Nibe F2016 Guía del usuario

Installer manual

LEK

NIBE™ F2016

UK 1x230V

Air/water heat pump

IHB GB 1244-2

031885

Table of Contents

1 Important information 2

Safety information 2

2 Delivery and handling 5

Transport and storage 5

Assembly 5

Supplied components 8

Removing the covers 8

3 The heat pump design 9

General 9

Electrical cabinets 11

4 Pipe connections 12

General 12

Pipe coupling heating medium circuit 12

Pressure drop, heating medium side 13

Docking alternatives 14

5 Electrical connections 20

General 20

Connections 21

Optional connections 23

Connecting accessories 24

6 Commissioning and adjusting 25

Preparations 25

Filling and venting the heating medium sys-

tem 25

Balance temperature 25

Stop temperature 25

Soft-starter 25

Compressor heater 25

Collar heater 25

Start-up and inspection 26

Readjusting, heating medium side 26

Adjustment, charge flow 27

7 Control - Introduction 28

General 28

Navigation 28

Display explanation 29

Control conditions 30

8 Control - Channels 32

Status channels 32

Temperature channels 32

Setting channels 32

9 Servicing and maintenance 34

Important 34

General inspection 34

Heating System 34

10 Disturbances in comfort 35

Troubleshooting 35

11 Accessories 39

12 Technical data 40

Dimensions and setting-out coordinates 40

Sound pressure levels 41

Technical specifications 42

Electrical circuit diagram 44

Item register 49

1Table of Contents |NIBE™ F2016

Safety information

This manual describes installation and service procedures

for implementation by specialists.

This appliance is not intended for use by persons (includ-

ing children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concern-

ing use of the appliance by a person responsible for their

safety.

Children should be supervised to ensure that they do not

play with the appliance.

Rights to make any design or technical modifications are

reserved.

©NIBE 2012.

Symbols

NOTE

This symbol indicates danger to machine or

person.

Caution

This symbol indicates important information

about what you should observe when maintain-

ing your installation.

TIP

This symbol indicates tips on how to facilitate

using the product.

Marking

F2016 is CE marked and fulfils IP24.

The CE marking means that NIBE ensures that the product

meets all regulations that are placed on it based on relev-

ant EU directives. The CE mark is obligatory for most

products sold in the EU, regardless where they are made.

IP24 means that the product is secure against penetration

by objects with a diameter larger than or equivalent to

12.5 mm and that the product is protected against drops

from all directions.

Serial number

The serial number can be found on the product's foot.

LEK

6HULDO QXPEHU

Caution

Always give the product's serial number when

reporting a fault.

Country specific information

Installer manual

This installer manual must be left with the customer.

Great Britain

This installation is subject to building regulation approval,

notify the local Authority of intention to install.

Use only manufacturer’s recommended replacement

parts.

Benchmark places responsibilities on both manufacturers

and installers. the purpose is to ensure that customers

are provided with the correct equipment for their needs,

that it is installed, commissioned and serviced in accord-

ance with the manufacturers instructions by competent

persons and that it meets the requirements of the appro-

priate Building Regulations. The Benchmark Checklist can

be used to demonstrate compliance with Building Regu-

lations and should be provided to the customer for future

reference.

Installers are required to carry out the installation, com-

missioning and servicing work in accordance with the

Benchmark Code of practice which is available from the

Heating and Hotwater Industry Council who manage and

promote the Scheme. Visit www.centralheating.co.uk for

information.

NIBE™ F2016Chapter 1 | Important information2

1 Important information

Warranty and insurance information

Thank you for installing a new NIBE heat pump in your

home.

NIBE heat pumps are manufactured in Sweden to the

very highest standard so we are pleased to offer our

customers a comprehensive guarantee.

The product is guaranteed for 24 months for parts and

labour from the date of installation or 33 months from

the date of manufacture, whichever is the shorter.

The NIBE guarantee is based on the unit being installed

and commissioned by a NIBE accredited installer, serviced

every year and the Benchmark documents completed.

Where this condition is not met, any chargeable spare

parts or components issued within the applicable guaran-

tee period still benefit from a 12 month warranty from

the date of issue by the manufacturer.

We recommend the installer completes and returns as

soon as possible, your guarantee registration card or

completes the guarantee form on the NIBE website

www.nibe.co.uk.

Electrical Supply

The heat pump must be permanently connected to a

230V ac 50Hz supply.

All system components shall be of an approved type and

all wiring to current I.E.E wiring regulations.

External wiring must be correctly earthed, polarised and

in accordance with the relevant standards: Currently this

is BS 7671.

Heating System

The installation of the heat pump should follow best

practice as covered in the following:

BS 5449 Forced circulation hot water central heating

systems for domestic premises.

BS 15450 Heating systems in buildings – Design of heat

pump heating systems.

3Chapter 1 | Important informationNIBE™ F2016

Inspection of the installation

Current regulations require the heating installation to be inspected before it is commissioned. The inspection must be

carried out by a suitably qualified person. Fill in the page for information about installation data in the User manual.

DateSignatureNotesDescription

✔

Heating medium (page 12)

System flushed

System vented

Particle filter

Shut-off and drain valve

Charge flow set

Electricity (page 20)

Fuses property

Safety breaker

Earth circuit-breaker

Heating cable type/effect

Fuse size, heating cable (F3)

Communication cable connected

Miscellaneous

Condensation water pipe

Insulation condensation water pipe, thick-

ness (if KVR 10 is not used)

Warranty

Benchmark checklist

NIBE™ F2016Chapter 1 | Important information4

Transport and storage

F2016 must be transported and stored vertically.

Assembly

႑Place F2016 outdoors on a solid level base that can

take the weight, preferably a concrete foundation. If

concrete slabs are used they must rest on asphalt or

shingle.

႑The concrete foundation or slabs must be positioned

so that the lower edge of the evaporator is at the level

of the average local snow depth, although a minimum

of 300 mm.

႑The F2016 should not be positioned next to sensitive

walls, for example, next to a bedroom.

႑Also ensure that the placement does not inconveni-

ence the neighbours.

႑F2016 must not be placed so that recirculation of the

outdoor air can occur. This causes lower output and

impaired efficiency.

႑The evaporator should be sheltered from direct wind.

Place F2016 protected from wind against the evapor-

ator.

႑Large amounts of condensation water as well as melt

water from defrosting can be produced. Condensation

water must be led off to a drain or similar (see page

6).

႑Care must be exercised so that the heat pump is not

scratched during installation.

LEK LEK

PLQ  PP

Do not place F2016 directly on the lawn or other non

solid surface.

If there is a risk of snow slip from roof, a protective roof

or cover must be erected to protect the heat pump, pipes

and wiring.

5Chapter 2 | Delivery and handlingNIBE™ F2016

2 Delivery and handling

Condensation water trough

The condensation water trough is used to collect and

lead away condensation water from the heat pump.

NOTE

It is important to the heat pump function that

condensation water is led away and that the

drain for the condensation water run off is not

positioned so that it may cause damage to the

house.

NOTE

Pipe with heating cable for draining the condens-

ation water trough are not included.

NOTE

To ensure this function the accessory KVR 10

should be used.

NOTE

The electrical installation and wiring must be

carried out under the supervision of an author-

ised electrician.

Caution

If none of the recommended alternatives is used

good lead off of condensation water must be

assured.

႑The condensation water (up to 50 litres/day) collected

in the trough should be routed by pipe to an appro-

priate drain, it is recommended that the shortest

outdoor stretch possible is used.

႑The section of the pipe that can be affected by frost

must be heated by the heating cable to prevent

freezing.

႑Route the pipe downward from F2016.

႑The outlet of the condensation water pipe must be

at a depth that is frost free or alternatively indoors

(with reservation for local ordinances and regulations).

႑Use a water trap for installations where air circulation

may occur in the condensation water pipe.

႑The insulation must be tight against the bottom of

the condensation water trough.

Recommended alternatives

Stone caisson

LEK

Frostfritt

djup

)URVW SURRI

GHSWK

If the house has a cellar the caisson must be positioned

so that it does not affect the house. Otherwise the caisson

can be positioned directly under the heat pump.

The outlet of the condensation water pipe must be at

frost free depth.

Drain indoors

:DWHU VHDO

The condensation water can be routed to a drain indoors

(with reservations for local rules and regulations).

Route the pipe downward from F2016.

The condensation water pipe must have a water trap to

prevent air circulation in the pipe.

NIBE™ F2016Chapter 2 | Delivery and handling6

Gutter drainage

LEK

Frostfritt

djup

)URVW SURRI

GHSWK

:DWHU VHDO

The outlet of the condensation water pipe must be at

frost free depth.

Route the pipe downward from F2016.

The condensation water pipe must have a water trap to

prevent air circulation in the pipe.

Installation area

The distance between F2016 and the house wall must

be at least 350 mm. Clearance in front of F2016 should

be at least one metre.

Fritt utrymme framför

Fritt utrymme

min. 400 mm

Fritt utrymme

min. 400 mm

350 mm

utrymme

3000 mm

)UHH VSDFH

PLQ  PP

)UHH VSDFH EHKLQG

)UHH VSDFH LQ IURQW

)UHH VSDFH

PLQ  PP

P

7Chapter 2 | Delivery and handlingNIBE™ F2016

Supplied components

LEK

Particle filterR25

2 flexible hoses (R25) with

4 seals

Removing the covers

NIBE™ F2016Chapter 2 | Delivery and handling8

Otros manuales para F2016

Tabla de contenidos

Otros manuales de Bomba de calor de Nibe

Nibe

Nibe HMF 10-55 Guía del usuario

Nibe

Nibe S1155 Manual de usuario

Nibe

Nibe FIGHTER 360P Manual de usuario

Nibe

Nibe Fighter 2005 Manual de funcionamiento original

Nibe

Nibe F1145 5 Guía del usuario

Nibe

Nibe DRAZICE TJ 2 EHP 6 kW Hoja de especificaciones

Nibe

Nibe F110 Guía del usuario

Nibe

Nibe F470 Guía del usuario

Nibe

Nibe F2030 Manual de usuario

Nibe

Nibe F470 Manual de usuario

Nibe

Nibe AG-AC10-42 Guía del usuario

Nibe

Nibe F2040 Series Manual de usuario

Nibe

Nibe F1330 Guía de inicio rápido

Nibe

Nibe S1155PC Guía del usuario

Nibe

Nibe FIGHTER 1240 Manual de usuario

Nibe

Nibe AP-BW30 Manual de usuario

Nibe

Nibe F2025 Manual de usuario

Nibe

Nibe F2016 Manual de usuario

Nibe

Nibe VVM 310 Guía del usuario

Nibe

Nibe F370 Guía del usuario

Nibe

Nibe HBS 05 Guía del usuario

Nibe

Nibe F2040 Series Guía del usuario

Nibe

Nibe S1156 Guía del usuario

Nibe

Nibe F1345 Series Guía del usuario

Manuales populares de Bomba de calor de otras marcas

MICROWELL

MICROWELL HP 1000 GREEN Manual de usuario

Sanyo

Sanyo SAP120FCH Manual de usuario

Daikin

Daikin EHYHBH05AA Manual de usuario

Panasonic

Panasonic WH-SDF03E3E5 Guía

Bryant

Bryant 544B Manual de usuario

Airxcel

Airxcel 45000 Series Manual

Mitsubishi Electric

Mitsubishi Electric PUZ-SWM60VAA Manual de usuario

Dimplex

Dimplex LI 16I-TUR Guía del usuario

Carrier

Carrier WSHP Open v3 Guía de configuración rápida

TGM

TGM CTV14CN018A Manual de usuario

Carrier

Carrier 38MGQ Series Manual de usuario

Kokido

Kokido K2O K880BX/EU Guía de solución de problemas

Viessmann

Viessmann VITOCAL 300-G PRO Type BW 2150 Guía rápida

Carrier

Carrier 48EZN Manual de usuario

Viessmann

Viessmann KWT Vitocal 350-G Pro Series Instrucciones de funcionamiento

Ariston

Ariston NIMBUS Manual de usuario

Weishaupt

Weishaupt WWP L 7 Guía del usuario

GE Zoneline AZ85H09EAC Manual de usuario