ML Accessories WAD12AA Manual de instrucciones

INSTALLATION & MAINTENANCE MANUAL

WAD12AA / WAD12ABK

These instructions should be read carefully and retained after installation by the

end user for future reference and maintenance.

These instructions should be used to aid installation of the following product(s):

WAD12AA / WAD12ABK

GENERAL INSTRUCTIONS

SAFETY

•This product must be installed in accordance with the latest edition of the IEE Wiring

Regulations (BS7671) and current Building Regulations. If in any doubt, consult a

qualiﬁed electrician

•Please isolate mains prior to installation or maintenance

•Check the total load on the circuit (including when this luminaire is ﬁtted) does not exceed

the rating of the circuit cable, fuse, or circuit breaker

•Please note the IP (Ingress Protection) rating of this luminaire when deciding the location

for installation

•This product is IP65 rated

•This product is Class I and must be earthed

INSTALLATION

Note - If this product is being used in conjunction with an external PIR or sensor, please

conﬁrm with the manufacturer of the sensors that they are compatible with LED luminaires.

•Provide power to the required point of installation (refer to BS7671 for correct cabling

methods). Suitable IP rated junction boxes should be used where required

•Round cable should be used for the mains supply. The use of ﬂat cable will cause water

ingress to the ﬁtting

•Using the Allen key provided, unfasten the screws on either side and remove the backplate

•Using the backplate as a template, mark the location for, and drill the ﬁxing holes ensuring

not to infringe with any gas/water pipes or electrical cables

•Feed the mains cable through the rubber grommet to retain IP rating, and secure the

backplate to the surface using the screws provided. Rubber washers or sealant should be

applied around the screw heads to prevent water ingress

•Connect the luminaire to the mains supply ensuring the correct polarity is observed

(see Fig. 1): L - Live (brown), E - Earth (green/yellow), N - Neutral (blue)

Fig.1

Fig. 2

•Secure the mains cable under the cable clamp and refit the terminal cover

•Switch on and check for correct operation

WARNING

This luminaire must be disconnected from the circuit if subjected to any high voltage or insulation resistance

testing. Irreparable damage will occur if this instruction is not followed.

GENERAL

This luminaire should be recycled in the correct manner when it reaches the end of its life. Check local

authorities for where facilities exist.

The LED lamps fitted in this product are non-replaceable. The luminaire should be recycled in the correct

manner when it reaches the end of its life. Check local authorities for where facilities exist.

Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the

luminaire.

This luminaire is non-dimmable.

WARRANTY

This luminaire has a warranty of 3 years from the date of purchase. Failure to install this product in accordance

with the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will

invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place of

purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation

costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve

the right to alter product specification without prior notice.

KOFEB20_V1

•Refasten the cover

•Switch on and check for correct operation

•Should the protective glass be cracked or damaged it should be replaced immediately

•This ﬁtting must not be used without the protective glass installed

WARNING

This product must be disconnected from the circuit if subjected to any high voltage or

insulation resistance testing. Irreparable damage will occur if this instruction is not followed.

This product is not suitable for installation in or near a coastal or marine environment.

GENERAL

This product contains light sources of energy efﬁciency class E to Regulation (EU)

No. 2019/2015. This product contains a non-replaceable LED light source and a control

gear which can be replaced by a professional.

Clean the external surfaces with a damp cloth using a mild solution of detergent and warm

water only, do not use aggressive cleaning products or solvents which may damage the

product.

This product is non-dimmable.

This product should be dismantled for disposal when it reaches the end of its life. Please

see website for dismantling instructions.

This product should be recycled in the correct manner when it reaches the end of its life.

Check local authorities for where facilities exist.

WARRANTY

This product has a warranty of 3 years from date of purchase. Failure to install this product

in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper

use, or removal of the batch code will invalidate the warranty. If this product should fail

within its warranty period, it should be returned to the place of purchase for a free of

charge replacement. ML Accessories does not accept responsibility for any installation

costs associated with the replacement product. Your statutory rights are not affected. ML

Accessories reserve the right to alter product speciﬁcation without prior notice.

Non-replacable light source

AKJUL21_V2

130

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Equipo de iluminación de ML Accessories

ML Accessories

ML Accessories WALL1 Manual de instrucciones

ML Accessories

ML Accessories BT ACT Series Manual de instrucciones

ML Accessories

ML Accessories SHE1BEM Manual de instrucciones

ML Accessories

ML Accessories T8BLED15EM1 Manual de instrucciones

ML Accessories

ML Accessories TRIBCCW Manual de instrucciones

ML Accessories

ML Accessories E27PR Manual de instrucciones

ML Accessories

ML Accessories CABBCCW Manual de instrucciones

ML Accessories

ML Accessories EA1 Series Manual de instrucciones

ML Accessories

ML Accessories MLRCTM2 Manual de instrucciones

ML Accessories

ML Accessories BT ACTS Series Manual de instrucciones

ML Accessories

ML Accessories TRLED14EM Manual de instrucciones

ML Accessories

ML Accessories OPRCDKIT Manual de instrucciones

ML Accessories

ML Accessories EMPOWER2 Manual de instrucciones

ML Accessories

ML Accessories RDSHCBR Manual de instrucciones

ML Accessories

ML Accessories Knightsbridge LEDF24RGB Manual

ML Accessories

ML Accessories SURF236HF Manual de instrucciones

ML Accessories

ML Accessories LWR2G Manual de instrucciones

ML Accessories

ML Accessories LSPIKEA Manual de instrucciones

ML Accessories

ML Accessories FLP Series Manual de instrucciones

ML Accessories

ML Accessories TPR14LEDS Manual de instrucciones

ML Accessories

ML Accessories CAPWGU Manual de instrucciones

ML Accessories

ML Accessories EMPDL Manual de instrucciones

ML Accessories

ML Accessories LFC24B M Series Manual de instrucciones

ML Accessories

ML Accessories RD1 Series Manual de instrucciones

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario