Outback THG3302S Manual de usuario
Photographs are not to scale.
Specifications subject to change
without prior notice.
Assembly and Operating Instructions for Outback®
Hunter Stainless Steel Gas Barbecue
0359
WARNING
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open barbecue lid or hood.
4. If odour continues, discontinue use and
contact your local dealer.
FOR YOUR SAFETY
1. Do not store or use petrol or other flammable
vapours or liquids in the vicinity of this or any
other appliance.
2. A gas bottle not connected for use shall not be
stored in the vicinity of this or any other
appliance.
• For outdoor use only.
• Read instructions before using the appliance. Failure to follow instructions could
result in death, serious bodily injury, and/or property loss.
• Warning: accessible parts may be very hot. Keep young children away.
• Do not move the appliance during use.
• Turn off the gas supply at the gas bottle after use.
• Any modification of the appliance, misuse, or failure to follow the instructions
may be dangerous and will invalidate your warranty. This does not affect your
statutory rights.
• Retain these instructions for future reference.
• Leak test annually, and whenever the gas bottle is removed or replaced. Check
the hose connections are tight and leak test each time you reconnect the gas
bottle.
THG3302S
2
A. Parts List
Quantity varies according to model purchased. Specifications subject to change without prior notice. For
more details on hardware, please see the corresponding ‘Hardware Reference Diagram’.
Pre-Assembled Component
CODE PART QTY Outback® Hunter
Stainless Steel
HOOD
A1 Hood (Pre-Assembled to Body) 1
A2 Hood Handle 1
A3 Hood Hinge Pin 2
A4 R-Clip 2
A5 Heat Indicator and Nuts 1
A6 WarmingRack 1
BODY
B1 Barbecue Body 1
B2 Burner 3
B3 Control Panel 1
B4 Knob 3
B5 Hose / Regulator Assembly 1
B6 Lava Rock in basket 2
B7 Large Cooking Grill 1
B8 Small Cooking Grill 1
B9 Cooking Griddle 1
B10 Drip Tray Left Bracket 1
B11 Drip Tray Right Bracket 1
B12 Drip Tray 1
TROLLEY
C1 Side Shelf 2
C2 Left Front Leg 1
C3 Left Rear Leg 1
C4 Right Front Leg 1
C5 Right Rear Leg 1
C6 Front Screen 1
C7 Leg Endcap 2
C8 Wheel 2
C9 Hubcap 2
C10 Axle 1
C11 Trolley Base 1
HARDWARE
D1 M5x15 Bolt 4
D2 Ø5 Washer 4
D3 M5 Nut 4
D4 1/4-20UNCx22 Bolt 24
D5 M6x95 Bolt 8
D6 Ø6 Spacer 8
D7 Axle Washer 2
D8 Locknut 2
3
B. Parts Diagram
Quantity varies according to model purchased. Specifications subject to change without prior notice. For
more details on hardware, please see the corresponding ‘Hardware Reference Diagram’.
C1 C5
C2
C10
C8 C9
D7
C6
C11
B5
A1 A4
A3
B3
B2
B4
A5
B1
A6
B6
B7 B9
C3 C4
C7
B10 B11
B12
D8
A2
B8
4
C. Hardware Reference Diagram
Specifications subject to change without prior notice.
D4
D1, D2, D3
D5, D6
5
D. Assembly
IMPORTANT!
• TOOLS NEEDED FOR ASSEMBLY: Medium size flat blade or Phillips/Crosspoint screwdriver,
adjustable spanner or metric spanner set.
• The assembly of this barbecue requires 2 people.
• Whilst every care is taken in the manufacture of this product, care must be taken during assembly in
case sharp edges are present.
• Please read the Important Information section carefully before assembly and use of your
barbecue.
Attach the Legs (C2,C3,C4,C5) to the Trolley Base (C11) using the 1/4-20UNCx22 Bolts (D4).
Ensure that the legs with the Velcro attached to them are at the front of the barbecue, facing
inwards.
1
2
Attach the Side Shelves (C1) to the Front/Rear Left Legs (C2,C3) and Front/Rear Right
Legs (C4,C5) using the 1/4-20UNCx22 Bolts (D4).
D5
C2
C1
C4
C3 C5
(Photo depicts trolley
from the reverse side)
C3 C2 C4
C5
C11
6
Remove all cooking components, lava rock, and any internal packaging from the Barbecue
Body (B1).
3
4
Turn the trolley over so that it stands on its side shelves.
Unscrew the Locknuts (D8) from both ends of the Axle (C10) and remove the Axle Washers (D7).
Slide the axle through the corresponding holes in the left legs. Place axle washers on each end of
the axle. Slide the Wheels (C8) over each end of the axle. Secure the wheels into place with the
locknuts. Place the wheel Hubcaps (C9) onto the outsides of the wheels.
Carefully turn the completed trolley over, right side up.
D8
C8
D7
C9
C10
B7 B8
B6
B9
7
Lay the assembled trolley on its side. Lay the Barbecue Body (B1) on its back and slide into
position between the trolley legs. CAUTION! Care must be taken to ensure the hood or lid
does not fall open unexpectedly or becomes damaged when it is set on the ground. When
positioning the body of the barbecue, ensure the control panel is on the same side as the legs
with Velcro fastenings.
With the barbecue laid on the ground, insert a M6x95 Bolt (D5) through the front left leg, through
a Spacer (D6), and screw the bolt into the sidewall of the body completely. Repeat the process
for all the legs until the barbecue body is completely fixed to the trolley.
5
6
B1
B1
D6D5
8
7
8
Carefully stand the barbecue upright, taking care to ensure the hood or lid does not fall open
unexpectedly.
Attach Drip Tray Right Bracket (B11) to barbecue body using M5x15 Bolts (D1), Ø5 Washers (D2)
and M5 Nuts (D3) as shown. Repeat above process for Drip Tray Left Bracket (B10).
Insert the Drip Tray (B12) by sliding it underneath the barbecue body.
D1
D2
B12
9
9
10
A6
Carefully lay the Lava Rock (B6) into the body ensuring it lies level within the body. Lay the Grills
(B7, B8) and Griddle (B9) into place.
3 burner model configuration: Left — Cooking Grills, Right — Cooking Griddle,
NOTE: Ensure that the lava rock lies directly underneath the grills.
Insert the Warming Rack (A6) into the hood and barbecue body. Make sure that the
swing legs fix to the body of the barbecue and the shorter fixed legs go through the holes
in the hood.
10
11
12
Connect the gas hose to the barbecue.
Ensure the mating faces of the connection are clean and not damaged. Do not use
any sealing tape, paste, or liquid on the connection. The nut must be tightened with
the use of a spanner. Do not use force which may damage the assembly.
(Rear view of the barbecue trolley.)
Attach the Front Screen (C6) to the front left/right legs as
C6
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Parrilla de Outback
Outback
Outback THG2302-3 Manual de usuario
Outback
Outback Excel 100T Manual de usuario
Outback
Outback Senator 6 Manual de usuario
Outback
Outback Meteor Select 3 Burner Gas BBQ MH3330 Manual de usuario
Outback
Outback THG3302P Manual de usuario
Outback
Outback Omega 150 Manual de usuario
Outback
Outback Meteor Select MS4431 Manual de usuario
Outback
Outback Diamond Hooded Manual de usuario
Outback
Outback Excel 310 Manual de usuario
Outback
Outback Professional Range Pro 6 Manual de usuario
Outback
Outback Meteor 4S Manual de usuario
Outback
Outback Sapphire 2 Burner Manual de usuario
Outback
Outback Trekker Manual de usuario
Outback
Outback OUT371036 Manual de usuario
Outback
Outback Spectrum 2 Burner Manual de usuario
Outback
Outback Hunter Manual de usuario
Outback
Outback Omega 100 Manual de usuario
Outback
Outback Excel 310 Manual de usuario
Outback
Outback Spectrum 2 Burner Manual de usuario
Outback
Outback ONYX 4 Burner Manual de usuario
