQ. END CAPS (33) into the BASE TUBES of the UPRIGHT FRAME (1) as shown in FIGURE 3.

• SECURELY assemble the BENCH FRAME (2) to the UPRIGHT FRAME (1) using two 3/8 X 3” BOLTS (17), one 3/8 X 2-3/

4” BOLT (16), six 3/8” WASHERS (19), and three 3/8” LOCK NUTS (21) as shown in FIGURE 3.

3/8 X 3” 17

3/8 X 2-3/4” 16

0123456

1/2 1/2 1/2 1/2 1/2 1/2

• SECURELY assemble two 3/8” SPRING PIN ASSEMBLIES (25) to the SPRING PIN HOUSING on the UPRIGHT FRAME (1)

as shown in FIGURE 3. (NOTE: !!!IMPORTANT!!! Tighten the nut of the SPRING PIN ASSEMBLY SECURELY!)

FIGURE 4

STEP 4:

• Attach eight PARAGLIDE STRIPS (31) to both UPRIGHT TUBES on the UPRIGHT FRAME (1) (FOUR ON EACH END) as

shown in FIGURE 4 using the following steps:

• Thoroughly clean all surfaces where the PARAGLIDE STRIPS are to be attached.

• Remove the PARAGLIDE STRIPS from the paper backing and firmly apply them to all shown surfaces.

• Attach eight PARAGLIDE STRIPS (31) to each SADDLE (6) (FOUR ON EACH END) as shown in FIGURE 4.

• Slide two 1-1/4 X 5” GRIPS (30) over the DIP HANDLES of both SADDLES (6). (IF A LUBRICANT IS REQUIRED, COAT

THE INSIDE OF THE GRIP WITH RUBBING ALCOHOL.)

• Pull back the SPRING PIN on the UPRIGHT TUBES, and insert the SADDLES (6) as shown in FIGURE 4.. Slide the SADDLE

(6) down to the desired height and release the SPRING PIN into the hole.

• Secure the SADDLES (6) in place with two THUMBSCREWS (29) as shown in FIGURE 4.

• Attach two THUMBSCREWS (29) to the DIP TUBES on the UPRIGHT FRAME (1) as shown in FIGURE 4. When ready to

perform the DIP EXERCISE, simply insert the SADDLES (6) into the DIP TUBES and tighten the two THUMBSCREWS

FIGURE 5

STEP 5:

3/8 X 1”

0123456

1/2 1/2 1/2 1/2 1/2 1/2

• AssembletheBACKPAD (14) to the two BACK PAD SUPPORTS (34) using four 3/8 X 2” BOLTS (36), four 3/8” LOCKWASHERS

(20)andfour3/8”WASHERS(19).

3/8X2”

• Insertone1 X 2” END CAP(37)into each BACK PAD SUPPORT (34)

7/8”

NOTE:

Holes in items 34

are not centered

• Assemble the SEAT PAD (13) to the two HINGE TABS (9) using two 3/8 X 1” BOLTS (15), two 3/8” LOCK WASHERS (20),

and two 3/8” WASHERS (19).

Tabla de contenidos

Otros manuales de Gimnasio en casa de ParaBody

ParaBody

ParaBody 880 Manual de usuario

ParaBody

ParaBody 336101 Manual de usuario

ParaBody

ParaBody 841101 Manual de usuario

ParaBody

ParaBody 893103 Manual de usuario

ParaBody

ParaBody 829 Manual de usuario

ParaBody

ParaBody 435104 Manual de usuario

ParaBody

ParaBody 909101 ST Manual de usuario

ParaBody

ParaBody Serious Steel 425 Manual de usuario

ParaBody

ParaBody 950 st Manual de usuario

ParaBody

ParaBody PBF011 Manual de usuario

ParaBody

ParaBody 454 Manual de usuario

ParaBody

ParaBody 912101 Manual de usuario

ParaBody

ParaBody 360101 Manual de usuario

ParaBody

ParaBody PBF005B Manual de usuario

ParaBody

ParaBody 216 Manual de usuario

ParaBody

ParaBody 440 GYM SYSTEM Manual de usuario

ParaBody

ParaBody Parabody 805101 Manual de usuario

ParaBody

ParaBody 701 Manual de usuario

ParaBody

ParaBody 465104 Manual de usuario

ParaBody

ParaBody 913101 Manual de usuario

ParaBody

ParaBody 76 Manual de usuario

ParaBody

ParaBody 445103 Manual de usuario

ParaBody

ParaBody PBF410A Manual de usuario

ParaBody

ParaBody 426103 Manual de usuario

Manuales populares de Gimnasio en casa de otras marcas

Horizon Fitness

Horizon Fitness OXFORD 6 Manual de usuario

Energetics

Energetics Multi Trainer 5.1 Manual de usuario

Matrix

Matrix MG-PL Series Manual de usuario

Reebok

Reebok Tbr2i Manual de operación y mantenimiento

Weider

Weider 8300 Hard Drive Manual de usuario

Pure Fitness

Pure Fitness 8526HE Manual de usuario

Weider

Weider 8700 I Guía de inicio rápido

Bowflex

Bowflex Sport 001-6961 Manual de usuario

NordicTrack

NordicTrack E8200 Competition Bench Guía de inicio rápido

Weider

Weider WEMC10161 Manual de usuario

Body Solid

Body Solid GHYP-345 Manual de usuario

Evo

Evo TAHOE 5105 Manual de usuario

cardiobull

cardiobull RA17 Manual de usuario

JLL

JLL Ventus Pro Air Power Manual de usuario

Trojan

Trojan Colorado 370 Manual de usuario

Octane Fitness

Octane Fitness xRide xR650 Manual de usuario

Precor

Precor Discovery Series Manual de usuario

Insportline

Insportline RW600 Manual de usuario