Oki 4336822A Manual de operación y mantenimiento
RFID(4336821A)installationprocedure.
Plate-Inner
Plate-Shield-RFID
1. To assemble Board-RFID to Plate-Shield-RFID
with two screws.
※RFID Assy – PCB
2. To assemble RFID Assy-PCB to Plate-Inner with
two screws.
Film
Board-RFID
after assembly
※Plate Assy – Inner (4336821A)
A toner cartridge is equipped with RF-ID TAG.
If toner cartridges are set to a printer, communication of RF-ID TAG and a RFID read writer module will be attained.
The function of this system is the following: Management of the existence detection and toner residual quantity of a toner cartridge.
4336822A are attached printer base unit according to the following figure.
RFID (4336822A) installation procedure
1
(4336822A)
Plate Assy-Inner
(4336821A)
Cover-Top(Sub)
To assemble Head-Cable, Holder-Head,
Cover–Top(Sub) and etc to Plate Assy
–
Inner (4336821A) with 8 screws.
※Cover Assy - Top
2
(4336822A)
(4336822A)
Printer-Unit
Cover Assy - Top
To assemble Cover Assy –Top to
Printer-Unit.
3
FCC WARNING
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
4
Tabla de contenidos
Otros manuales de Accesorios de impresora de Oki
Oki
Oki ES3640eMFP Manual de usuario
Oki
Oki ML520n Manual de usuario
Oki
Oki B6500 Series Manual de usuario
Oki
Oki C9300 Series Guía
Oki
Oki OKICOLOR8n Guía
Oki
Oki ML520n Manual de usuario
Oki
Oki LP441s Manual de usuario
Oki
Oki C5300n Manual de usuario
Oki
Oki B 4600n Manual de usuario
Oki
Oki C9600hdn Manual de usuario
Oki
Oki 59375102 Manual de usuario
Oki
Oki B721dn Manual de usuario
Oki
Oki B4400 Series Manual de usuario
Oki
Oki CX 1145 MFP Manual de usuario
Oki
Oki 4465871A Guía del usuario
Oki
Oki C9300 Series Manual de usuario
Oki
Oki MPS4200mb Instrucciones de funcionamiento y mantenimiento
Oki
Oki C330dn Manual de usuario
Oki
Oki C 9650dn Manual de usuario
Oki
Oki T400 Manual de usuario
