ML Accessories BL5BK Manual de instrucciones

INSTALLATION & MAINTENANCE MANUAL

BL5BK / BL5G / BL5BLBK / BL5BLG

BLKITBK / BLKITG

These instructions should be read carefully and retained after installation by the

end user for future reference and maintenance.

These instructions should be used to aid installation of the following products:

BL5BK / BL5G / BL5BLBK / BL5BLG / BLKITBK / BLKITG

GENERAL INSTRUCTIONS

SAFETY

• This product must be installed in accordance with the latest edition of the IEE Wiring

Regulations (BS7671) and current Building Regulations. If in any doubt, consult a

qualiﬁed electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this luminaire is ﬁtted) does not exceed

the rating of the circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location

for installation

• This product is Class II double insulated

• This product is IP65 rated

INSTALLATION

Note - If this product is being used in conjunction with an external PIR or sensor, please

conﬁrm with the manufacturer of the sensors that they are compatible with LED luminaires.

• Provide power to the required point of installation (refer to BS7671 for correct cabling

methods). Suitable IP rated junction boxes should be used where required

• Round cable should be used for the mains supply. The use of ﬂat cable may cause water

ingress to the ﬁtting

• Remove the outer frame and the LED gear tray from the luminaire housing (see Fig. 1)

Fig. 1

BL5xx INSTRUCTIONS_SPREADS.indd 5-8BL5xx INSTRUCTIONS_SPREADS.indd 5-8 20/01/2021 16:02:4120/01/2021 16:02:41

SURFACE MOUNTING

• Secure the ﬁtting to the surface with the wall plugs, screws, and rubber washers provided

• Drill two ﬁxing holes in the rear of the luminaire housing, mark the location of the ﬁxing

holes and drill ensuring not to infringe with any gas/water pipes or electrical cables

• Feed the mains cable through the grommet on either the rear or the side of the luminaire

housing (see Fig. 2) ensuring a good seal is made to retain the IP rating. The luminaire

can be ﬁtted horizontally or vertically, enabling cable entry on either side

BL5xx INSTRUCTIONS_SPREADS.indd 5-8BL5xx INSTRUCTIONS_SPREADS.indd 5-8 20/01/2021 16:02:4120/01/2021 16:02:41

Fig. 2

BL5xx INSTRUCTIONS_SPREADS.indd 5-8BL5xx INSTRUCTIONS_SPREADS.indd 5-8 20/01/2021 16:02:4120/01/2021 16:02:41

RECESSED MOUNTING

• For recessed mounting using the BLKITxx, cut a suitable hole in the mounting surface

ensuring not to infringe with any gas/water pipes or electrical cables

• Remove a knockout from the backbox (see Fig. 3)

• Feed the mains cable into the backbox (at this stage there is no requirement for

maintaining the IP rating)

• Fix the backbox securely into the wall ﬂush with the wall surface. Mortar around the

backbox if necessary and allow to set before continuing

• Drill two ﬁxing holes on the rear of the luminaire housing to align with the screw pillars in

the backbox

• Feed the mains cable through one of the cable entry grommets in the luminaire housing

(see Fig. 2) ensuring a good seal is made to retain the IP rating

• Secure the luminaire to the backbox using the M4 screws and rubber washers provided

(see Fig. 4)

Fig. 3

BL5xx INSTRUCTIONS_SPREADS.indd 1-4BL5xx INSTRUCTIONS_SPREADS.indd 1-4 20/01/2021 16:02:4120/01/2021 16:02:41

TERMINATION AND ACCESSORIES

• Connect the luminaire to the mains supply ensuring the correct polarity is observed:

L - Live (brown), N - Neutral (blue)

• Select the desired colour temperature by means of the sliding switch on the LED gear tray

(where applicable)

• Reﬁt the LED gear tray onto the luminaire housing ensuring the cable does not press

against the terminal block which may cause it to open, and secure it with all four screws

ensuring a tight seal is made

• Select a decorative accessory if required, and hold it in place while ﬁtting the appropriate

outer frame – the deep frame should be used if surface mounting; the shallow frame if

recess mounting

• Switch on and check for correct operation

Fig. 4

GENERAL

WARNING

This product contains a light source of energy efﬁciency class D to Regulation (EU)

No. 2019/2015. (Not applicable to BL5BLxx).

This product contains an LED light source and control gear which can be replaced by a

professional.

Clean the external surfaces with a damp cloth using a mild solution of detergent and warm

water only, do not use aggressive cleaning products or solvents which may damage the

product.

Do not use any source of high-pressure washers to maintain or clean this luminaire.

This product is non-dimmable.

This product should be dismantled for disposal when it reaches the end of its life. Please

see website for dismantling instructions.

This product should be recycled in the correct manner when it reaches the end of its life.

Check local authorities for where facilities exist.

This product must be disconnected from the circuit if subjected to any high voltage or

insulation resistance testing. Irreparable damage will occur if this instruction is not followed.

This product is not suitable for direct installation in the ground, nor in a retaining wall where

the ground may become saturated behind.

DCJUN21_V1

WARRANTY

This product has a warranty of 3 years (BL5xx) / 1 year (BLKITxx) from date of purchase.

Failure to install this product in accordance with the current edition of the IEE Wiring

Regulations (BS7671), improper use, or removal of the batch code will invalidate the

warranty. If this product should fail within its warranty period, it should be returned

to the place of purchase for a free of charge replacement. ML Accessories does not

accept responsibility for any installation costs associated with the replacement product.

Your statutory rights are not affected. ML Accessories reserve the right to alter product

speciﬁcation without prior notice.

ML Accessories Limited LU5 4LT

www.mlaccessories.co.uk

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Equipo de iluminación de ML Accessories

ML Accessories

ML Accessories BATSCWMST4 Manual de instrucciones

ML Accessories

ML Accessories LSPIKEA Manual de instrucciones

ML Accessories

ML Accessories FLP Series Manual de instrucciones

ML Accessories

ML Accessories TRLED14EM Manual de instrucciones

ML Accessories

ML Accessories SURF236EMHF Manual de instrucciones

ML Accessories

ML Accessories POTHB1 Manual de instrucciones

ML Accessories

ML Accessories OWALL1 Series Manual de instrucciones

ML Accessories

ML Accessories EMKIT2 Manual de instrucciones

ML Accessories

ML Accessories UNDKIT3WWW Manual de instrucciones

ML Accessories

ML Accessories EMPOWER3 Manual de instrucciones

ML Accessories

ML Accessories EMPDL Manual de instrucciones

ML Accessories

ML Accessories 12DCIP40 Manual de instrucciones

ML Accessories

ML Accessories EMLSUS Manual de instrucciones

ML Accessories

ML Accessories FLN10 Manual de instrucciones

ML Accessories

ML Accessories SURF236HF Manual de instrucciones

ML Accessories

ML Accessories SPIKE4BL Manual de instrucciones

ML Accessories

ML Accessories SPIKE5S Manual de instrucciones

ML Accessories

ML Accessories Knightsbridge EMTWINPC Manual de instrucciones

ML Accessories

ML Accessories NH0183BD Manual de instrucciones

ML Accessories

ML Accessories AC65118 Manual de instrucciones

ML Accessories

ML Accessories BATS2 Manual de instrucciones

ML Accessories

ML Accessories TPR14LEDS Manual de instrucciones

ML Accessories

ML Accessories TPOV60B Manual de instrucciones

ML Accessories

ML Accessories EA1 Series Manual de instrucciones

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario