ML Accessories EMKIT2 Manual de instrucciones

INSTALLATION & MAINTENANCE MANUAL

EMKIT2

These instructions should be read carefully and retained after installation by the end user for future

reference and maintenance.

These instructions should be used to aid installation of the following product:

EMKIT2

GENERAL INSTRUCTIONS

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)

and current Building Regulations. If in any doubt, consult a qualiﬁed electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this product is ﬁtted) does not exceed the rating of the

circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

• Choose a suitable location for the ﬁtting allowing a 50mm space above and around the product

• This product must not be covered by insulation

• Do not overload this accessory or subject it to conditions outside its rating

• This product is Class II double insulated

• This product is IP20 rated (indoor use only)

SAFETY

• Provide power to the required point of installation (refer to BS7671 for correct cabling methods)

• Connect the cable marked “AC Mains” to the permanent Live (Brown) and Neutral (Blue)

(see Fig. 1)

• Connect the cable marked “LED Load” to the LED

• Connect the cable marked “LED Driver” to the secondary side of the compatible driver

Note: Some luminaires may have the connections reversed, in this case please use the adaptors provided to

convert a Female to a Male connector and a Male to Female connector (see Fig. 2)

INSTALLATION

Fig. 2

Fig. 1

• Switch on and check for correct operation ensuring that the green LED indicator is illuminated

We recommend, on commissioning the installation, a minimum charge period of 24 hours before carrying

out an emergency duration test

If the batteries have been left in a discharged state for an extended period, we recommend that one or more

charge and discharge cycles are completed which should help to restore the battery capacity

• The product comes equipped with two LED indicator holders. To install, mark the location of the LED

indicator holder and drill a 6.5mm/18mm hole ensuring it does not infringe with any joists, gas/water pipes

or electrical cables

Note: The LED indicator needs to be visible

This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance

testing. Irreparable damage will occur if this instruction is not followed.

WARNING

This product should be recycled in the correct manner when it reaches the end of its life. Check local

authorities for where facilities exist.

The batteries in this luminaire are Nickel Cadmium and must be disposed of correctly. Please contact the

local authorities for the disposal of this toxic waste.

GENERAL

This product has a warranty of 3 years (excluding battery) from date of purchase. Failure to install this

product in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper use, or

removal of the batch codes will invalidate the warranty. If this product should fail within its warranty period, it

should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept

responsibility for any installation costs associated with the replacement product. Your statutory rights are not

affected. ML Accessories reserve the right to alter product speciﬁcation without prior notice.

WARRANTY

TEST RECORD SHEET

INITIAL COMMISSIONING

3 HOUR TEST

SIGNED DATE

MONTH TEST

FIRST YEAR SECOND YEAR THIRD YEAR FOURTH YEAR FIFTH YEAR

SIGNED DATE SIGNED DATE SIGNED DATE SIGNED DATE SIGNED DATE

1 FUNCTIONAL

2 FUNCTIONAL

3 FUNCTIONAL

4 FUNCTIONAL

5 FUNCTIONAL

6 FUNCTIONAL

7 FUNCTIONAL

8 FUNCTIONAL

9 FUNCTIONAL

10 FUNCTIONAL

11 FUNCTIONAL

12 3 HOUR

Installed by: Installation date:

Contact number:

Recommended routine test procedure in accordance with BS5266

• Daily check – check LED charge indicator is illuminated

• Monthly functional test - simulate a mains supply failure for approx. 30 seconds by operation

of key switch or switching off circuit breaker. Ensure normal supply is restored after test and ensure

charge indicator is illuminated

• Annual three hour duration test - simulate a mains supply failure for three hour continuous test by

operation of key switch or switching off circuit breaker. Ensure normal supply is restored after test and

ensure charge indicator is illuminated

• If the luminaire fails any of the above tests, please contact a qualiﬁed electrician.

See below for test record sheet

TESTING FOR EMERGENCY LUMINAIRES

AVMAY21_V3

ML Accessories Limited LU5 4LT

www.mlaccessories.co.uk

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

Tabla de contenidos

Otros manuales de Equipo de iluminación de ML Accessories

ML Accessories

ML Accessories BATSCWMST4 Manual de instrucciones

ML Accessories

ML Accessories TRIBCCW Manual de instrucciones

ML Accessories

ML Accessories BL01BK Manual de instrucciones

ML Accessories

ML Accessories FLP Series Manual de instrucciones

ML Accessories

ML Accessories SHE1BEMP Manual de instrucciones

ML Accessories

ML Accessories NH019W Manual de instrucciones

ML Accessories

ML Accessories FL8ABK Manual de instrucciones

ML Accessories

ML Accessories POTHB1 Manual de instrucciones

ML Accessories

ML Accessories EMLSUS Manual de instrucciones

ML Accessories

ML Accessories SHE1B Manual de instrucciones

ML Accessories

ML Accessories LSPIKEA Manual de instrucciones

ML Accessories

ML Accessories SPIKE5S Manual de instrucciones

ML Accessories

ML Accessories EMPOWER3 Manual de instrucciones

ML Accessories

ML Accessories AC65136EM Manual de instrucciones

ML Accessories

ML Accessories TRLED12 Manual de instrucciones

ML Accessories

ML Accessories NH027 Manual de instrucciones

ML Accessories

ML Accessories BATSCWST4 Manual de instrucciones

ML Accessories

ML Accessories SHE1BEM Manual de instrucciones

ML Accessories

ML Accessories RD1 Series Manual de instrucciones

ML Accessories

ML Accessories EA1 Series Manual de instrucciones

ML Accessories

ML Accessories AX CCT Manual de instrucciones

ML Accessories

ML Accessories EMLRECL Manual de instrucciones

ML Accessories

ML Accessories ENM5C Manual de instrucciones

ML Accessories

ML Accessories SPIKEW Manual de instrucciones

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario